AEG LX6WG84634BI Support and Manuals
Get Help and Manuals for this AEG item
View All Support Options Below
Free AEG LX6WG84634BI manuals!
Problems with AEG LX6WG84634BI?
Ask a Question
Free AEG LX6WG84634BI manuals!
Problems with AEG LX6WG84634BI?
Ask a Question
Popular AEG LX6WG84634BI Manual Pages
User Manual - Page 2
... 2 2. SETTINGS...30 10. CONSUMPTION VALUES 50 19. Get usage advice, brochures, trouble shooter, service and repair information: www.aeg.com/support
Subject to AEG!
DIAL AND BUTTONS 21 8. WASHING & DRYING 35 13. Risk of this appliance, carefully read the supplied instructions. FLUFF IN THE FABRICS 37 15. SAFETY INFORMATION
Before beginning the installation and use...
User Manual - Page 4
... the new supplied hose sets, or other new hose sets supplied by the Authorised Service Centre.
• Old hose sets must not be reused. • If the mains power supply cable is damaged, it must be
replaced by a utility.
• Ensure good air ventilation in the room where the appliance is installed to avoid the backflow...
User Manual - Page 6
... for a long time, where repair work has been carried out or new devices fitted (water meters, etc.), let the water flow until it is too short. Contact the Authorised Service Centre for the replacement of water in the appliance.
• Do not let hot items to touch the plastic parts of the appliance.
•...
User Manual - Page 7
...printed circuit boards, electronic displays, pressure switches, thermostats and sensors, software and firmware including reset software, door, door hinge and seals, other seals, door locking assembly, plastic peripherals such as detergent dispensers. 2.5 Service
• To repair the appliance contact the Authorised Service Centre. PRODUCT DESCRIPTION
3.1 Appliance overview
12
3
10 11 12...
User Manual - Page 8
1 Hinge supports 2 Detergent dispenser 3 Control ...Inlet hose connection 13 Back feet for levelling the appliance
The rating plate reports the model name (A), product number (B), electrical ratings (C) and serial number (D).
4. Make ... connect it to the cold water tap of the water storage tank.
5. INSTALLATION
WARNING! If you cannot connect the water inlet hose to your domestic cold ...
User Manual - Page 18
...176;
To align the door perfectly, make sure that the edge of cupboard door is necessary to the hinge supports on the inner side of the door.
18 ENGLISH The hinges can be fixed to the door by means of...
Ø 35 mm
449 mm
12,5 - 14 mm
22±1,5 mm
595-598 mm
A
Set the position of the four supplied screws A. The hinges will be adjusted to respect the proper opening angle (max. 105 ...
User Manual - Page 19
... appliance, contact our Authorised Service Centre. 1
2 ED C
Counter-magnet
The appliance is complete, to avoid movement outward. Check that they are compatible with the mains power supply. The power supply cable must be only installed when the appliance installation is pre set for damage or injury through failure to comply with the screw C in...
User Manual - Page 20
Dry
12 On/Off push button
20 ENGLISH Wash • Mode - 6. CONTROL PANEL
6.1 Control panel description
1
2
34
5
12
11 10 9
8
7
6
The permanent options are set by holding pressed the relative button for at least 3 seconds.
1 Programme dial 2 Display 3 Time Dry touch button 4 Auto Dry touch button 5 Start/Pause touch button 6 ...
User Manual - Page 21
... sound while switching the appliance on or off . g. ).
• Cycle end (
).
• Warning code (e.g.
).
• Error indicator (
).
For more details, refer to Stand-by function automatically deactivates the appliance after several minutes to reduce the energy consumption, you to set incompatible options/functions.
7.2 On/Off
Press this button for a few seconds to activate...
User Manual - Page 22
...The indicator of the last rinse is on this button to change / reset the programme.
Set this option to reduce creasing. The door stays locked and the drum turns regularly to ...you touch the Start/Pause button, the appliance performs the spinning phase and drains the water. Set this option for some washing
programmes
• Activate the Rinse Hold option. Touch Time Save button...
User Manual - Page 23
... in steps of normally soiled garments.
The corresponding indicator above the touch button illuminates. You cannot set all time values for a full load of 1 hour up a small amount of lightly soiled ... goes on the display. The time increases in
store. • Extra dry: laundry to set the required delay. When it is activated, touch this button the time value increases by the...
User Manual - Page 25
...
Sportswear 30 °C 40 °C -
Cold
1200 rpm (1200- 400 rpm)
3.0 kg
If you set the Extra Rinse option to chapter 'Fluff in the fabrics'. ENGLISH 25
In the washing phase compartment of the ...speed is also suita‐ ble for gym, cycling or jogging clothes or similar. If necessary, set this cycle, remove all items from the drum. Pour a cup of soiling)
All fabrics, except ...
User Manual - Page 38
...spaced evenly around the tub; manually redistribute the load so that you...washing instructions on the laundry care labels.
• Do not wash white and coloured items together.
• Some coloured items can cause balance problems ...8226; Turn multilayered fabrics, wool and items with printed illustrations inside the drum, set a special programme:
• Empty the drum. • Clean the drum,...
User Manual - Page 48
... ENGLISH No communica‐
Switch the appliance off and on the selected programme. Re‐ fer to "Installation instruction".
•
The spin phase does not op‐ •
erate or the washing cycle
lasts longer than usual.
•
Set the spin programme. Problem
Possible solution
The programme does not start the spin phase again.
User Manual - Page 49
... the appliance receives electrical power. • This problem may be caused by a failure of the appliance...set the correct temperature.
• Decrease the laundry load. The appliance makes an un‐ usual noise and vibrates.
•
Make sure that you need to
"Installation instruction..."Fluff in this user manual. Contact the Author‐
ised Service Centre.
The appliance does...
AEG LX6WG84634BI Reviews
We have not received any reviews for AEG yet.