Sony MKS-6570 Support and Manuals
Get Help and Manuals for this Sony item
View All Support Options Below
Free Sony MKS-6570 manuals!
Problems with Sony MKS-6570?
Ask a Question
Free Sony MKS-6570 manuals!
Problems with Sony MKS-6570?
Ask a Question
Popular Sony MKS-6570 Manual Pages
Operating Instructions - Page 1
... MVS-6530 System MVS-3000A System MVS-3000 System (SY) 4-448-461-13 (1)
Sony Corporation
Printed in Japan 2019.04 32 © 2012
MVS-6520 ICP-6520 ICP-6511
MVS-6530 ICP-6530 MKS-6550
MVS-3000A ICP-3000 MKS-6570
Startup Guide [English]
Software Version 1.10 and Later 1st Edition (Revised 2)
MVS-3000 ICP...
Operating Instructions - Page 7
...MKS-8080/8082 AUX bus remote panels via a T bridge. m MVS (multi format video switcher) connector (RJ-45 compliant)
Connect to 4 connectors (D-sub 9-pin, RS422A)
Connect devices supporting Sony 9-pin VTR, VDCP (Video Disk Communications Protocol), or P-Bus (Peripheral II Protocol) protocols.
For details about output signals and settings... connectors to the User's Guide. n UTIL (SW) ...
Operating Instructions - Page 12
... Switcher Processor
(with MKS-6550 Format Converter Board and MKS6570 Digital Multi Effect Board installed) • ICP-6520 Control Panel • ICP-6511 Menu Panel • Cameras for recording (4) • VTRs for playback (2)
• Character generator (1) • Video monitors (2) • Monitor for multi viewer (1)
Notes
The MVS-3000 does not support the MKS-6570 DME board.
Operating Instructions - Page 17
... saver and panel sleep mode If no operation is not lit before turning off the power. Check to the User's Guide. Indicator on the control panel also dims.
For details about settings, refer to make sure the indicator is performed for a given time, the menu display screen saver starts.
MVS-6520/3000A...
Operating Instructions - Page 19
... the Engineering Setup >System >Network Config menu (7311).
2 Set the group ID.
In this example, check that the group ID is set to the MVS system LAN are detected and corresponding settings are registered.
1 Display the menu. b Check the message, then press [Yes]. If the group ID is not set to the User's Guide.
3 Detect the...
Operating Instructions - Page 21
... HD system BB: Black burst or sync
Notes
This setting is installed).
Format menu
a Press [Signal Format]. Memo
If [BB] is selected, you can set in the format converter (when MKS-6550 Format Converter Board is available for the desired format to the User's Guide.
21 Setting Signal Formats b Press the button for HD systems only...
Operating Instructions - Page 23
... Cross-Point Buttons b In the group, press [Video], turning it on . d In the group, press [Set]. Video signal
Key signal
1 Display the menu. Memo
When assigning the same signal to the video and key,... on both [Video] and [Key] in the group.
The video is assigned. a Open the Engineering Setup >Panel >Xpt Assign menu (7322). The Main, V/K Pair Assign menu (7322.5) appears.
Notes
Up ...
Operating Instructions - Page 24
... devices on the OUTPUTS of the switcher processor. Setting Monitor Outputs
This section describes the procedure for setting up monitors for checking final program output video (program output) and for setting the M/E-1 reentry input. a Open the Engineering Setup >Switcher >Output menu (7333).
Out#
Src#
V/K
Preparation
Video Key Set
Main, V/K Pair Assign menu
a In the [V/K] column...
Operating Instructions - Page 25
... split into sixteen
Subscreen signals
There are two multi viewer systems, Multi Viewer 1 and 2, to view multiple video signals simultaneously.
a Open the Engineering Setup >Switcher >Output menu (7333).
Setting Multi Viewer Output
To use multi viewer, you can be split to which you must assign the multi viewer output to the OUTPUTS...
Operating Instructions - Page 26
... Multi Viewer
1 Display the menu.
In this example, select "9". b In the group, select the number of the screen. Assigning Signals to the monitor.
d Press [Set]. a Open the Engineering Setup >Switcher >Output menu (7333).
c Press [Source/Output Assign]. In this example, select [1].
The Multi Viewer menu (7333.9) appears.
Split 10: Splits the screen...
Operating Instructions - Page 28
... the [Destination Address], [Destination
Level], and [Tally Type] parameters to the OUTPUTS 2 connector.
1 Set the position of the switcher processor. Proceed to the User's Guide.
In this example, select [136x138 (Standard)].
The New menu (7364.1) appears. Setting Serial Tally
Set the red tally of the program output (P/P PGM1) and the green tally of the...
Operating Instructions - Page 29
...tallies from a DCU, display the Engineering Setup >Router/Tally >Parallel Tally menu (7366) in [Group14], and [R5] to [R8] and [G5] to make settings.
Setting Destination Level Tally Type Enable
Value OUT002... For details about settings, refer to the User's Guide.
Input/outputs for the preview output.
In this example, select [Panel Port]. If the settings of the serial...
Operating Instructions - Page 39
... MVS-3000 and on the MVS-3000A without an MKS-6570 installed, only the background DME wipe or key 1 can set .
a Open the Engineering Setup >Switcher >Config menu (7331).
2 Enable the background DME wipe.
a Open the Engineering Setup >System >Start Up menu (7314).
2 Select the device to set the startup mode when power is turned on the...
Operating Instructions - Page 43
... User's Guide.
1 Initialize the MKS-8080/8082 settings. Switcher processor
MVS-6520/6530/ 3000A/3000
Board CA-85
STATION ID switch S3801
43 Setting Simple Connection of AUX Bus Remote Panel For details about setting the station ID, refer to "Setting the station number" in "Preparations for the MKS-8080/8082" in the MKS-8080/8082 Operation Manual.
3 Set the...
Operating Instructions - Page 50
...Apply a border to the picture-in order to select it on the MVS-3000A without an MKS-6570 installed, a setting must be enabled in -picture pattern. a Open the M/E-1 >DME Wipe >1ch menu (.... • On the MVS-3000 and on .
50 Saving DME Wipe Settings in picture) pattern. On the MVS-3000A with an MKS-6570 installed, configuration is required in order to check the video. In this example, ...
Sony MKS-6570 Reviews
We have not received any reviews for Sony yet.