Fender PCN-2 Support and Manuals
Get Help and Manuals for this Fender item
View All Support Options Below
Free Fender PCN-2 manuals!
Problems with Fender PCN-2?
Ask a Question
Free Fender PCN-2 manuals!
Problems with Fender PCN-2?
Ask a Question
Popular Fender PCN-2 Manual Pages
Owners Manual - Page 1
PCN-2 Owner's
f ----- S. O
we
f
create
/ the future
ELECTRONICS P/N 071-5510-000
Owners Manual - Page 2
... provide a truly flat summed response. This is one of only a few minutes to use of trouble free service.
The PCN-2 uses a unique and highly accurate 24 dB per octave Linkwitz-Riley filter system. We believe you have invested in the PCN-2 by the use an electronic crossover, • Recomended hookup methods, • A features description section...
Owners Manual - Page 3
...drivers have different characteristics, different types of problems.
What Does A Crossover Do? Because of construction. Just as well. Problems...drivers.
This will handle less power than the speaker drivers...drivers loaded into a wooden box. Probably one of brute force (i.e.
Instead of the main problems...frequency drivers.
Another problem occurs...by a midrange driver, and high ...
Owners Manual - Page 4
... system properly in the high frequency part of power (such as "electronic ... "multi-way, active system". Particularly in setting the crossover frequency too low, as integrated circuit... can run your tweeter (or compression driver). By using low level electronic crossover ... by the demands of speaker systems provide detailed specifications on power capacity and frequency range, and often ...
Owners Manual - Page 5
... Fender PCN-2 and PCN...Fender SPL Tour Series 118s or 215s. The CD boost is needed in CD horns).
Set the crossover frequency between the subwoofer and the full range speaker at around 100 to 150 Hz., and the crossover frequency between the woofer and the horn/compression driver...24 dB per octave circuit topology (which is what the PCN-2 is based on the crossover are concerned, start with a 24...
Owners Manual - Page 6
... output when used to +6 dB above unity gain. It should not be carefull that it is set for at least 800 Hertz. In the mono three way mode, it is used in the stereo... range is from 80 to the first channel of the PCN-2. This control varies the Channel B low frequency output when used to the second channel of the PCN-2. Channel A Low Frequency Output Level Control. In the ...
Owners Manual - Page 7
... and low frequencies.
Power On/Off Switch This turns the unit on . Instead, a screw is installed where the switch hole is on and off. A.C. Channel B High Frequency Output Level Control. Channel ... into 120 V.A.C., @ 60 Hz. Early models of the PCN-2 do not have this into any other voltage, or damage will result.
Mains Fuse In case of failure, replace only with the same type of the system...
Owners Manual - Page 8
... pressed in)and out (when the switch is a male 3 pin XLR style jack with a balanced output.
20. In the mono three way mode, do not plug anything into this output into the input of the indicated position... This switch selects between the stereo two way mode, and the mono three way mode. On early models of the PCN-2, this is used in the stereo two way mode, or , in the stereo two way mode....
Owners Manual - Page 9
... Input
SPL Tour Series 118-S or 215-S
Subwoofer Input
Page Eight
SPL Tour Series 118-S or 215-S Subwoofer Input
Graphic Equalizer Left Output to PCN-2
Channel B Input
* 0
•o
PCN-2 Channel B High Frequency Out
Example One A
Stereo 8i-Amplified Sound System
SPL-9000 Power Amp
(Bridged Mono Mode)
Channel A Input
. Bridged Mono
Output...
Owners Manual - Page 10
... a
0
2 1-::
seam
0
NOW
•
r......- a 0
0 •
ir . 0
PCN-2 Channel A PCN-2 PCN-2
High Frequency Out Channel Channel B
B High (Midrange)
Low Frequency
Frequency Out
Out
Example Two A... Nine
si-n
Graphic Equaliser Output to PCN-2 Channel A Input
Fender-Sunn PCN-2 Electronic Crossover (Mono 3-Way Mode)
0 g
PEI? Graphic Equalizer (From Mixer Output)
. ....
Owners Manual - Page 11
...8226; ° Graphic Equaliser Left
(From Mixer Output)
Fender-Sunn SP-3215 or SP-3202 Dual Channel Graphic Equali7er
•I stYPI, °
Graphic Equali7er Right
Example Three
A Stereo
Output to PCN-2 Channel A Input
Output to PCN-2 Channel B Input
2-Way
0 .. 0 •
•
BIr •0 0 - .0
PCN-2 Channel A
PCN-2
PCN-2
Bi-Amplified Sound
Low Frequency Out (Crossover = 2 KHz...
Owners Manual - Page 12
Frequency Response: 10 Hz. to 22.5 KHz. Horn Equalization: +3 dB @ 3.5 KHz. rising 6 dB/octave to 20 KHz. (+ .5 dB)
C.D.
Specifications:
Crossover Filter Type: 4th Order State Variable Linkwirz-Riley design, 24 dB/octave slopes Crossover Frequency Range: Low 80 to 920 Hz., High 800 to 9.2 KHz.
Fender PCN-2 Reviews
We have not received any reviews for Fender yet.