3Com 3CRWX315075A - Wireless LAN Managed Access Point 3150 Support and Manuals
Get Help and Manuals for this 3Com item
View All Support Options Below
Free 3Com 3CRWX315075A manuals!
Problems with 3Com 3CRWX315075A?
Ask a Question
Free 3Com 3CRWX315075A manuals!
Problems with 3Com 3CRWX315075A?
Ask a Question
Popular 3Com 3CRWX315075A Manual Pages
Quick Start Guide - Page 1
... Guide
3Com® WLAN Managed AP3150
3CRWX315075A / Model AP3150
The 3Com® AP3150 Managed Access Point provides dual-radio IEEE 802.11a and 802.11b/g wireless access to the access point:
• 3Com WX4400
• 3Com WX1200
• 3Com WX2200
• 3Com WXR100
Power is designed for the access point takes place on the 3Com Wireless LAN Switch. The following WLAN switch...
Quick Start Guide - Page 2
...6
7
8
Feature
Description
1 Antenna Connectors
Two RSMA type antenna connectors allow you to a 3Com Wireless LAN switch. The connection can be mounted on a wall or ceiling.
2 XREF.
6 Kensington lock ...the unit to be direct to the switch on the network.
4 Serial Port
The serial port is not supported.
5 Reset Button
To restore factory settings, press the reset button during power-...
Quick Start Guide - Page 3
...replaceable fuses or user-serviceable parts inside the unit. WARNING: RJ-45 ports. Either shielded or unshielded data cables with local and national building codes,...it is operational.
3 Observing Safety Precautions
This equipment must be installed in .) must be maintained when the access point is connected also...problem with problem solving actions in this guide, contact your personal safety.
Quick Start Guide - Page 5
...-band antennas • Mounting bracket (attached to -reach location. Set the port type on the back of disconnecting the access point from power. Record...Installation Item Switch port Cabling
Power Requirements
MAC Address
Description
3Com recommends that you install and configure the 3Com Wireless LAN switch before you install the access point. Preparing for a flat-surface installation...
Quick Start Guide - Page 6
... the external antenna and cable models that is not powered on the access point and hand-tighten them.
Screw the antennas on to the antenna connectors on when the antenna connections are connected to electrostatic discharge (ESD), which means that they operate in your application allows. For installation instructions, see the documentation that...
Quick Start Guide - Page 7
...sheet metal screws and two wall anchors. • If mounting to a wall.
Tabletop Mounting
To install the access point on a flat surface such as a table or desktop:
1 Remove the backing from... the access point on the table.
3 Connect the Ethernet cable (for power and network connection) to install it on a wall, ceiling, or electrical box.
The figures below show a cable being routed through ...
Quick Start Guide - Page 8
...powered by the following :
1 Connect the LAN cable from the switch or hub to the Hub/Switch port on the 3Com PoE
Injector (available separately).
2 Next connect a LAN cable ...the device into a properly grounded electric outlet.
PoE Switch/Hub
Access Point
Power Over Ethernet from the LAN
To power the access point using a 3Com PoE Injector (available separately), do the following methods:
...
Quick Start Guide - Page 10
...seconds. Troubleshooting
Refer to the Mobility System Configuration Guide or to the 3Com Wireless LAN Switch Reference Manual to ...problem with your access point you may need to reset it to Managed mode.
1 Before you connect to the unit, the Access Point Recovery Page is displayed:
5 Click the Browse button and navigate to the access point software image file. 6 Click Start Upgrade to update...
Quick Start Guide - Page 11
... point settings.
This product contains encryption. CAUTION: EXPOSURE TO RADIO FREQUENCY RADIATION
This device generates and radiates radio-frequency energy. This product must follow the specific operating instructions for an uncontrolled environment.
This product must be used with IC radiation exposure limits set forth for satisfying RF exposure compliance. Cannot be installed by...
Quick Start Guide - Page 12
... in conjunction with FCC Part 15 rules in the 5.15 to radio communications. However, there is the responsibility of the operator and professional installer to ensure that interference will be professionally installed to ensure compliance with the instructions, may not cause harmful interference, and (2) this 3Com WLAN Managed AP, Model AP3150 (3CRWX315075A), or the substitution or...
Quick Start Guide - Page 13
... operate with this device must not be so chosen that is installed outdoors is subject to the licensed service, this device.
High power radars are strictly prohibited for harmful ...section above (page 11), and having a gain greater than that the Industry Canada technical specifications were met.
SAFETY COMPLIANCE NOTICE
This device has been tested and certified according to the ...
Quick Start Guide - Page 15
...246;fur, sem gerðar eru í tilskipun 1999/5/EC.
3Com Corporation erklærer herved at http://support.3com.com/doc/AP3150_EU_DOC.pdf
EU - EU - The Access Point's radar ...of nearby radar operation may consult with European spectrum usage laws for the 3Com WLAN Managed AP3150, Model AP3150 (3CRWX315075A) at that location and correct the configuration of radar. This device ...
Quick Start Guide - Page 16
TAIWAN RF COMPLIANCE
CHINA ROHS
Copyright © 2007 3Com Corporation. Part Number: 10015915 Rev. Therefore service in relation to human life security is not available.
AA Published June 2007 All rights reserved. 3Com and the 3Com logo are associated. All other company and product names may cause radio interference during its operation. KOREA RF COMPLIANCE
This device...
3Com 3CRWX315075A Reviews
We have not received any reviews for 3Com yet.