Cisco AIR-LAP1121G-A-K Support and Manuals
Get Help and Manuals for this Cisco item
View All Support Options Below
Free Cisco AIR-LAP1121G-A-K manuals!
Problems with Cisco AIR-LAP1121G-A-K?
Ask a Question
Free Cisco AIR-LAP1121G-A-K manuals!
Problems with Cisco AIR-LAP1121G-A-K?
Ask a Question
Popular Cisco AIR-LAP1121G-A-K Manual Pages
Hardware Installation Guide - Page 2
... part 15 of Cisco Systems, Inc. Cisco Aironet 1100 Series Access Point Hardware Installation Guide © 2006 Cisco Systems, Inc. THE SOFTWARE LICENSE AND LIMITED WARRANTY FOR THE ACCOMPANYING PRODUCT ARE SET FORTH.... (0609R)
Any Internet Protocol (IP) addresses used in accordance with the instruction manual, may cause harmful interference to cause harmful interference, in which case users will...
Hardware Installation Guide - Page 8
... for basic problems with controller information. Interactive examples use these conventions: • Commands and keywords are in angle brackets (< >). The tips information might not be troubleshooting or even an action, but could be useful information. Cisco Aironet 1100 Series Access Point Hardware Installation Guide
viii
OL-4309-07 Appendix D, "Channels and Maximum Power Levels...
Hardware Installation Guide - Page 17
...settings maintained within the controller. The autonomous access points can roam throughout a facility while maintaining seamless access to operate as the center point of the Cisco Integrated Wireless Network Solution and requires no manual configuration before being mounted. Autonomous Access Points
The autonomous access point (models: AIR-AP1120B or AIR-AP1121G) (model: AIR-AP1252) supports...
Hardware Installation Guide - Page 19
... injector, switch, or power patch panel. The access point can perform a field upgrade to the mini-PCI radio and antennas to support new radio technologies, such as the 2.4-GHz IEEE 802.11g-compliant radio.
Ethernet Port
The auto-sensing Ethernet port accepts an RJ-45 connector, linking the access point to Appendix C, "Access Point Specifications," for a list of access point specifications...
Hardware Installation Guide - Page 20
... Power Patch Panel
Cisco Aironet 1100 Series Access Point Hardware Installation Guide
1-4
OL-4309-07 This LED is normally green when an Ethernet cable is connected, and blinks green when a packet is not associated with at least one wireless client. The LED is off , but is received or transmitted over the radio interface.
Cisco Aironet Power Injector (Cisco AIR-PWRINJ3= or Cisco AIR...
Hardware Installation Guide - Page 21
... to a wired LAN, associates to a root access point, and supports wireless clients
• Workgroup bridge-Not connected to a wired LAN, associates to UL 2043 for operation in a building's environmental air space, such as above suspended ceilings. OL-4309-07
Cisco Aironet 1100 Series Access Point Hardware Installation Guide
1-5 no other power injectors or power modules have been tested to UL...
Hardware Installation Guide - Page 33
...24
Power injector
AP/ BRITDOGE
NETWOTROK
Power cord
Universal power supply
Access Point
Option 4
The access point power options are listed below: • A switch with inline power, such as a Cisco Catalyst 3500XL, 3550, 4000, or 6500 switch • An inline power patch panel, such as a Cisco Catalyst Inline Power Patch Panel • A power injector (Cisco AIR-PWRINJ3= or Cisco AIR-PWRINJ...
Hardware Installation Guide - Page 34
... connector labeled Ethernet on the access point. Caution
Only the fiber-optic power injector (AIR-PWRINJ-FIB) has been tested to UL 2043 for the access point.
Connect the other end of the power module into an unpowered Ethernet port on the access point. Cisco Aironet 1100 Series Access Point Hardware Installation Guide
2-8
OL-4309-07 Connect the power module's output connector to...
Hardware Installation Guide - Page 38
... the access point.
Caution
Only the fiber-optic power injector (AIR-PWRINJ-FIB) has been tested to UL 2043 for each of these mounting methods are also provided. Security features for operation in accordance with Section 300-22(C) of the National Electrical Code (NEC) and Sections 2-128, 12-010(3) and 12-100 of the Canadian Electrical Code, Part...
Hardware Installation Guide - Page 43
... T-rails. See the illustration above the ceiling tile. National Electrical Safety Code. Note The power module and power injector are securely attached to make it with the U.S. Make sure the clips are not rated for maximum clearance above . After you have installed the access point on the wall or ceiling mounting bracket and the security hasp adapter...
Hardware Installation Guide - Page 72
...support Wireless Domain Services (WDS) and cannot communicate with Cisco 2006 or 4400 series wireless LAN controllers. Guidelines for Using 1100 Series Lightweight Access Points
Chapter 6 Troubleshooting Lightweight Access Points
Guidelines for Lightweight Access Points" section on the 1100 series lightweight access point, because it .
• The access points support eight Basic Service Set...
Hardware Installation Guide - Page 95
... (0 to 40oC) for the power injector -13 to 158oF (-25 to 70oC) for the 1100 series access point. C A P P E N D I X
Access Point Specifications
This appendix provides technical specifications for access point
10.5 oz (297g) with 2.4-GHz radio
OL-4309-07
Cisco Aironet 1100 Series Access Point Hardware Installation Guide
C-1 Table C-1
Access Point Specifications
Category Physical
Size Status...
Hardware Installation Guide - Page 97
... Series Access Point Hardware Installation Guide
C-3
no other power injectors or power modules have been tested to UL 2043 for operation in accordancew ith Section 300-22(C)oftheN ationalElectricalCode(N EC)and Sections2-128, 12-010(3)and 12-100 oftheCanadian ElectricalCode,Part1,C22.1. A diversity system with two integrated 2.2 dBi dipole antennas.
Appendix C Access Point Specifications...
Hardware Installation Guide - Page 99
... under Access Points.
Click Install and Upgrade Guides.
OL-4309-07
Cisco Aironet 1100 Series Access Point Hardware Installation Guide
D-1 Click Channels and Maximum Power Settings for Cisco Aironet Autonomous Access Points and Bridges or the Channels and Maximum Power Settings for Cisco Aironet Lightweight Access Points and Bridges documents available on the Cisco Wireless documentation...
Hardware Installation Guide - Page 102
... to the product documentation. You can configure lightweight access point settings such as described in this mode for LWAPP communications. Cisco Aironet 1100 Series Access Point Hardware Installation Guide
E-2
OL-4309-07 Appendix E Priming Lightweight Access Points Prior to Deployment
Before deploying your lightweight access points to their final locations, follow these steps to prime...
Cisco AIR-LAP1121G-A-K Reviews
We have not received any reviews for Cisco yet.