TASCAM 202MKIV Support and Manuals
Get Help and Manuals for this TASCAM item
View All Support Options Below
Free TASCAM 202MKIV manuals!
Problems with TASCAM 202MKIV?
Ask a Question
Free TASCAM 202MKIV manuals!
Problems with TASCAM 202MKIV?
Ask a Question
Popular TASCAM 202MKIV Manual Pages
Owners Manual - Page 2
...instruction manual, may be determined by turning the equipment off and on the rear panel.
b) Increase the separation between the equipment and receiver. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. If this equipment not expressly approved by one or more of important operating and maintenance (servicing) instructions in a residential installation.
Please record the model...
Owners Manual - Page 3
... (battery pack or batteries installed) shall not be located ...INSTRUCTIONS
1 Read these instructions.
2 Keep these instructions.
3 Heed all warnings.
4 Follow all instructions.
5 Do not use caution when moving the cart/ apparatus combination to avoid injury from tip-over.
14 Refer all servicing to qualified service personnel. The wide blade or the third prong are provided for replacement...
Owners Manual - Page 5
...
HX Pro headroom extension originated by Bang and Olufsen. Use the rack-mounting kit to properly set the DOLBY NR switch to reduce tape hiss, a noise introduced during the recording and playback ...missing.
In playback, be sure to set up and connect the 202MKIV, as well as the operation of these items are mounting the unit in this manual thoroughly to ensure you understand how to...
Owners Manual - Page 6
...tape transport mechanism.
Do not install this to match your supplier or service agency.
• When ...leave sufficient space above the unit for ventilation. Please set this unit in a confined space such as a...unit, you should not use
Poor performance, errors, or malfunctions may result if you use... these tapes may also cause tape clog problems that you should tape the cassette decks...
Owners Manual - Page 9
e DOLBY NR switch This switch toggles the Dolby Noise Reduction system on/off . In playback you need to set this key temporarily stops playback or recording.
PAUSE Pressing this switch to the first 15 seconds of each segment.
4 COUNTER RESET keys Pressing these keys ...
Owners Manual - Page 16
... INTRO CHECK key during normal playback will fast wind in the same direction as playback. The Intro Check range varies depending on REV MODE switch settings:
Ä: Checks one side of the tape. Ê: Checks both sides of the tape. ä: Checks both sides of tape then double checks
the first...
Owners Manual - Page 17
... indicated by pushing in the same direction as the indicator. Turn on both sides. Set the REV MODE switch. Set the switch to ON to record with its open edge facing down, side "A" facing...prevention tabs of the loaded cassette tape have been broken off, stick a piece of your recording source and set the REC LEVEL control knob so that the level meter indicates "0 dB" at peaks.
7. NOTE Be...
Owners Manual - Page 18
To stop recording, press the stop recording temporarily. To erase a tape without making a new recording, set the REV MODE switch to run.
18 TASCAM 202MKIV I4M−PROeRcToArNdiTnSgAFETY PRECAUTIONS
8.
A second press of the ... to the direction you press the reverse PLAY key (h), recording will be done only on both tape sides, set the REC LEVEL control to stop key (ª).
Owners Manual - Page 20
... deck enters the record-pause mode. π and will light on the front panel.
2.
Set the REV MODE switch to . 3. Press the TAPE 1 deck's RECORD key. Plug your voice and the other settings, as instructed earlier in this manual.
Set the DOLBY NR switch to the ON position if you need to get the optimum...
Owners Manual - Page 21
... TAPE 1 deck, the TAPE 2 deck automatically starts recording. IMPORTANT SAFETY IN4 S−TReUcCoTrIdOiNngS
4. Recording is in the same direction as Record direction, Reverse mode setting, Dolby NR setting, Recording level, etc.
During parallel recording, the PARALLEL indicator is not recorded: when recording reaches the end of this order:
TAPE 1 Side "A"
≈
Side...
Owners Manual - Page 22
...PAUSE key followed play key (˙ or ¥) corresponding to adjust the recording level or
set the Dolby NR system, as the indicator.
Insert a cassette tape for playback into the ...;PROeRcToArNdiTnSgAFETY PRECAUTIONS
Dubbing (from TAPE 1 to start playback.
• Set the REV MODE switch as the recording level is set to press play /record direction indicator (˙/¥) on the pre...
Owners Manual - Page 23
... end of side "B", both tapes automatically switch over to side "B" and recording and playback re-start simultaneously.
TAPE l starts reverse play and TAPE 2 starts recording.
Set the REV MODE switch to get out of side "A", TAPE 1 stops and TAPE 2 enters the "blank recording" mode.
Insert a cassette tape for playback into the...
Owners Manual - Page 24
...case, TAPE 1 starts first. You can also insert tapes into both decks is set is fast-forwarded or rewound to the end.
We recommend normal speed dubbing for dubbing, as the recording ...steadily on the display. During normal speed dubbing, only the following keys work if the reverse mode is set to any positions other than Ë or if the transport direction of the pre-recorded tape. I4M...
Owners Manual - Page 25
... let both decks for a while, be supplied and recording will start (power on the POWER switch of your audio setup lets you don't use the timer for continuous recording).
4.
Connect this set the TIMER switch to be switched off . When the preset start time is reached, power will be switched off .
Connections...
Owners Manual - Page 26
... TEAC authorized service center or your dealer for 1 minute or more, then turning the power back on . Reinsert it .
Continuous play -
Playback speed seems somewhat fast or slow ® Check the pitch control setting. Problems you encounter on such occasions may be cured by plugging another component. I5M−PROeRfTeAreNnTcSeAaFnEdTYspPeRcEifCicAaUtiToIOnsNS
Troubleshooting
If you...
TASCAM 202MKIV Reviews
We have not received any reviews for TASCAM yet.