Kenwood TK-2302 Support and Manuals
Get Help and Manuals for this Kenwood item
View All Support Options Below
Free Kenwood TK-2302 manuals!
Problems with Kenwood TK-2302?
Ask a Question
Free Kenwood TK-2302 manuals!
Problems with Kenwood TK-2302?
Ask a Question
Kenwood TK-2302 Videos
Kenwood TK-2302/3302
Duration: :56
Total Views: 8,411
Duration: :56
Total Views: 8,411
Popular Kenwood TK-2302 Manual Pages
User Manual 1 - Page 2
... on our health and the environment. Contact your KENWOOD dealer. ◆◆ Use of the transceiver while you may
be recycled at gasoline service stations. ◆◆ Near explosives or blasting sites. ◆◆ In aircraft. (Any use of the transceiver must follow the instructions and regulations provided by the airline crew.) ◆...
User Manual 1 - Page 4
..., hold the microphone approximately 3 cm to switch the transceiver ON.
BASIC OPERATION
SWITCHING POWER ON/ OFF
Key type:
Press [ ] to 4 cm (1.5 inches) from your transceiver settings.
3
< PO_BASIC_OP_PMR > Clockwise increases the volume and counterclockwise decreases it becomes free. 3 Press the PTT switch and speak into the microphone.
Press [ ] again to decrease the...
Operation Manual - Page 3
AT BE DK FI FR DE GR IS IE IT LI LU NL NO PT ES SE CH GB CY CZ EE HU LV LT MT PL SK SI BG RO HR TR
ISO3166 Restrictions This equipment requires a licence and is intended for use in the countries as below.
ENGLISH
VHF FM TRANSCEIVER/ UHF FM TRANSCEIVER
TK-2302/ TK-3302
INSTRUCTION MANUAL
NOTIFICATION This equipment complies with the essential requirements of Directive 2014/53/EU.
Operation Manual - Page 5
...disposed as household waste.
Contact your local authority for countries that have chosen KENWOOD for your land mobile radio applications. Proper recycling and waste disposal will ...service to and ownership of copyrights for firmware embedded in locating a recycle facility nearest to the operation of Old Electrical and Electronic Equipment and Batteries (applicable for details in KENWOOD ...
Operation Manual - Page 6
... reduce
the transceiver volume. Do not touch these locations when replacing the battery pack. • Do not immerse the transceiver ... to the volume level when turning the squelch off before installing optional accessories. • The charger is the device that...not specified by KENWOOD. • If the die-cast chassis or other transceiver part is damaged, do not
touch the damaged parts. • ...
Operation Manual - Page 7
... the driver or passengers. • Do not transmit while touching the antenna terminal or if any metallic parts are posted regarding the use only a speaker/microphone in these conditions, to medical facilities. • Near persons using an earphone accessory in a high-frequency burn. • If an abnormal odor or smoke is incorrectly replaced; Turn...
Operation Manual - Page 10
If the battery pack has not finished charging even after the regulated time has passed, stop it may cause eye-problems.
• Do not charge the battery for any other reason, remove it . The battery may cause the battery to generate smoke or burst into a microwave ...
Operation Manual - Page 11
SUPPLIED ACCESSORIES
• Antenna CONTENTS
UNPACKING AND CHECKING EQUIPMENT 1 PREPARATION 2 ORIENTATION 5 PROGRAMMABLE AUXILIARY FUNCTIONS 7 BASIC OPERATIONS 9 VOICE OPERATED TRANSMISSION (VOX 10 BACKGROUND OPERATIONS 11
UNPACKING AND CHECKING EQUIPMENT
Carefully unpack the transceiver. If any of the items listed below are missing or damaged, file a claim with the carrier immediately....
Operation Manual - Page 12
PREPARATION
INSTALLING/ REMOVING THE BATTERY PACK
◆ Do not short the battery terminals or dispose of the battery by fire. ◆ Never attempt to remove the casing ...
Operation Manual - Page 13
... transmission or when left sitting in these glues, may crack the transceiver's back panel.
3 INSTALLING THE BELT CLIP
If necessary, attach the belt clip using the two supplied M3 x 8 ..., nor a speaker/ microphone attachment point. Note: The antenna is designed to the transceiver.
INSTALLING THE ANTENNA
Antenna
Screw the antenna into the connector on the top of the transceiver by holding...
Operation Manual - Page 14
... is not charged at the factory;
Note: To keep the transceiver water resistant, you are not using a speaker/ microphone, install the cover over the speaker/ microphone jacks using the speaker/ microphone. Speaker/ microphone jack cover
INSTALLING THE OPTIONAL SPEAKER/ MICROPHONE (OR HEADSET)
1 Insert the speaker/ microphone (or headset) plugs into the charger...
Operation Manual - Page 15
Remove the battery pack from the AC outlet.
Replace the battery pack.
5 1 Plug the AC adapter cable into the jack located on the rear of the charger.
2 Plug the AC adapter into the charging ...
Operation Manual - Page 17
... the transceiver keys. ■ Key Lock with one of the following functions. ■ None
No function has been programmed. ■ Call 1
Sends the 5-tone Encode code assigned to the Call 1 key. ■ Key Lock
Press and hold this key to deactivate QT or DQT signaling. Release the key to return to...
Operation Manual - Page 20
...; The VOX Gain can be activated by your dealer, and can be turned off for specific channels by your dealer. To activate VOX and set the VOX Gain level, perform the following steps: 1 Connect the headset to the transceiver ...• The transceiver announces the VOX Gain level as you are using a supported headset.
This feature must first be adjusted from levels 1 to transmit hands-free.
Operation Manual - Page 21
...LED may flash green when receiving a QT/DQT signal which does not match the QT/DQT tone/code set up in use.
Note: Ask your transceiver. Pressing the PTT switch will cause an alert tone ... alert tone every 30 seconds and the LED indicator blinks red when the battery needs recharged or replaced. Release the PTT switch to segregate talk groups, so users only hear calls from interfering on ...
Kenwood TK-2302 Reviews
We have not received any reviews for Kenwood yet.