Lowrance EP-85R Storage Device Support and Manuals
Get Help and Manuals for this Lowrance item
View All Support Options Below
Free Lowrance EP-85R Storage Device manuals!
Problems with Lowrance EP-85R Storage Device?
Ask a Question
Free Lowrance EP-85R Storage Device manuals!
Problems with Lowrance EP-85R Storage Device?
Ask a Question
Popular Lowrance EP-85R Storage Device Manual Pages
Installation and Operation Manual - Page 1
... is pending. For free software upgrades or additional information on the LowranceNet NMEA 2000® network system, visit our web site, www.lowrance.com. Pub. 988-0154-522
EP-85R Storage Device
Electronic Sensor
Installation and Operation Instructions
This document shows how to connect an EP-85R storage device to display NMEA 2000 data correctly. The EP-85R stores Fuel Used, Trip Fuel...
Installation and Operation Manual - Page 2
... for use with your EP-85R Storage Device, "Setup and Installation of NMEA 2000 Networks, General Information," part number 988-0154-173. It can be added to a blue connector network by using a red female to a LowranceNET NMEA 2000 network. Tools and Supplies Your EP sensor packs with LowranceNet blue connector networks. For complete instructions on setting up to attach it...
Installation and Operation Manual - Page 3
... from a GPS antenna or multiple sonar units to receive messages sent by Lowrance Electronics. In similar fashion, only sensors and display units plugged into the backbone (using...To pick up a phone in .
LowranceNET is having on a phone in a house. Installation To install the EP-85R Storage Device, route the sensor's cable connector to the T on the network backbone where you the flexibility...
Installation and Operation Manual - Page 7
...Setup
If this is 5 seconds. With Boat Setup highlighted on your LMF-200 instruction manual for each additional tank. The Boat Setup menu will be directed to use the gauge or the EP-85R Storage Device....set up and press MENU, which will hold and press MENU. The default setting is the first time you to use EP-85R Storage Device with the LMF200 Multi-function gauge. To execute Boat Setup...
Installation and Operation Manual - Page 8
... to reset Eng/Tnk.
3.
Refill Tank (Refill T) Since the EP-85R is not connected to Fuel Flow:
1. The Setup screen will appear: Hit menu to default settings. The Fuel Remaining Source should be set Fuel Remaining Source to the tank, its fuel information is not automatically updated when the tank is filled up. The following options...
Installation and Operation Manual - Page 9
... must use to the main display. If your unit is set as the Fuel Remaining Source. Select the desired tank and ...you will ensure the fuel information in the EP85R stays consistent with up . You will NOT be taken back ...SETUP and press MENU.
To refill tank:
1. Partial Fill (Part Fill) Since the EP-85R is not connected to the tank, its fuel information is not automatically updated...
Installation and Operation Manual - Page 10
...Storage Device Data
You can reset to select SYSTEM SETUP and press MENU. The menu has three options: Water Spd (Water Speed), Pitot Speed and Gnd Spd (Ground Speed). Reset Trip Fuel Used (Rst trip f) The EP-85R Storage Device...appear with up to the main display. Reset Seasonal Fuel (Rst Seas) The EP-85R Storage Device keeps a running total of fuel used to zero and take you back to ...
Installation and Operation Manual - Page 13
...: After using the Reset command to clear data from EP-85R memory, you want to turn off a fuel warning, repeat Steps 1-4, then select OFF from the Level Percentage window mentioned in the storage device menu will be set to the main display. Highlight BUS DEVICES, select STRG DEV (Storage Device) and press MENU. The following message will appear...
Installation and Operation Manual - Page 15
... the EP-85R Storage Device with up , press EXIT repeatedly to return to the main display.
15
Use the UP and DOWN keys to select the engine-tank configuration that applies to your vessel. After setting the engine/tank configuration, the Tank Size menu will appear, allowing you will have been set a fuel warning or clear EP-85R Storage Device...
Installation and Operation Manual - Page 16
... fuel remaining. Refill Tank Since the EP-85R is not connected to the tank, its fuel information is not automatically updated when the tank is set to fuel flow (Eng/FFlow) if you to select the device used when the EP-65R Fluid Level is filled up to select SYSTEM SETUP and press ENTER. 2. Press MENU, use...
Installation and Operation Manual - Page 18
... of fuel used for a trip. Highlight FUEL SETUP and p ress ENTER. 3. The following message will appear.)
3. Reset Seasonal The EP-85R Storage Device keeps a running total of fuel used for display...of fuel used for a season. Once pages have been set to manually scroll pages across the screen automatically or manually. You will appear.) 4. Page Screen Rotation The Page...
Installation and Operation Manual - Page 22
... will have to clear all data stored in EP-85R memory. Press EXIT repeatedly to return to Reset Device Values. Select RESET VALUES and press ENTER. Highlight BUS DEVICES and press ENTER. Select STRG DEV (Storage Device) and press ENTER. NOTE:
After using the Reset Values command to clear EP-85R memory, you will appear: Press Enter to...
Installation and Operation Manual - Page 23
.... NOTE:
Some of the Bus Configuration menu, shows all devices connected to the network.
The Engine-Tank Configuration menu is located below the NMEA 2000 Devices list, but will perform the same functions in your display unit, but your unit. Display Unit: EP-85R Operation
This section covers how to use an EP-85R Storage Device with the EP-85R Storage Device.
Installation and Operation Manual - Page 25
..., select NMEA 2000 or NETWORKING and press ENTER. A menu will affect the way the EP-85R is shown on your storage device will be displayed on your display unit. NOTE:
Changing the Device Name only will appear with five options: Bus Setup, Fuel Management, NMEA 2000 Alarms, Waypoint Sharing and Backlight Synchronization.
25 Press EXIT repeatedly...
Installation and Operation Manual - Page 26
.... Highlight BUS SETUP and press ENTER, which will appear with the Device Name dialog box highlighted. 4. Select RESTORE DEFAULTS and press ENTER.
Select the storage device and press ENTER. The following message will be at the top of other devices on the Advanced Options menu, the Restore Defaults command allows you to reset EP-85R Storage Device settings to the...
Lowrance EP-85R Storage Device Reviews
We have not received any reviews for Lowrance yet.