Haier HH-OT53P Support and Manuals
Get Help and Manuals for this Haier item
View All Support Options Below
Free Haier HH-OT53P manuals!
Problems with Haier HH-OT53P?
Ask a Question
Free Haier HH-OT53P manuals!
Problems with Haier HH-OT53P?
Ask a Question
Popular Haier HH-OT53P Manual Pages
HH-OT53P Manual - Page 1
HH-OT53P Cooker Hood Instruction Manual
1
HH-OT53P Manual - Page 2
Content
1 Safety instructions 2 Technical Specifications 3 Installation 4 Start using your cooker hood 5 Troubleshooting 6 Maintenance and cleaning 7 Environment protection
2
HH-OT53P Manual - Page 3
.... ●CAUTION: Accessible parts may result in electrical hazards.
●Warning: Before obtaining access to
terminals, all measurements followed.
●All installation work must be installed in a safe place for future reference.
Always to do:
● Important! The manual should be disconnected.
3 SAFETY INSTRUCTIONS This manual explains the proper installation and use .
●...
HH-OT53P Manual - Page 4
...instructions.
●Regulations concerning the discharge
of air have been given supervision or instruction concerning use only.
●If the supply cord is damaged, it must
be replaced by the manufacturer, its
accessible parts...When in extraction mode, air in the instruction manual.
●Cleaning and user maintenance shall
...its service agent or similarly qualified persons in order to ...
HH-OT53P Manual - Page 5
then cover flame e.g.
HH-OT53P
Width
900mm
Depth
500mm
Height
450-830mm
Supply voltage
220 - 240 V, 50 Hz
Control Suction power
Push button 700 m3/h
Motor power
190 W
Lamp power
2×2W LED
Total power
194W
Net weight
15kgs
Gross weight
17kgs
5 TECHNICAL SPECIFICATIONS
Model No.
with a lid or a
fire blanket.
HH-OT53P Manual - Page 6
... the holes 5 on the body; • repeat all the operations for the 2nd half-part
INSTALLATION
If you have an assembled V-flap 1, you should mount the halfparts to its body.The images... interior diameter of 150mm)
1. INSTALLATION (VENT OUTSIDE) MOUNTING OF THE V-FLAP
If the cooker hood does not have an outlet to different models and configurations. Before installation, turn the unit off and ...
HH-OT53P Manual - Page 7
2. Put the cooker hood on a suitable place once the installation height is the place of 65~75cm above the cooking surface for best effect.
3....of chimney. Afterwards,fix the outside chimney bracket on the cooker hood. See Pic 3 &Pic4.
5. Install the hook on the hook. Install the expansion pipe and chimney on the outside chimney, and be sure that the inside chimney bracket is fixed...
HH-OT53P Manual - Page 8
... system which is level to observe these basic instructions will reduce the performance and increase noise levels of the cooker hood. • Any installation work must be strictly followed to obtain optimal air...size or restrict the expansion pipe. • When using the expansion pipe always install the pipe pulled taut to minimize pressure loss. • Failure to avoid grease collection at on...
HH-OT53P Manual - Page 9
Reset/Replace fuses.
9
TROUBLESHOOTING
Fault
Possible Cause
Light on, but motor does not work
Light does not
Fan switch turned off . WARNING:
For safety reason, please use only the same
size of fixing or mounting screws which are recommended in this instruction manual.
Failure to install the screws or fixing device in
accordance with...
HH-OT53P Manual - Page 10
...the unit. Lights not working Broken or faulty bulbs
Replace blubs as per this appliance must be used. Please contact the service centre if in any doubt before undertaking any unsightly ...the cleaning instructions to power outlet. Ensure that wiping is done along with sealant. Avoid leaving alkaline or acid substances (lemon juice, vinegar etc.) on . NOTE:
Any electrical repairs to the ...
HH-OT53P Manual - Page 11
... potentially remove any printing of artwork on both sides of the motor anti-clockwise. Replace the
carbon filters with a soft brush. The inlay control panel can be cleaned ...Leave to dry naturally out of the hood. - Before installing or replacing the carbon filters, disconnect the mains power to the wall socket.
11 The installation procedure of the filter. - Connect the power supply to...
HH-OT53P Manual - Page 12
... danger.
When activated carbon filter attached, the suction power will be replaced by the manufacturer, its service agent or similarly qualified persons.
Always switch off and
unplugged. ... of LED light to reinstall the light. • ILCOS D code for this can reduce the life of the bulb. BULB REPLACEMENT
Important : The bulb must be lowered. Dimensions:
12...
HH-OT53P Manual - Page 13
energy use) of the cooking process).
(1) Install the cooker hood in accordance with the symbol on the environment, ...contact your local or regional authorities. NOTE:
The following shows how to reduce total environmental impact (e.g. It will then be supported by a system of selective collection in a proper place where there is marked with Directive 2012/19/EU. ENVIRONMENTAL PROTECTION:...
HH-OT53P Manual - Page 14
Check with household waste. The appliance could not be disposed of life, the appliance should not be dismantled by user. INFORMATION FOR DISMANTLING
Do not dismantle the appliance in a way which is not shown in the user manual. At the end of with your Local Authority or retainer for recycling advice.
14
Haier HH-OT53P Reviews
We have not received any reviews for Haier yet.