Makita XDT08Z Support and Manuals
Get Help and Manuals for this Makita item
View All Support Options Below
Free Makita XDT08Z manuals!
Problems with Makita XDT08Z?
Ask a Question
Free Makita XDT08Z manuals!
Problems with Makita XDT08Z?
Ask a Question
Popular Makita XDT08Z Manual Pages
Instruction Manual - Page 1
IMPORTANT: Lire avant usage. IMPORTANTE: Leer antes de usar. 1 INSTRUCTION MANUAL MANUEL D'INSTRUCTION MANUAL DE INSTRUCCIONES
Cordless Impact Driver Tournevis à Chocs sans Fil Atornillador de Impacto Inalámbrico
XDT08
012780
IMPORTANT: Read Before Using.
Instruction Manual - Page 2
...ranges and refrigerators. ENGLISH (Original instructions)
SPECIFICATIONS
Model
XDT08
Machine screw
4 mm - 8... mm (5/32" - 5/16")
Capacities
Standard bolt
5 mm - 14 mm (3/16" - 9/16")
High tensile bolt
5 mm - 12 mm (3/16" - 1/2")
No load speed (RPM)
0 - 2,500/min
Impacts per minute
0 - 3,200
Overall length
147 mm (5-7/8")
Battery...
Instruction Manual - Page 3
... parts.
16. Hold the tool firmly. 4. Keep proper footing and balance at the rate for lubricating and changing accessories. 30. Do not force the power tool. Disconnect the plug from the power source and/or the battery pack from those intended could give the operator an electric shock.
2.
avoid contact. GEB054-1
CORDLESS IMPACT DRIVER...
Instruction Manual - Page 4
... per minute
･ number of overheating, possible burns and even an explosion. 4.
Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery.
2. SAVE THESE INSTRUCTIONS. Always stop operating immediately. A battery short can explode in every six months if you notice less tool power.
2.
Tips...
Instruction Manual - Page 5
... you or someone around you can see that the tool is switched off and the
battery cartridge is removed before installing or
removing of the battery cartridge. • Hold the tool and the battery cartridge firmly when
installing or removing battery cartridge. If not, it locks in place with the groove in damage to the "OFF...
Instruction Manual - Page 6
... When not operating the tool, always set the reversing switch lever to secure the ...after the switch trigger is being pulled.
Installing or removing driver bit or socket bit
12 mm (15/...the sleeve will not return to the instructions above.
6 Reversing switch lever
A
B... to wipe the dirt off and the
battery cartridge is not inserted deep enough into the...serviced at a Makita service center.
Instruction Manual - Page 7
... it comes out, do not use . • When fastening M8 or smaller screw, choose a
proper impact force and carefully adjust pressure on either side and then secure it with a screw. Apply forward pressure to... test operation to the tool. 1. Hook
1. To install the hook, insert it into a groove in the figures, the screw or the point of the driver bit may differ depending upon the kind or size of ...
Instruction Manual - Page 8
...affected by Makita Authorized or Factory Service Centers, always using Makita replacement parts. Only use with a torque wrench. 1.
MAKITA LIMITED ONE YEAR WARRANTY Warranty Policy Every Makita tool is... the following troubleshooting related to use of any trouble develop during this manual. Operating the tool at low speed will repair (or at our option, replace) without charge...
Makita XDT08Z Reviews
We have not received any reviews for Makita yet.