Clifford Matrix 3 Support and Manuals
Get Help and Manuals for this Clifford item
View All Support Options Below
Free Clifford Matrix 3 manuals!
Problems with Clifford Matrix 3?
Ask a Question
Free Clifford Matrix 3 manuals!
Problems with Clifford Matrix 3?
Ask a Question
Most Recent Clifford Matrix 3 Questions
Central Locking Wires On A 950 Intelliguard
(Posted by Anonymous-150307 9 years ago)
Popular Clifford Matrix 3 Manual Pages
Owners Guide - Page 2
...limitation the siren, the remote transmitters and the associated sensors...code or serial number is returned to Directed®, shipping prepaid with excessive damage. the unit has been modified or used in workmanship or material under reasonable use , neglect, improper service, installation... original purchaser to repair or replace with a comparable reconditioned model any unit with ...
Owners Guide - Page 3
... covered by an Anti-Theft Guarantee.
Some states do not allow limitations on automobile ➤ Installation receipts
trademarks and copyrights
Bitwriter™, Clifford®, Code Hopping™, DEI®, Directed®, Doubleguard®, ESP™, FailSafe®, Ghost Switch™, Learn Routine™, Nite-Lite®, Nuisance Prevention Circuitry®, NPC®, Revenger...
Owners Guide - Page 5
.... This system must be installed by an authorized dealer. what is included
➤ A 3-channel control module ➤ A pair of four-button transmitters ➤ An XHF receiver/antenna ➤ A shock sensor ➤ A siren ➤ A red LED status indicator light ➤ A push-button Valet switch ➤ Your warranty registration ➤ Fault-proof starter interrupt ready circuitry...
Owners Guide - Page 7
... receiver uses computer-based code learning to any receiver function. The buttons in all of the instructions in this manual correspond to your system ...➜ standard configuration
Button
The arming, disarming and panic function are controlled by
. (Remote Controlled Chirp
Muting works by an authorized dealer.
The transmitter initially comes programmed with Standard Configuration...
Owners Guide - Page 8
...locks have
added to your system
The buttons used in the instructions in groups, refer to the Diagnostics section of this manual correspond to the standard transmitter configuration. Button
Another optional convenience ...a short siren sound, or chirp, and see the LED status indicator flashing in this guide.
If you will lock. When the system arms, you hear a second chirp after...
Owners Guide - Page 13
Press the Valet switch the preset DRW-35 number of the Valet switch required to check with the installer for less than one op- The unit can do this for you must have waited too long; eration only. In order to the "on" position. turn the ignition off the arm or disarm siren chirps, use
Remote Controlled Chirp...
Owners Guide - Page 14
... it serviced.
In Valet Mode, the security system will not arm, even with your vehicle, you want chirp-free. Press and release the Valet
switch within 10 seconds.
© 2001 directed electronics, inc.
11
DRW-35
3. This is still fully capable of triggering. Only the Warning Zone response is armed using Valet Mode. tion by using Remote...
Owners Guide - Page 15
.... Press
.
4. Here's how it works: The alarm triggers three times. Each time, the same sensor or switch is set up.
1. Open any vehicle door.
2. The three triggers are within 60 minutes of triggers as thunder, jackhammers, airport noise, etc. Remember, the buttons used in all the instructions in this guide correspond to a Standard Configuration transmitter.
Owners Guide - Page 20
...specific transmitter is used with your dealer for any reason, such as servicing the car, when the battery is reconnected the unit will recall the stored state from Directed®. note: Owner Recognition cannot be in your dealer can program many of the system including arm, disarm, VRS, and Valet... settings that transmitter. It is almost like having four separate alarms in Valet Mode...
Owners Guide - Page 23
...installer is also possible to disarm the AED feature by turning the ignition key to the "run" position and pressing the Valet switch the programmed number of the vehicle will be disabled 30 seconds after one -half its normal armed rate) to arm the car with the remote...a nuisance. Thirty seconds later, the starter of whether or not the alarm is in Valet Mode. AED is disabled when the system...
Owners Guide - Page 24
...manual for any duration ranging from any sensor indefinitely. The siren chirps can be programmed from 1-5 presses.
computer and the TechSoft Programmer, the full triggered response can be programmed for a complete explanation of the Valet switch... 1 to 180 seconds. ➤ False Alarm Control Technology (FACT) on or off .
➤ Valet pulse count: The number of presses of how...
Owners Guide - Page 25
...manual for a complete explanation of a carjacking. Should a carjacking occur, the VRS allows you from your vehicle. installation... options
The system has many options that if your vehicle is taken by an unauthorized user, it does ensure that may require extra parts and labor. Please refer to ensure that when disarmed, only the driver...: In most cars with electric power door ...
Owners Guide - Page 29
...the vehicle's starter from cranking when the system is ready for this feature, however installation may require ... is also used to DRW-35 disarm the VRS system.
Fault-Proof Starter Interrupt: An automatic switch controlled by a sensor, pinswitch...physical connection to report triggers and faults in Valet mode, or should the starter interrupt switch itself fail. Your system is disarmed, in...
Owners Guide - Page 30
... the secondary Warning Zone response.
Transmitter: Hand-held, remote control which operates the various functions of your system consists of 30 seconds of your system. Valet Switch: A small push-button switch mounted somewhere inside the vehicle. Siren: Noise generating device usually installed in the vehicle that the alarm can recognize as the six tones you hear...
Owners Guide - Page 33
... system should now disarm. Press and release
the Valet switch within 15 seconds. To activate Remote Controlled Chirp Muting
➤ Press
briefly before arming or disarming, and the confirmation chirp(s)
will be eliminated for that the ignition is on and try again.
quick reference guide
To arm using your transmitter for
one operation only...
Clifford Matrix 3 Reviews
We have not received any reviews for Clifford yet.