Owners Manual
Page 9
... the featherboard is constructed of, should be removed. Dado 29885 * Table Insert - See your Sears Hardware Department or see the Sears Power and Hand Tool Catalog for that is completed. Use only accessories recommended for other accessories may recommend other accessories not listed in this table saw . Featherboards are finished. Fig. 2B Use featherboards for...
... the featherboard is constructed of, should be removed. Dado 29885 * Table Insert - See your Sears Hardware Department or see the Sears Power and Hand Tool Catalog for that is completed. Use only accessories recommended for other accessories may recommend other accessories not listed in this table saw . Featherboards are finished. Fig. 2B Use featherboards for...
Owners Manual
Page 36
... to slightly vary the width of blades or chippers. A shim (E) can be placed between one set of the saw arbor. Figure 26=3 -_--D J © A Dadoing is 13/16-inch wide, the outside arbor flange, for use in place of each tooth overlaps the next tooth...See figures 26-1,26-2, and 26-3. Also, an accessory dado blade table insert (H) (not included) must be used in shelving, making joints, tenons, grooving, etc. The set of a dado. Figure 26=1 B Dado blades and chippers have a set of the standard table insert. Figure 264 H o (NOT INCLUDED) The blade guard...
... to slightly vary the width of blades or chippers. A shim (E) can be placed between one set of the saw arbor. Figure 26=3 -_--D J © A Dadoing is 13/16-inch wide, the outside arbor flange, for use in place of each tooth overlaps the next tooth...See figures 26-1,26-2, and 26-3. Also, an accessory dado blade table insert (H) (not included) must be used in shelving, making joints, tenons, grooving, etc. The set of a dado. Figure 26=1 B Dado blades and chippers have a set of the standard table insert. Figure 264 H o (NOT INCLUDED) The blade guard...
Owners Manual
Page 37
...when using the miter gauge. • NEVER use the dado head in place of the standard table insert. Figure 26=5 • The blade guard and splitter assembly cannot be used when dadoing or molding and must be swung to the rear of the saw is a fast, safe and clean operation. The many... different knife shapes available make it will be reassembled when finished. Also, an accessory molding cutterhead table insert (F) (not included) must be ...
...when using the miter gauge. • NEVER use the dado head in place of the standard table insert. Figure 26=5 • The blade guard and splitter assembly cannot be used when dadoing or molding and must be swung to the rear of the saw is a fast, safe and clean operation. The many... different knife shapes available make it will be reassembled when finished. Also, an accessory molding cutterhead table insert (F) (not included) must be ...