Lowrance NAC-1 Autopilot Computer Support and Manuals
Get Help and Manuals for this Lowrance item
View All Support Options Below
Free Lowrance NAC-1 Autopilot Computer manuals!
Problems with Lowrance NAC-1 Autopilot Computer?
Ask a Question
Free Lowrance NAC-1 Autopilot Computer manuals!
Problems with Lowrance NAC-1 Autopilot Computer?
Ask a Question
Popular Lowrance NAC-1 Autopilot Computer Manual Pages
Addendum software release v20.2 for Zeus2 Glass Helm - Page 15
... to specify:
• Dangerous targets - AIS specific settings are : - Show -
targets further away than - Hide slower than the following target filter settings will be shown. specify the time of interest ...to hide targets that support tracking targets, the following distance will be shown. specify to "Safe ring" on radar range) or targets within a specific distance of time or...
Addendum software release v20.2 for Zeus2 Glass Helm - Page 16
... around your vessel to the system, AIS targets can be made before using the radar. Installation setup settings are described in the separate Radar or the display unit's installation manuals. The antenna height is carrying a typical load. You can set the antenna height correctly as overlay on the icon representing the position of the antenna above...
Addendum software release v20.2 for Zeus2 Glass Helm - Page 21
... available if you have your MMSI number entered to avoid seeing your system.
Ú Note: For radar specific settings, refer to be shown. ADDENDUM | Zeus Series
21 AIS SART 'tests' icons are : -
Closest ...15. Vessels and tracked targets This dialog contains settings for your own MMSI (Maritime Mobile Service Identity) number into the system. Range of approach in the selected time period....
Network Autopilot Installation and Commissioning Manual - Page 71
... 24 CHECKING THE COMPASS OFFSET 25 AUTOMATIC RUDDER GAIN 25
CHECKING THE AUTOMATIC RUDDER GAIN LEARNING __________ 26 MANUAL RUDDER GAIN 26 SETTING THE RUDDER GAIN MANUALLY 27
RUDDER GAIN VALUE TABLE 28 BOAT LAG 28 SETTING THE BOAT LAG VALUE 29
BOAT LAG VALUE TABLE 29 CALIBRATION OF DIRECT SPEED INPUT 30 POWER...
H1000 Pilot Installation Manual - Page 1
... extreme sea conditions x When in areas where use of vessel x Always switch OFF the autopilot in damage and invalidate the warranty
h1000 pilot installation
manual
HB-1000I-02 English
WARNING!
CAUTION! An autopilot is prohibited by law When using an autopilot: x Do not leave the helm unattended x Do not place any magnetic material or equipment...
Zeus Touch Install Manual - Page 30
..., etc.). 8
Video In
Connect up the video panel buttons. The settings are adjusted individually for each display unit using the Video / Data cable (optional for T7 and T8, supplied with another Zeus Touch unit via the network.
Video In | Zeus Touch installation manual This connects to the VIDEO IN port on the unit...
Zeus Touch Install Manual - Page 44
... Follow the on the compass that there is reading more significant and heading errors exceeding ±3° may have to be accepted. The calibration should move... Autopilot | Zeus Touch installation manual If another model compass from B&G or another manufacturer is installed, refer to the instruction for any interfering magnetic objects and remove them, or you want to change the set...
Zeus Touch Install Manual - Page 45
... popup, and the following abbreviations are used:
HI-A LO-A HI-M LO-M
High response parameters set automatically Low response parameters set automatically High response parameters set manually Low response parameter set manually
Autopilot | Zeus Touch installation manual | 45 Setting the Transition speed (HI/LO) This is recommended that you change from slow to HI steering parameters. On...
Network Pilot Installation Manual ACP - Page 71
... 24 CHECKING THE COMPASS OFFSET 25 AUTOMATIC RUDDER GAIN 25
CHECKING THE AUTOMATIC RUDDER GAIN LEARNING __________ 26 MANUAL RUDDER GAIN 26 SETTING THE RUDDER GAIN MANUALLY 27
RUDDER GAIN VALUE TABLE 28 BOAT LAG 28 SETTING THE BOAT LAG VALUE 29
BOAT LAG VALUE TABLE 29 CALIBRATION OF DIRECT SPEED INPUT 30 POWER...
Zeus Glass Helm Installation Manual - Page 47
...cable)
RS422 port baud rate Charting support
1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200 Embedded low detail backround +
Insight, Navionics and CMap on rear (BNC female. 7
Specifications
Mechanical/Environmental
Casing
ABS plastic
Operating ... 1 port on rear (Micro-C male, LEN = 1)
Video input
2 ports on SD card
Specifications | Zeus2 Glass Helm Installation Manual
| 45
NAIS 400 Owners Manual - Page 27
... mode is ready for use of how to make use .
Specific details of how to configure your AIS transceiver. Follow the instructions provided in the help monitor the performance of your chartplotter to...will be able to set the AIS transceiver into 'silent mode'. To use silent mode if you should use the full range of other vessels with your chartplotter manual.
When silent mode...
NSPL 400 User Manual - Page 2
...instruction manuals, user guides and other important information. Warning: Used when necessary to warn personnel that they should proceed carefully to prevent risk of injury to personnel or damage to the brand web sites: www.bandg.com www.Lowrance...install ...manual. In the event of any conflict between any further assistance. About this manual Meet the technical standards in accordance with Part...
H2000 User Manual - Page 94
... into contact with the ground it slows and changes direction.
h2000 User Manual
CAL VAL 2 Setting 0
1
Description
Default setting. The effects themselves are relatively straightforward and are minimised. if the wind...on the amount of mixing of the wind at the root of the greatest problems for an instrument system to the main processor. Differences of direction of this will...
H2000 User Manual - Page 114
...17 (-) at the Computer Unit connection block. If the sensor is a totally independent fitting (B&G part no further action is required. This value is necessary to calibrate this case no . 224-...to change the sensor selection value.
If it is found in :
114
HB-0845-06 h2000 User Manual
CAL VAL 2 Setting 0 1 2 3 4 5
Function Text Shown
AFT DPTH FWD DPTH MID DPTH PORT DEP STBD DEP...
Network Quad User Manual - Page 20
...Network WIND and Network TACK which do not have alarms. See NETWORK ALARMS at the end of this manual. Shallow Alarm • Factory set Shallow 0.5m Deep 1.0m, • (1.6/3.2ft, 0.2/.5 fathoms). • Adjustable range 0 - .... Silence the alarm by pressing any key. Anchor Alarm • Factory set to 10.0m, (32.8ft, 5.4 fathoms). • Adjustable range 0 - 180m, 0 - 590 ft...
Lowrance NAC-1 Autopilot Computer Reviews
We have not received any reviews for Lowrance yet.