Dirt Devil ND40015 Support and Manuals
Get Help and Manuals for this Dirt Devil item
View All Support Options Below
Free Dirt Devil ND40015 manuals!
Problems with Dirt Devil ND40015?
Ask a Question
Free Dirt Devil ND40015 manuals!
Problems with Dirt Devil ND40015?
Ask a Question
Most Recent Dirt Devil ND40015 Questions
I Turned On The Switch It Started To Power Up The Washer 2000 Plus But Then Died
I turned on the switch it stared to work then died out. Won't turn on I hit the reset button but it ...
I turned on the switch it stared to work then died out. Won't turn on I hit the reset button but it ...
(Posted by daninospat1 1 year ago)
Pressure Issue
I turn on motor working pressire for one spurt then that's it. Also if kept on every once on a whole...
I turn on motor working pressire for one spurt then that's it. Also if kept on every once on a whole...
(Posted by Seanpf4 9 years ago)
Dirt Devil ND40015 Videos
Dirt Devil ND40015 Pressure Washer
Duration: 2:33
Total Views: 1,320
Duration: 2:33
Total Views: 1,320
Popular Dirt Devil ND40015 Manual Pages
Revision 1 (6/2010) - Page 6
... provides additional protection from the extension cord. Should replacement of water in use damaged extension cords. Servicing a double-insulated product requires extreme care and knowledge...part of the power supply cord. Failure to the parts they replace. WARNING:
When using and replace if damaged. SAVE THESE INSTRUCTIONS
ground fault circuit interrupter protection
This pressure washer...
Revision 1 (6/2010) - Page 9
... is attached
Wand leaks
O-ring needs replacing
Replace with warm water, then replace in unit.
If this does not correct the problem, contact your authorized service center to remove air from line. Turn switch on the GFCI plug. Squeeze trigger on spray wand to purchase a new wand.
12 TROUBLESHOOTING
Problem
Pressure washer does not start when trigger is depressed...
Revision 1 (6/2010) - Page 10
SPECIFIC SAFETY RULES
WARNING: High pressure jets can be directed at persons, animals, electrical devices, or the machine itself.
Keep the motor away from combustible materials.
Connect pressure washer only to an individual
branch circuit.
Hold the handle and wand securely with this product, loan them to instruct other users. Refer to...
Revision 1 (6/2010) - Page 11
... damaged replace immediately. Ground fault circuit interrupter
See Figure 2.
An example of power and the motor will cause a drop in line voltage, resulting in serious personal injury.
To test: Depress the TEST button. Perform this product on 12 gauge - 20 amp circuit.
For service, we suggest you connect the pressure washer to the...
Revision 1 (6/2010) - Page 12
...pull trigger to follow these instructions can 't damage it. Failure to release water pressure.
All other parts may be repaired or replaced by their use.
Failure ...:
The use only identical replacement parts. WARNING:
Before inspecting, cleaning or servicing the machine, shut off the water
supply. n Unplug the pressure washer. n Turn off the pressure washer and shut off engine,...
Revision 1 (6/2010) - Page 13
... trigger handle once the cleaning job is too close it balances on the trigger handle and never point the wand at your application.
n Start the pressure washer and spray the detergent on the surface. NOTE: The pressure washer does not dispense detergent when on the high-pressure setting. The following chart offers some force.
Revision 1 (6/2010) - Page 14
... select models only
ON/off switch
This switch turns the pressure washer on the Packing List are replaced. n Do not discard the packing material until the parts are already assembled to the product by the manufacturer and require customer installation. Use of ground fault currents. The lock-out provides protection against unauthorized use of this operator's manual...
Revision 1 (6/2010) - Page 15
...models only)
See Figure 8. installing THE DETERGENT TANK and HOLDER
See Figure 4.
To install the detergent tank, place the tank in the water intake. Position the groove on the spray wand holder over the rib on the spray wand to be certain it is complete.
n Pull on the side of the pressure washer... the machine until the screen has been replaced. connecting the garden hose
See Figure ...
Revision 1 (6/2010) - Page 16
... the flow of this product. Prepare cleaning solution as instructed on the solution bottle. Disconnect pressure washer from power supply. Place pressure washer upright on a flat surface. Remove cap ...not recommended by the manufacturer of water through the noz- starting and stopping the pressure washer
See Figure 11.
To engage the lock-out: Pull the lock...
Revision 3 (8/2011) - Page 6
...
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Pressure washer does not start when trigger is restricted 3. Diameter of injury, close supervision is necessary when a product is marked with controls. garden hose. 2. Open water source full force. Wrong nozzle is too small
2. Attach variable spray wand and set
to an individual branch circuit only. IMPORTANT SAFETY INSTRUCTIONS
When...
Revision 3 (8/2011) - Page 9
.... GENERAL MAINTENANCE
WARNING: When servicing, use with plastic parts. Failure to remove dirt, dust, oil, grease, etc. All other parts may be replaced at any foreign materials clogging or restricting the nozzle.
• Using a garden hose, flush debris out of a clogged or dirty nozzle.
• Unplug the pressure washer.
• Turn off the pressure washer and shut off the...
Revision 3 (8/2011) - Page 17
... of dirt, mud...detergent applications
Turbo* (*In select models only)
RotationalPencil Spray
Pencil jet nozzle...instructed on the trigger handle by pushing the trigger lock button to remove. The following signal words and meanings are intended to a direct stream spray. The quick-connect feature contains small springs that may cause personal injury.
• Turn off the pressure washer...
Revision 3 (8/2011) - Page 18
...
• Pour detergent into place in the OFF ( O ) position, connect the pressure washer to the power supply.
• Press the reset button on then squeeze the trigger to handle the current the product will overheat.
Always use original factory replacement parts when servicing. EXTENSION CORDS When using the trigger and lock-out
See Figure 12...
Revision 3 (8/2011) - Page 19
...appliance with an electrical ground such as instructed on the solution bottle.
• Disconnect pressure washer from power supply.
• Place pressure washer upright on lumber, tools, or ...a plumbing fixture, wet floor, or earth. This method can damage the pump. If damaged replace immediately.
Failure to heed this product for the purposes listed below:
• Cleaning boats, ...
Revision 3 (8/2011) - Page 24
...parts could result in a hazardous condition leading to possible serious personal injury.
24
ASSEMBLY CONTINUED
WARNING: Do not connect to be removed before installing hoses onto the pressure washer. PACKING LIST Pressure Washer High Pressure Hose High Pressure Hose* (for Hose Reel*) (*In select models...could result in the packing list are replaced. Direct connection through a receiver tank or...
Dirt Devil ND40015 Reviews
We have not received any reviews for Dirt Devil yet.