Zanussi ZGG75524XA Support Question
Zanussi ZGG75524XA Support Question
Find answers below for this question about Zanussi ZGG75524XA.Need a Zanussi ZGG75524XA manual? We have 1 online manual for this item!
Question posted by Baker16nl on January 2nd, 2014
Hob Spark Plug Sparks
The spark plug continues to spark on all burners continuously
Current Answers
Related Zanussi ZGG75524XA Manual Pages
Product Manaul - Page 1
EN User manual Gas hob
ZGG75524 ZGG76524
IE PK GB
Product Manaul - Page 2
...all packaging away from children. There is cold. Flames can tip over the edges of the burners. Contents
Safety information 2 Installation 4 Product description 8 Operation 8 Helpful hints and tips 9
...physical injury. • Keep children away from the appliance before installation and use the hob without notice. They must not be used for other purposes, for example room heating....
Product Manaul - Page 3
... Do not put flammable products or items that obey the standards.
• Do not install the hob over a domestic appliances if the installation instructions do not allow it.
• Install the appliance .... There is installed. Hot cookware can find near sockets. It must be hit off the hob when you use of mechanical ventilation where present) is necessary when you operate the appliance with ...
Product Manaul - Page 4
...the appliance
• To prevent the risk of Ireland please refer to NSAI- The hob should be carried out by qualified personnel in compliance with standards and local regulations in ...electrical mains terminal is near to give anti-shock protection.
• A loose and incorrect mains plug and socket connections can be located in the Republic of physical injury or damage
- For appliances...
Product Manaul - Page 5
... assembly will not accept liability, should the above instructions or any strain on the hob. Also be with either rigid or semi-rigid pipe, i.e. Important!
Remove the ...burners: 1. tors and replace them with the ones which includes the G 1/2" threaded elbow, adjustment is important to the hob connecting pipe. Replace the rating plate (it is changeable or different from the edges of the hob...
Product Manaul - Page 6
...the National Inspection Council for Triple Crown burner). The isolation device must have a contact opening width of the appliance. The appliance is access to the mains plug after the installation. • Do not... be done by -pass screw
- your own safety the installation must comply with a 3 amp plug. The rating plate is on the bottom of minimum 3 mm.
• You must be connected...
Product Manaul - Page 7
... strands of electrical shock.
Building In
1 Green and Yellow 2 3 amp fuse
3 Brown 4 Cord clamp 5 Blue Should the plug need to be replaced for insertion Kitchen unit with door The panel installed below the hob must be done by a qualified electrician or competent person, according to remove and let an easy access in...
Product Manaul - Page 8
... up. Keep the control knob pushed for connections
Kitchen unit with vents to let a continuous supply of the flame
Always light the burner before you use open fire in case misuse of air. The electrical connection of the hob and the oven must be interrupted. If not, the gas supply will let thermocouple...
Product Manaul - Page 9
... Semi-rapid
Auxiliary
Diameters of cookware 180 - 260 mm 180 - 260 mm 120 - 220 mm
120 - 180 mm
80 - 160 mm
www.zanussi.com
9 The spark generator can ignite the burner without electrical device;
Important! in
correct positions.
1 2 3
4
1 2 3 4
Warning! Do not keep the control knob pushed for more than 15 seconds. Warning...
Product Manaul - Page 10
...earthenware pans or cast iron plates. The stainless steel can remove the pan supports to easily clean the hob.
• To clean the enamelled parts, cap and crown, wash them with warm soapy water ...electrical supply before you do not protrude over the front edge of the cooktop and that the arms of the burner.
• Be very careful when you position the pan supports correctly after cleaning. &#...
Product Manaul - Page 11
... pressure adjuster, if fitted. components well clean to check the conditions of the spark plug This feature is switched on.
• Control the fuse.
Periodic maintenance
Periodically ...What to a qualified electrician.
• Make sure that the injector is not blocked and the burner crown is clear of hob. 2.
www.zanussi.com
11
At the end rub the appliance dry with a damp cloth and...
Product Manaul - Page 12
...
MOD. These data are available at Service Force Centre and approved spare parts shops. Hob dimensions
Width: Length:
744 mm 510 mm
Hob recess dimensions
Width: Length:
560 mm 480 mm
Heat input
Triple Crown burner: Rapid burner: Semi-rapid burner: Auxiliary burner:
4.0 kW 3.0 kW 2.0 kW 1.0 kW
12
www.zanussi.com Labels supplied with the accessories...
Product Manaul - Page 13
...G 1/2"
Gas supply: Appliance class:
G20 (2H) 20 mbar 3
By-pass diameters
Burner
Auxiliary Semi-rapid
Rapid Triple Crown
Ø By-pass in 1/100 mm 28 32 42 56
Gas burners
BURNER
NORMAL POWER
kW
Auxiliary Semi-rapid
Rapid
Triple Crown
1.0 2.0 3.0 (natural gas) 2.8... = 858 g/h
G31 (3+) 37 mbar = 843 g/h
230 V ~ 50 Hz 3 core flexible cable with non rewirable plug fitted with a 3 amp car-
Similar Questions
One Hob Not Starting Up
Hi, one of the hob is not starting up when I turn on the knob. I can't hear a click sound, nor does ...
Hi, one of the hob is not starting up when I turn on the knob. I can't hear a click sound, nor does ...
(Posted by Anonymous-169792 2 years ago)
What Amp Will This Hob Need
Just purchased this hob and need to know what amp this will need so I can go and buy the materials
Just purchased this hob and need to know what amp this will need so I can go and buy the materials
(Posted by dmitchell1982 10 years ago)
How Do You Wire Up
What are the correct connection details for this hob including the jumpers to be fitted
What are the correct connection details for this hob including the jumpers to be fitted
(Posted by chosen1955 10 years ago)
Hotplate On Zanussi Zev6240fba
One of my hotplates on my hob is not working. I have had this hob since 12.10.12
One of my hotplates on my hob is not working. I have had this hob since 12.10.12
(Posted by kendapowell 10 years ago)
