Hikvision DS-2CD2532F-IS Support and Manuals
Get Help and Manuals for this Hikvision item
View All Support Options Below
Free Hikvision DS-2CD2532F-IS manuals!
Problems with Hikvision DS-2CD2532F-IS?
Ask a Question
Free Hikvision DS-2CD2532F-IS manuals!
Problems with Hikvision DS-2CD2532F-IS?
Ask a Question
Hikvision DS-2CD2532F-IS Videos
Hikvision DS-2CD2532F installation and Setup
Duration: 14:27
Total Views: 64,687
Duration: 14:27
Total Views: 64,687
Hikvision Aliexpress Order Unboxing Review: DS-2CD2532F-IWS: Part 1
Duration: 5:54
Total Views: 4,015
Duration: 5:54
Total Views: 4,015
DS-2CD2532F-ISW 2.8 HIKVISION
Duration: :22
Total Views: 846
Duration: :22
Total Views: 846
Hikvision DS-2CD2532F-IWS
Duration: :24
Total Views: 3,277
Duration: :24
Total Views: 3,277
Popular Hikvision DS-2CD2532F-IS Manual Pages
User Manual - Page 5
... problems caused by a qualified service person and should be caused if any of these precautions to the ceiling.
If the product does not work properly, please contact your dealer or the nearest service center. User Manual of these warnings are
neglected.
Warnings Follow these safeguards to avoid danger or property loss. Safety Instruction
These instructions...
User Manual - Page 12
... chapter for it before you need to activate the camera
via SADP software.
Notes:
The default IP address of the camera is 192.168.1.64.
For the camera enables the DHCP by setting a strong password for Activation via Web Browser
Steps:
1. Figure 2-1 Connecting Directly
Figure 2-2 Connecting via a Switch or a Router
2.1.2 Activating...
User Manual - Page 15
Follow the steps to the prompts. Input the password and click the Save button to activate your IP address
modification.
Activation via Client Software... panel of devices. Get the client software from the supplied disk or the official website, and install the software according to activate the camera. User Manual of Network Camera
Figure 2-5 Modify the IP Address 6. Steps: 1.
User Manual - Page 18
... camera via a router or connect it to the WAN directly. Connecting the network camera via a router Steps: 1. User Manual of Enable DHCP. 9. Input the password to activate your IP address modification.
2.2 Setting the Network Camera over the WAN
Purpose: This section explains how to connect the network camera to the WAN with...
User Manual - Page 20
... camera supports the PPPoE auto dial-up after rebooting the camera. Figure 2-12 Accessing the Camera with port mapping. You need to configure the PPPoE parameters of the network camera. 3. User Manual of the router. 7. Refer to solve the problem. Normal Domain Name Resolution
20 In the router, set the PPPoE user name, password...
User Manual - Page 31
...product. Proper configuration of all passwords and other security settings is never easy. User Manual of Network Camera
numbers and special characters...wireless connection. Steps:
Figure 4-10 Wi-Fi Settings - WPS (Wi-Fi Protected Setup) refers to enable WPS.
31 Note: If...the installer and/or end-user.
4.2 Easy Wi-Fi Connection with WPS function
Purpose: The setting of the network)
...
User Manual - Page 33
... example, enter 48167581 to the router.
4.3 IP Property Settings for the PIN code is generated from the router side, you should enter the PIN code you can generate the PIN code on the camera side. Steps:
33 Or You can change the default IP. Click Connect. Enter the code to the router, in the Router PIN...
User Manual - Page 55
... name, password, APN, MTU and verification protocol. Auto and Manual are configured.
For your system against security risks,
55 Check the checkbox to enter the Wireless Dial configuration interface. 2.
The name of the device when detected online can also leave these parameters blank, and the device will adopt the default settings for dialing...
User Manual - Page 59
....263xmail.com). SMTP Port: The SMTP port. And the SSL SMTP port is 465. User Manual of the email sender. Configure the following settings:
Sender: The name of Network Camera
set the IPv4 Address, IPv4 Subnet Mask, IPv4 Default Gateway and the Preferred DNS Server. Sender's Address: The email address of the sender. Enter...
User Manual - Page 62
... field, you can use the Device Name, Device Number or Device IP for all passwords and other security settings is the responsibility of the installer and/or end-user. Upload type: To enable uploading the captured picture to the camera model and it requires
62 For detailed information, please refer to the Section 7.3.
6.3.13...
User Manual - Page 63
...Manual of Network Camera
for the support of Enable to enable the EZVIZ Cloud P2P, and you are able to manage the device via the web browser. Check the checkbox of the camera.
Configuration > Advanced Configuration > Network > HTTPS 2.
Figure 6-25 Platform Access
6.3.14 HTTPS Settings
Purpose: HTTPS provides authentication of https. E.g.: If you set... steps to set the port number...
User Manual - Page 77
... different illumination. Please refer to the actual camera model for day and night to day/night auto switch session. 3. Click Common tab to configure the common parameters applicable to set the separate camera parameters for details. User Manual of Network Camera
Some of the camera supports CVBS, SDI, or HDMI output. Day/Night Scheduled...
User Manual - Page 137
...Manual of Network Camera
Chapter 8 Counting
Purpose: Counting function is used to calculate the number of non-iDS camera does not require for calibration settings...supported by some certain non-iDS camera models. Compared with the people counting function supported by the iDS camera, the
counting function of object entered or exited a certain configured area and is recommended to install...
User Manual - Page 159
... LED, you can go to the hardware service, and select to enable or disable the corresponding service according to enter the service settings interface. User Manual of Network Camera
12.10 Service Settings
Go to Configuration> Advanced Configuration> System > Service to the actual demands.
159 Service settings refer to the hardware service the camera supports, and it varies according to the...
Data Sheet - Page 1
...720)
PC-120 120 mm Pendant Cap
Image Settings
ROI Network
Network Storage
Alarm Trigger
Protocols
System...network disconnect, IP address conflict, storage exception, storage error TCP/IP, ICMP, HTTP, HTTPS, FTP, DHCP,... Models
(Includes gang plate adapter)
DS-2CD2512F-I, DS-2CD2512F-IS DS-2CD2532F-I, DS-2CD2532F-IS
* -S: Audio/Alarm IO
www.hikvision.com DS-2CD2512F-I (1.3 MP)/DS-2CD2532F-I...
Hikvision DS-2CD2532F-IS Reviews
We have not received any reviews for Hikvision yet.