AEG HG755421UM Support and Manuals
Get Help and Manuals for this AEG item
View All Support Options Below
Free AEG HG755421UM manuals!
Problems with AEG HG755421UM?
Ask a Question
Free AEG HG755421UM manuals!
Problems with AEG HG755421UM?
Ask a Question
Popular AEG HG755421UM Manual Pages
Product Manual - Page 2
...TROUBLESHOOTING 10 8. We have the following data available: Model, PNC, Serial Number. Visit our website for:
Get usage advice, brochures, trouble shooter, service information: www.aeg.com
Register your product for better service: www.registeraeg.com
Buy Accessories, Consumables and Original spare parts...SAFETY INSTRUCTIONS 4 3. When contacting our Authorised Service Centre, ensure that help...
Product Manual - Page 3
... from 8 years and above and persons with water, but switch off the appliance and then cover flame e.g. Always keep the instructions with a lid or a fire blanket. SAFETY INFORMATION Before the installation and use . ENGLISH 3
1. Accessible parts are hot. • If the appliance has a child safety device, we recommend you activate it cools down.
Product Manual - Page 4
... damaged
appliance. • Obey the installation instruction
supplied with the appliance. • Keep the minimum distance from the
other appliances and units. • Always be replaced by a qualified electrician. • ...If the appliance is installed above drawers make sure that the cable doesn't come into direct contact (for example using insulating sleeving) with parts that the space, ...
Product Manual - Page 5
... during operation. • Set the cooking zone to "off" after the installation.
• If the ...Service Centre or an electrician to change the specification of this appliance in a household environment. • Do not change a damaged mains cable.
• The shock protection of live and insulated parts must have an isolation device which evacuates the products of the installation...
Product Manual - Page 6
...burner. • The use of a gas cooking appliance results in the room where the appliance is installed. • Prolonged intensive use water spray and steam to the minimum position. • Use only ... maximum to clean the appliance.
• Clean the appliance with the appliance. • Do not install a flame diffuser on the appliance. It must not be damaged. • Do not activate the ...
Product Manual - Page 8
... knob, turn the control knob counterclockwise to maximum gas supply position and push it off position and try to Safety chapters.
5.1 Cookware
CAUTION! If after installation or a power cut. WARNING! The spark generator can start automatically when you can become tarnished if it into off before you put the same pan...
Product Manual - Page 9
...to the size of burners. ENGLISH 9
CAUTION! They must be careful when you replace the pan supports to get maximum stability and to prevent the hob top from damage. 2. Make ...turn down the flame to barely simmer the liquid.
5.3 Diameters of the hob. • Wash stainless steel parts with a moist cloth and some detergent. Make sure that the bottoms of pots do not stand above the ...
Product Manual - Page 10
... is correctly
try to activate the spark gen- Problem
Possible cause
Remedy
There is no spark when you put them back.
6.4 Cleaning the spark plug
This feature is released. The fuse is obtained through a ceramic ignition candle with a metal electrode.
The instructions about the Service Centre and conditions of charge, also during the...
Product Manual - Page 11
... 230V-50Hz IP20
A) Stick it on Guarantee Card and keep this part (if applicable). The hob should not be installed in the following British Standards Codes Of Practice: B.S. 6172/ B.S. 5440, Par. 2 and B.S. ...If it on instruction booklet. SER.NO DATA
0049
03 IT MADE IN ITALY
C
MOD. Model PNC Serial number
8.2 Important safety requirements
This hob must be installed in a room...
Product Manual - Page 12
... combustible material can be fitted above instructions or any strain on the end of the other fuel burning appliances in touch with either rigid or semi-rigid pipe, i.e. Domestic Gas Installation I .S. 813 Current Editions Table Four. Be careful they do not come in the same room, B.S. 5440 Part 2 Current Edition, should be ignored...
Product Manual - Page 13
... The appliance must be guided by means of clamps ...installation must not be connected with the one for Triple Crown burner). Neutral terminal • or E - Assemble the parts, follow the same procedure backwards. 5. Replace...which are not abided by a qualified electrician (e.g. 8.4 Injectors replacement
1. Remove the pan supports. 2.
Supply connections This hob has to a temperature of...
Product Manual - Page 14
...
3.
A
B
C D E
8.7 Replacement of the connection cable
The replacement of electric cable must be carried out exclusively by the service force centre or by personnel with similar competencies...earth connection in accordance with a 3 amp plug. If it is marked with the appliance installed. To replace the connection cable use a 3 amp ASTA-approved (BS 1362) fuse. Neutral -
...
Product Manual - Page 15
... with flat surface.
8.9 Possibilities for insertion
Kitchen unit with door The panel installed below the hob must be easy to remove and let an easy access in...panel
B) Space for connections
Kitchen unit with oven
The electrical connection of the hob and
the oven must be installed separately for
safety reasons and to let easy remove
B
oven from the unit.
9. TECHNICAL INFORMATION
9.1 Hob...
Product Manual - Page 16
... www.aeg.com
9.3 Other technical data
TOTAL POWER:
Electric supply:
Appliance category: Gas connection: Appliance class:
Gas original:
G20 (2H) 20 mbar = 11 kW
Gas replacement: G30 (3+) 28-30 mbar = 800 g/h G31 (3+) 37 mbar = 786 g/h
230 V ~ 50 Hz 3 core flexible cable with non rewireable plug fitted with a 3 amp cartridge fuse
II2H3...
AEG HG755421UM Reviews
We have not received any reviews for AEG yet.