Honeywell RCW3504N1001/N - Decor Wired Door Chime Support and Manuals
Get Help and Manuals for this Honeywell item
This item is in your list!
View All Support Options Below
Free Honeywell RCW3504N1001/N manuals!
Problems with Honeywell RCW3504N1001/N?
Ask a Question
Free Honeywell RCW3504N1001/N manuals!
Problems with Honeywell RCW3504N1001/N?
Ask a Question
Popular Honeywell RCW3504N1001/N Manual Pages
Owner's Manual - Page 2
...Push...11 Volume control...11 Change tunes...12 Program button...14 Finishing the wood cover...15 Specifications...16 Troubleshooting...17 Disposal and recycling...18 Guarantee...18 Declaration...18
69-2173EFS-03
ii
69-2173EFS_B.indd 2
4/17/2008 11:15:45 AM Installation Instructions
Contents Safety...3 Checking pack contents...4 Installation...5 Power supply...6 Mount the chime...7 Wiring -
Owner's Manual - Page 3
VOLUME CONTROL CHANNEL INDICATOR LED
WIRE CONNECTION PORT/TERMINAL HOLE FOR CABLE/WIRE ENTRY OPTIONAL POWER WITH FOUR x LR14C ALKALINE BATTERIES
WIRED CHIME BASE
69-2173EFS_B.indd 1
RCW35 Series and RCW25 Series
PROGRAM BUTTON
TUNE BUTTON
LOW BATTERY LED
DECORATIVE CHIME COVER
SOLD SEPARATELY FROM
RCW35N
M27274
M27254
69-2173EFS-03
4/17/2008 11:15:45 AM
Owner's Manual - Page 4
Can work with "B." Illuminated bell push buttons can be used when the chime is powered by a transformer (Honeywell RCA900N).
69-2173EFS-03
69-2173EFS_B.indd 2
4/17/2008 11:15:45 AM Installation Instructions
Compatible with most bell pushes, with standard normally open contacts, including Honeywell wired pushes marked with up to 3 push circuits.
Owner's Manual - Page 5
... cables and water pipes. Replace only with the installation, please note the following safety warnings:
• Always follow the manufacturer's advice when using power tools and wear suitable protective...holes, etc.
• Before drilling holes in doubt.
• Chime is incorrectly replaced. RCW35 Series and RCW25 Series
Safety Before proceeding with the same or equivalent type.
69...
Owner's Manual - Page 6
Installation Instructions
Checking Pack Contents • Chime • 2 x fixing screws for chime • 2 x wall plugs
You will need: • Wired push • 20 AWG minimum bell wire • 4 mm cross-head screwdriver • A small flat bladed screwdriver • 1/4-in. (6 mm) masonry drill bit • 4 x LR14 'C' Alkaline batteries OR transformer (16V 10 VA) Honeywell part number...
Owner's Manual - Page 7
Open the chime cover
RCW35 Series and RCW25 Series
69-2173EFS_B.indd 5
M27275
69-2173EFS-03
4/17/2008 11:15:45 AM Installation 1.
Owner's Manual - Page 8
OR a 16V, 10VA transformer as recommended in the table below below:
69-2173EFS-03
69-2173EFS_B.indd 6
ATTENTION! ATTENTION! ¡ATENCIÓN! T 16 V~
1
2
3
M27276
4/17/2008 11:15:45 AM
Determine the type of power supply and type of wired push required to suit your installation. Use 4 x LR14 'C' size alkaline batteries; Installation Instructions
Power Supply
2.
Owner's Manual - Page 10
...Installation Instructions
Wiring
Connect the wires from opening in step 4. The wires can be surface 16V~ mounted or direct from door push and transformer (where used) to the chime terminals as detailed in the wall and enter the rear of the chime housing using the wire guide... channels provided.
4a. Wiring for standard/lighted push via a 16V 10VA transformer.
16V~
OPTION 1: AC POWERED ...
Owner's Manual - Page 12
Battery powered - x 1
Note: Wire/cable length should not exceed 150 ft. (50 m).
69-2173EFS-03
10
69-2173EFS_B.indd 10
x 3
AC V/AC C1 C2 C3 1 2 3 M27281
4/17/2008 11:15:46 AM Installation Instructions
4b. Wiring for
standard (non-lighted) push only.
Owner's Manual - Page 14
Chime tunes are provided plus an additional alert tone.
Installation Instructions To Change Tune
7. Alert
69-2173EFS-03
12
69-2173EFS_B.indd 12
4/17/2008 11:15:46 AM Tunes Table Ding Dong
St Clements
Westminster
Tube Chime
Warm Brass
Fantasy
!
Owner's Manual - Page 16
Installation Instructions
Program Button
8. The channel LED will flash. While channel LED is flashing, tune can be changed using the tune select button .
• Recall A short push ...
Owner's Manual - Page 18
Installation Instructions
Specification Operating Temperature Sound Level (typical) Power Supply
Battery Life (if applicable) (5 operations/day)
Chime
32°F to 104°F 0°C to +40°C
90dBA @ 3 ft (1m)
4 x LR14 C size alkaline batteries OR 16V 10VA transformer (UL approved) Honeywell part number RCA900N
12 months
69-2173EFS-03
16
69-2173EFS_B.indd 16
4/17/2008 11:15:46 AM
Owner's Manual - Page 19
... chime battery is low, an amber LED located at the minimum setting.
Only use a 16V 10VA transformer connection for an illuminated push. Install
new batteries in the chime, type LR14 'C' cells. If using minimum 20AWG wire. RCW35 Series and RCW25 Series
Troubleshooting
When the illuminated bell push is operated, very dim / no light...
Owner's Manual - Page 20
...including interference that this does not affect your statutory rights. Check with your product, call the Honeywell helpline at 1-800-468-1502. Installation Instructions
Disposal & Recycling Batteries and waste electrical products should not be disposed of the FCC rules and ... B digital apparatus complies with household waste. this product complies with Part 15 of with Canadian IECS-003.
Owner's Manual - Page 22
Registered Trademark. © 2008 Honeywell International Inc. 69-2173EFS-03 M.S. ACS, Environmental and Combustion Controls 1985 Douglas Drive, Golden Valley, MN 55422 www.honeywell.com
Printed in U.S.A. Rev. 04-08
69-2173EFS_B.indd 20
4/17/2008 11:15:47 AM on recycled paper containing at least 10% post-consumer paper fibers.
® U.S. Honeywell International Inc.
Honeywell RCW3504N1001/N Reviews
Do you have an experience with the Honeywell RCW3504N1001/N that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Honeywell yet.
Earn 750 points for your review!