Zenith SL-5798-WH-A Support Question
Zenith SL-5798-WH-A Support Question
Find answers below for this question about Zenith SL-5798-WH-A - Heath - 270-Degree Triple Head Halogen Motion Sensing Security Light.Need a Zenith SL-5798-WH-A manual? We have 1 online manual for this item!
Question posted by wrobinson on February 23rd, 2011
Light Bulb Replacement
How do I change the light bulb
Current Answers
Related Zenith SL-5798-WH-A Manual Pages
User Guide - Page 1
...sensor bottom to Dawn
LAMP MODE
Sensor Light Control
3 Wire Connectors
Put the LAMP MODE switch in the Normal, Soft, or Flash position. ON-TIME
TEST 1 5 20
3 Halogen Bulbs (Installed)
Light...the ON-TIME switch in wet locations. DualBrite® Triple Halogen Motion Sensing Light
Model 5798
Features
• Turns on lighting when motion is intended for use with the enclosed
gasket and ...
User Guide - Page 2
...effects) available when motion is sensed, the light turns on full ...Light flashes on half bright for replacement. Flip the light switch off when motion is mounted higher than 3 feet. (1 m). • Use only T4, 100W (max.) G8 bi-pin tungsten halogen
120 VAC lamps.
CAUTION: To Avoid Fire Or Burn Hazards: • Allow fixture to off for proper under eave installation, the sensor head...
User Guide - Page 3
... small flat-head screwdriver.Turn shade counterclockwise and remove. ❒ To remove bulb, pull straight ... hanger can be used to the light fixture ❒ Adjust lamp shades by... and wires are inside the junction box.
Secure the fixture to the junction box ground wire...the sensor.
Reinstall the shades in the center of fixture. ❒ To replace bulb, firmly push bulb pins...
User Guide - Page 4
...]
Sensing Angle Up to 270° Electrical Load Up to the TEST position.
Power Requirements. . 120 VAC, 60 Hz Operating Modes. . . . .
These heat sources could cause false triggering.
• Areas where pets or unwanted traffic may trigger the control.
• Nearby large, light-colored objects reflecting light may
increase false triggering. ❒ Secure the sensor head by...
User Guide - Page 5
....)
Technical Service
Please call * for this guide.You may be sensing small animals or automobile traffic (re-aim sensor). 2. If you experience a problem, follow this Product
598-1309-01
Turn Boost off too late in Manual Mode.
Heat being reflected from the sensor).
2. Light control is in Flash mode. (An initial start-up . (Flashing...
User Guide - Page 6
...products previously sold.
598-1309-01 REPAIR OR REPLACEMENT SHALL BE THE SOLE REMEDY OF THE CUSTOMER AND ... adjustment and calibration due to misuse, abuse or negligence, light bulbs, batteries, and other rights which gives you . THIS WARRANTY...HeathCo LLC reserves the right to discontinue products and to change specifications at any time without incurring any furnished component will ...
Similar Questions
How To Deactivate The Motion Sensor On The Heath/zenith Sl-5610-wh-b?
How to deactivate the motion sensor on the Heath/Zenith SL-5610-WH-B?
How to deactivate the motion sensor on the Heath/Zenith SL-5610-WH-B?
(Posted by emvilla 4 years ago)
Zenith Hologen Motion Sensor Light
How do I adjust it so that both lights come on with motion and not just one>
How do I adjust it so that both lights come on with motion and not just one>
(Posted by drwoggon 9 years ago)
Heath Zenith Motion Sensor Light Wont Turn Off
(Posted by Tiighchairu 10 years ago)