Maytag UXT4230ADS Support and Manuals
Get Help and Manuals for this Maytag item
This item is in your list!
View All Support Options Below
Free Maytag UXT4230ADS manuals!
Problems with Maytag UXT4230ADS?
Ask a Question
Free Maytag UXT4230ADS manuals!
Problems with Maytag UXT4230ADS?
Ask a Question
Popular Maytag UXT4230ADS Manual Pages
Use & Care Guide - Page 1
... alert symbol.
FOR RESIDENTIAL USE ONLY.
30" (76.2 CM) AND 36" (91.4 CM) RANGE HOOD
Installation Instructions and Use & Care Guide
For questions about features, operation/performance, parts, accessories or service, call: 1-800-253-1301 or visit our website at www.whirlpool.com
In Canada, call 1-800-807-6777 or visit our website at www.whirlpool.ca
HOTTE...
Use & Care Guide - Page 2
...low or medium settings.
■ Always turn off at high settings. do not ...code authorities.
■ When cutting or drilling into crawl spaces, or garages. aBased on accidentally. READ AND SAVE THESE INSTRUCTIONS
TABLE OF CONTENTS
RANGE HOOD SAFETY 1 INSTALLATION REQUIREMENTS 3 INSTALLATION INSTRUCTIONS 6 RANGE HOOD USE 10 RANGE HOOD CARE 10 WIRING DIAGRAM 11 ASSISTANCE OR SERVICE...
Use & Care Guide - Page 3
... that all governing codes and ordinances. ■ It is located inside the range hood on ordering charcoal filters. See the "Assistance or Service" section for Manufactured Home Installation 1982 (Manufactured Home Sites, Communities and Setups) ANSI A225.1/NFPA 501A, or latest edition, or with wall or roof cap
Optional accessories
Charcoal filter kit Part Number W10355450*
Power...
Use & Care Guide - Page 5
... appliance as specified on the rear wall of the range hood.
■ Wire sizes must conform with the range hood. ■ Use caulking to the pigtail leads.
2.
Connect a section of the National Electrical Code, ANSI/NFPA 70 (latest edition), or CSA Standards C22. 1-94, Canadian Electrical Code, Part 1 and C22.2 No. 0-M91 (latest edition) and all joints...
Use & Care Guide - Page 6
...; Set the range hood on its back on your model, determine which venting method
to use: roof, wall or non-vented (recirculating).
■ It is recommended that a qualified contractor determine the anchoring method.
4. NOTE: For installations to a surface other than drywall, it is proper clearance within the ceiling or wall for the vent system.
1. INSTALLATION INSTRUCTIONS
NOTES...
Use & Care Guide - Page 9
...11. See "Replacing the Incandescent Light Bulb" in the "Range Hood Care" section. Direct Wire Installations ■ Use a UL Listed/CSA Approved wire connector and connect
the 2 white wires (A) together. ■ Use a UL Listed/CSA Approved wire connector and connect
the 2 black wires (B) together.
Power Cord Kit Installations For optional power cord kit installations, follow the instructions...
Use & Care Guide - Page 10
... filter to order.
■ For stainless steel models, rub in a dishwasher or hot detergent solution.
Turn the light switch to the following instructions. Exterior Surfaces: IMPORTANT: Do not use Stainless Steel Cleaner and Polish, Part Number 31462A (not included): See the "Assistance or Service" section to the range hood.
2.
To reinstall the filter, place the back...
Installation Guide - Page 1
... you what can happen if the instructions are very important. All safety messages will follow instructions. 30" (76.2 CM) AND 36" (91.4 CM) RANGE HOOD
Installation Instructions and Use & Care Guide
For questions about features, operation/performance, parts, accessories or service, call: 1-800-253-1301 or visit our website at www.whirlpool.com
In Canada, call 1-800-807-6777 or...
Installation Guide - Page 2
... fight the fire with all applicable codes and standards, including fire-rated construction.
■ Do not operate any solid-state speed control device. READ AND SAVE THESE INSTRUCTIONS
TABLE OF CONTENTS
RANGE HOOD SAFETY 1 INSTALLATION REQUIREMENTS 3 INSTALLATION INSTRUCTIONS 6 RANGE HOOD USE 10 RANGE HOOD CARE 10 WIRING DIAGRAM 11 ASSISTANCE OR SERVICE 12 WARRANTY 12
TABLE DES MATI...
Installation Guide - Page 3
...174;TORX and T10 are factory set for vented installations. Consult the cooktop/range manufacturer installation instructions before starting installation. INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before making any tools listed here. Read and follow the instructions provided with any cutouts.
■ This range hood is recommended for Manufactured Home...
Installation Guide - Page 5
... of the range hood.
■ Wire sizes must conform to the requirements of the National Electrical Code, ANSI/NFPA 70 (latest edition), or CSA Standards C22. 1-94, Canadian Electrical Code, Part 1 and ...than 1 elbow is used. ■ Do not install 2 elbows together. ■ Use clamps or duct tape to seal all local codes and ordinances.
5 The model/serial plate is required.
■ If the house...
Installation Guide - Page 6
Replace all parts and panels before servicing.
Install Brackets
WARNING
Electrical Shock Hazard Disconnect power before operating. NOTE: For installations to use:... Set the range hood on its back on your model, determine which venting method
to a surface other than drywall, it is recommended that the vent system be installed before the range hood is installed. INSTALLATION INSTRUCTIONS
...
Installation Guide - Page 8
... marked previously at the electrical strain relief. Prepare Range Hood Vents and Mounting Tabs
x2 F
■ Using (2) short Phillips head screws, install the 3¹⁄₄" x 10" (8.3 x 25.4 cm) rectangular damper over the vent knockouts removed in Step 8. NOTE: An optional 7" (17.8 cm) round damper (A), Part Number W10355451, and a 7" (17.8 cm) round vent mounting...
Installation Guide - Page 9
...; Connect the ventwork to green ground screw in the "Range Hood Care" section.
■ If removed previously, replace the filter.
See "Replacing the Incandescent Light Bulb" in terminal box.
Attach the screws to the National Electric Code or CSA standards and local codes and ordinances.
Complete the Installation
■ Install a 120V, 75W maximum, incandescent light bulb with the...
Installation Guide - Page 10
... Clean the Filter: 1. A
■ Glass cleaner to remove fingerprints.
■ For stainless steel models, use Stainless Steel Cleaner and Polish, Part Number 31462A (not included): See the "Assistance or Service" section to 6 months with normal use. Dispose of the range hood. Push the filter into the channel at the rear of the grain to clear...
Maytag UXT4230ADS Reviews
Do you have an experience with the Maytag UXT4230ADS that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Maytag yet.
Earn 750 points for your review!