Harbor Freight Tools 63025 - 900 Peak/700 Running Watts Support and Manuals
Get Help and Manuals for this Harbor Freight Tools item
View All Support Options Below
Free Harbor Freight Tools 63025 manuals!
Problems with Harbor Freight Tools 63025?
Ask a Question
Free Harbor Freight Tools 63025 manuals!
Problems with Harbor Freight Tools 63025?
Ask a Question
Popular Harbor Freight Tools 63025 Manual Pages
User Manual - Page 1
... & Safety Instructions
Save This Manual Keep this manual for future reference.
you cannot see or smell. NEVER use inside
Only use OUTSIDE
a home or garage,
ENVEEVNEIRF duosoersinansdide wa ihndoomwes oarregoapreang. Visit our website at: http://www.harborfreight.com Email our technical support at:
[email protected] Email our Engine support at: predator@harborfreight...
User Manual - Page 2
...0012"
The emissions control system for this manual.
ITEM 63025 Table of this Engine is warranted for mixing with gasoline) 50:1 gasoline-to the last pages of Contents
Specifications 2 Safety 3 Setup 7 Operationr 8
Maintenances 11 Troubleshooting 14 Parts Lists and Diagrams 16 Warranties 18
Specifications
Generator
Displacement Engine Type Cooling System
Output Receptacles...
User Manual - Page 3
... cover all instructions. Safety
Setup
WARNING SYMBOLS AND DEFINITIONS This is used to alert you to potential personal injury hazards.
Symbol Definitions
Symbol
Property or Statement
RPM Revolutions Per Minute
HP Horsepower
WARNING marking concerning Risk of Eye Injury. Read the manual before set-up and/or use. Wear hearing protection.
IMPORTANT SAFETY INSTRUCTIONS
WARNING...
User Manual - Page 4
... as a power source. Read and adhere to the instruction manual of carbon monoxide from utility power, and must only be powered to be installed by a qualified electrician.
Connections for electrical shock. The connection must isolate the generator power from building up in the Specifications chart of this manual.
9. If you cannot see or smell. The...
User Manual - Page 5
...Prevent body contact with these instructions and in the manner intended for your model. The generator can be cleaned...parts, breakage of moving parts.
30. Dispose of transport and lifting devices with any local, state, or federal codes and regulations. If damaged, have the equipment serviced..., please call 1-888-866-5797. Safety
Setup
Operating Precautions (continued)
12. Make sure ...
User Manual - Page 6
...corroded.
SAVE THESE INSTRUCTIONS. Safety
Service Precautions
1. Before service, maintenance, or ...repair person using only identical replacement parts. Wear ANSI-approved safety goggles, heavy‑duty work gloves, and dust mask/respirator during service...replacement.
7.
Max Fuel DO NOT OVERFILL! 4. To prevent FIRE, do not fill fuel above the bottom of children. 9. Setup...
User Manual - Page 7
...888-866-5797. The Generator must be properly grounded in accordance with proper spark arrestor installed. Grounding
1. To ground the Generator, connect a #10 AWG grounding wire (not ...prevention requirements. Safety
Setup
Set Up
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all relevant electrical codes and standards before set up or use of...
User Manual - Page 8
...for it .
2. If any problems are found, do not start ...the fuel level.
Safety
Setup
Operation
Read the ENTIRE ...parts before each use gasoline containing more than 10% ethanol (E10).
Inspect the generator and engine.
Then replace the Strainer. Note: Do not use . Then replace the Fuel Cap.
7. Add fuel stabilizer to about 1 inch under subheadings therein before set...
User Manual - Page 10
... Generator. Wattage Estimates
Wattages listed below are estimates for complete storage instructions. Check nameplate wattages on page 13 for that type of fuel... amperage rating.
• Refer to appliance/tool owner's manuals to Generator. Figure C: Unplug Load
This Unit Can Power...Load And Circuit Breaker:
1.
Safety
Setup
Break-in the Maintenance section. To stop the engine in an ...
User Manual - Page 11
...Service more than 10% ethanol (E10). of use gasoline that has been stored in this manual. TO PREVENT SERIOUS INJURY FROM FIRE: Fill the fuel tank in this manual, will differ depending on factors such as a general guide... service instructions in a well-ventilated area away from
combustion chamber Replace fuel line if necessary
Before Each Use
Monthly or every 20 hr.
Safety
Setup
...
User Manual - Page 14
...diagnosing or servicing the ...problem, see #3.
3. Reinstall spark plug and set Choke to prime.
6. Clean spark plug.
3. If that does not remedy problem, replace head gasket.
4. Have qualified technician adjust/ repair valves and tappets. Carburetor needle stuck. Problem after long storage periods.
2. Replace...Replace spark plug cap.
5. Tighten head. Safety
Setup
Troubleshooting
Problem...
User Manual - Page 15
....
1.
Old or low quality gasoline/oil mixture. Attached device 1. Problem with fresh 87+ octane stabilizer-treated unleaded gasoline/oil mixture. Do not use a more powerful generator. Have qualified technician diagnose and service engine.
1. Have product repaired.
1. Have device repaired by a qualified technician, or replace device.
2. Spark plug cap loose. 2. Defective spark plug cap...
User Manual - Page 16
...-5797.
ITEM 63025 Note: Some parts are listed and shown for illustration purposes only, and are not available individually as replacement parts. Safety
Setup
Parts Lists and Diagrams
Parts List
Part
Description
1 Left Crankcase
2 Right ... Gasket
48 Carburetor
49 Carbureor Gasket (B)
50 Carbureor Gasket (A)
51 Supporting Plate
52 Compression Spring
53 Cross Round Head Bolt (M6*40)...
User Manual - Page 18
...Manual. The warranty repairs or replacement should however be returned to exceed 30 days. This warranty does not apply to damage due directly or indirectly, to misuse, abuse, negligence or accidents, repairs or alterations outside our facilities, criminal activity, improper installation... specific legal rights and you have other emissions-related assemblies.
If any emission-related part ...
User Manual - Page 19
... support at a retail store or by HFT. If the part fails...Setup
GENERAL EMISSIONS WARRANTY COVERAGE
a) The warranty period begins on or modified part...replacement part may not be used in fact defective, provided that is liable for regular inspection in the written instructions is two years. Thermal reactor. b.
Notwithstanding the provisions herein, warranty services or repairs...
Harbor Freight Tools 63025 Reviews
We have not received any reviews for Harbor Freight Tools yet.