Haier HHV4330DBWW Support and Manuals
Get Help and Manuals for this Haier item
View All Support Options Below
Free Haier HHV4330DBWW manuals!
Problems with Haier HHV4330DBWW?
Ask a Question
Free Haier HHV4330DBWW manuals!
Problems with Haier HHV4330DBWW?
Ask a Question
Popular Haier HHV4330DBWW Manual Pages
HHV3330 Manual - Page 2
... codes and standards, including fire-rated construction codes and standards.
4. Sufficient air is 1-877-337-3639.
2. Before servicing or cleaning unit, switch power off at high settings. When the service disconnecting...'s guideline and safety standards such as a tag, to the service panel.
3. Installation work and electrical wiring must be allowed to the outdoors.
8. Heat oils...
HHV3330 Manual - Page 3
... read specification label on product for using our Haier product. off the burner. Remember to your manual. BE CAREFUL TO PREVENT BURNS. They are on "Kitchen Fire Safety Tips" published by NFPA.
Date of fire, use manual will guide you for further information and requirements. Observe all governing codes and ordinances.
1. For general ventilation use this appliance...
HHV3330 Manual - Page 4
... Electrical Connections 10 Installing Hood 11 Operating the Range Hood 12-14 Use and Care 15 Troubleshooting 16 Warranty Information 17
Accessories
Range Hood Accessories Provided:
1 Range Hood 1 7" Round Duct Plate 1 Damper/Duct Connector 4 Damper Screws 4 Washers 4 Range Hood Wood Screws 2 Wire Connectors 2 HEPA or Charcoal Filters* 1 User Manual *4000 series models come with HEPA...
HHV3330 Manual - Page 5
... wall. Run house wiring between the hood location and a roof cap or wall cap. For vertical or horizontal discharge, run ductwork between service panel and hood location. 4 English
Installation Preparation
To install this range hood, you will need the following tools and materials: Note: This procedure will discharge vertically (3¼" x 10" or 7" Round...
HHV3330 Manual - Page 6
with mounting screws. 7" Round Duct Plate
2. Remove tape holding filters in place with 2 screws) 5 Bottom Cover (Held in place. English
Preparing Hood
1. Remove 7" Round Duct Plate from hood. Set duct plate aside - Set filters aside.
Pull down on filter tabs and lift filters out. Set cover and mounting screws aside. Remove bottom cover from top of hood. Filters
3.
HHV3330 Manual - Page 7
Set connector aside
with mounting screws and parts bag. Then snip or break the attachment points.
6. Remove either top or back wiring knockout and install approved electrical conduit according to national electrical code.
Conduit
6 Damper/Duct Connector
5. Remove the appropriate electrical knockout by inserting a screwdriver.
English 4. Remove Damper/Duct Connector from inside the hood....
HHV3330 Manual - Page 9
... Plate in place with Screws(2). TIES
SCREWS(2)
SCREW(1)
METAL STRIP
PLATE
HOUSE WIRING
8
(120 VAC)
English
11. Re-install air chute, re-connect wire harness, and replace light panel. NOTE: Be careful not to trap wires between support fin and light panel.
12. Remove appropriate Duct Knockout(s) from top or back of hood.
HHV3330 Manual - Page 11
... hood white wire, and house grounder to
protect the cooktop, if necessary. Use a piece of electric shock, make sure power is switched off at the service panel.
METAL STRIP
PLATE
1. Connect House Wiring (120 VAC) to prevent power from being switched on accidentally. TIES
English
SCREW(1)
Preparing Electrical Connections SCREWS(2)
WARNING...
HHV3330 Manual - Page 12
...(4) Mounting Screws (from parts bag). KEYHOLE (4)
MKOEUYNHTOINLGE SCR(4E)W
(4)
2. MOUNTING SCREW
KEYHOLE
3. Connect ductwork to (4()m4) ake joiDnUtsCTsecure and air tight.
If you have a 3000 series model, install (2) PAR 20, 50W halogen lights. HALOGEN BULB -or-
Refer to bulb packaging for further information.
! 5. Replace filters*, turn on power at service panel, and test range...
HHV3330 Manual - Page 13
... Use "-" or "+" buttons to set lights to reset
Your new Haier range hood comes equipped with 3 ...different fan speeds: "low", "med", or "high". Press the "on/off" button a second time will turn off time has been selected. English
Operating the Range Hood
4000 series models (For 3000 series models, see next section.)
Hold 3 secs to reset
Light Settings...
HHV3330 Manual - Page 14
... is equipped with a Heat Sensor that automatically turns off the fan if a certain temperature is on, press and hold "filter" for 3 seconds to the previous setting before the heat sensor was activated.
HHV3330 Manual - Page 15
...Signal Reset
If the filter change signal is on, press "filter" to reset
Your new Haier range hood comes equipped with 3 different fan speeds: "low", "med", or "high....
14
To turn off " position. English
lter
3000 series models (For 4000 series models, see previous section.)
o low high
o low med high
Light Settings
There are 2 light settings available, "low" and "high" To turn on the fan...
HHV3330 Manual - Page 16
... range hood exterior with your specific model. Rinse thoroughly and repeat if necessary. See prior section for painted surfaces. All parts may be obtained from service centers authorized by Haier, or may be cleaned easily, thus the filter may need to replace the filter before servicing.
HEPA/Charcoal Filter This filter should be replaced.
Disconnect range hood from...
HHV3330 Manual - Page 17
... technician must be due to function. If you see instructions above the range hood. This could be dimmable for ...troubleshooting when your unit is blowing through the back wall. If air is using an LED bulb, it must install metal ductwork from the range hood through either a defective fan switch or a burned-out fan motor. Please call a qualified service professional. Try replacing...
HHV3330 Manual - Page 18
... PUERTO RICO.
Some states do not allow the exclusion of a replacement part, beyond the initial 12-month period. Haier will be able to state.
17 This warranty does not cover incidental or consequential damages. This warranty gives you specific legal rights, and you get service?
1. Contact your original sales receipt as proof of the date...
Haier HHV4330DBWW Reviews
We have not received any reviews for Haier yet.