Jenn-Air JDRP636H Support and Manuals
Get Help and Manuals for this Jenn-Air item
View All Support Options Below
Free Jenn-Air JDRP636H manuals!
Problems with Jenn-Air JDRP636H?
Ask a Question
Free Jenn-Air JDRP636H manuals!
Problems with Jenn-Air JDRP636H?
Ask a Question
Popular Jenn-Air JDRP636H Manual Pages
Warranty - Page 1
...with products not approved by our authorized Jenn-Air Service Providers. Service to review the Troubleshooting or Problem Solver section of repair or replacement under this warranty. light bulbs, batteries, air or water filters, preservation solutions, etc.).
5. Repairs to parts or systems to province. The cost of the Use and Care Guide or visit https://jennair.custhelp.com.
2.
Some...
Owners Manual - Page 4
... as aluminum foil.
I User Servicing - Only certain types of the range. They should never be stored in the manual.
Do not operate range without the anti-tip bracket fastened down properly.
Aluminum foil linings may ignite. Loose-fitting or hanging garments should be seriously injured. Do not repair or replace any part of a range - I WARNING...
Owners Manual - Page 27
... burner.
If the burner does not light, check cap alignment. If the burner needs to be adjusted, contact a trained repair specialist.
4. Replace burner cap. If the burner still does not light, do not service the sealed burner yourself. Do not enlarge or distort the port. Burner
2. Clean food spills.
1
1 Incorrect 2 Correct
2
To preserve...
Owners Manual - Page 35
.... If the problem continues, call , refer to start button to operate properly. Make sure cap is continuous sparking, but does not light. Reconnect the meat probe. Make sure cap is wet. See the Installation Instructions for valid knob combinations. Moving too quickly between cooking modes can cause issues with a straight pin. TROUBLESHOOTING
First try...
Installation Instructions - Page 6
...models
■ It is adequate as long as it must conform to the floor during transit. A
■ Follow the range hood or microwave hood combination installation instructions for dimensional clearances above the cooktop surface.
■ Recessed installations..., Part 3280 (formerly the Federal Standard for Manufactured Home Installations, ANSI A225.1/NFPA 501A or local codes. The model/serial...
Installation Instructions - Page 9
...Must include a shut-off valve: Install a manual gas line shut-off valve during any...is needed for turning on the model/serial/rating plate for use the...Gas: This range is factory set for use TEFLON®†...valve. Flexible metal appliance connector:
■ If local codes permit, a new CSA design-certified, 4-5 ft ... a qualified service technician.
Gas supply line B. The parts for this...
Installation Instructions - Page 10
...parts package from packaging on the floor behind range. Remove grates from range.
Lift range up about 3" (8.0 cm) and move and install range. Kick plate b. Set range on top of range and grate pack. INSTALLATION INSTRUCTIONS...48" (121.9 cm) models only, rotate center support counterclockwise off the pallet until it back until range is not needed for installation.
3. Using two or ...
Installation Instructions - Page 13
...Open valve
2. Open the manual shut-off valve. The
...-detection solution. Turn on griddle models)
The griddle is plugged into ...instructions located in the well at the front of a qualified person include: licensed heating personnel, authorized gas company personnel, and authorized service personnel. Install Griddle Tray
(on power supply. Place drip tray in the Use and Care Guide...
Installation Instructions - Page 17
..." and "NAT" position on the model/serial/rating plate. Kick plate B. Locate the gas pressure regulator at least 1" (2.5 cm) water column pressure above the set pressure. A
A.
Gently lay kick ...psi (3.5 kPa) gauge (14" [35.6 cm] WCP)
The range and its individual manual shut-off valve must be disconnected from the gas supply piping system during any pressure testing ...replace kick plate.
Installation Instructions - Page 21
... manual ...installed, remove them. 2. Remove the burner base by using a large flatblade screwdriver, turning the regulator cap clockwise.
7. Replace...driver while changing it. Tighten screws only until burner is pointing toward the cap. Locate the "LP" and "NAT" position on the model/serial/rating plate. Line pressure testing above the manifold pressure shown on the spring retainer. Set...
Internet Connectivity Guide - Page 1
.../connect. www.jennair.com/connect
In Canada, visit www.jennair.ca
IMPORTANT: Proper installation of use is printed on a label and can be guided through the steps to read and follow the Installation Instructions that came with WPA2 security. The SAID code is your appliance. For additional information, terms of your appliance prior to use...
Owners Manual 1 - Page 4
...; Slide range forward. • Look for range-top service without breaking due to the open door without anti-tip bracket installed and engaged. I CAUTION: Do not store items of a range -
children climbing on the backguard of interest to cause burns. Do not repair or replace any part of glass, glass/ceramic, ceramic, earthenware, or other...
Owners Manual 1 - Page 18
...Mode must be automatically replaced by visiting iTunes®&#...Connectivity and Remote Operation
Models are provided with ...puts complete control of the part code mentioned herein will still remain... temperature rises above a certain level set "Away."
Add Appliance
1. NOTE:... the app will be scanned or manually added. Within a few seconds, ... will not turn on your guide and walk you 're away...
Owners Manual 1 - Page 27
...first unless otherwise noted. If the burner still does not light, do not service the sealed burner yourself. Do not use oven cleaners, bleach, or rust ...repair specialist.
2. Clean gas opening with damp cloth.
16-Jan-2019 04:15:32 EST | RELEASED
In some European factories the letter "W" of the part code mentioned herein will be adjusted, contact a trained repair specialist.
4. Replace...
Owners Manual 1 - Page 35
... the part code mentioned herein will not operate.
See the Installation Instructions for disabling. See Sabbath Mode section for leveling instructions.
The burner ports are clogged. If the problem continues, call , refer to self-clean.
16-Jan-2019 04:15:32 EST | RELEASED
In some models, the Sabbath Mode is not being used . The proper cookware is set...
Jenn-Air JDRP636H Reviews
We have not received any reviews for Jenn-Air yet.