Maytag MEDB850WR - 7.3 cu. Ft. Capacity Electric Dryer Support and Manuals
Get Help and Manuals for this Maytag item
View All Support Options Below
Free Maytag MEDB850WR manuals!
Problems with Maytag MEDB850WR?
Ask a Question
Free Maytag MEDB850WR manuals!
Problems with Maytag MEDB850WR?
Ask a Question
Most Recent Maytag MEDB850WR Questions
Medb850wr Will Not Get Hot
2010 Maytag steam bravo - Dryer blower runs fine, lights come on correctly. Power plug is tight, etc...
2010 Maytag steam bravo - Dryer blower runs fine, lights come on correctly. Power plug is tight, etc...
(Posted by conniewilhelmMiller 10 years ago)
Are There Documented Problems With The Blower On This Dryer?
(Posted by zulligm 10 years ago)
Maytag Med850wr Vent Fan Not Spinning Underneath.
Dryer is not drying clothes in last few weeks without extensive time. Checked the lint trap (cleaned...
Dryer is not drying clothes in last few weeks without extensive time. Checked the lint trap (cleaned...
(Posted by srognlie 11 years ago)
The Drum Doesn't Turn. Also No Display Is Showing.
(Posted by judylj31 12 years ago)
Popular Maytag MEDB850WR Manual Pages
Owners Manual - Page 3
... of this manual must be followed to minimize the risk of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54. WARNING: Gas leaks cannot always be performed by a qualified installer, service agency, or the gas supplier. IMPORTANT: The gas installation must be detected by UL or CSA. Follow the gas supplier's
instructions.
• If...
Owners Manual - Page 5
This Use and Care Guide covers several different models.
Press POWER/CANCEL. 2. To make changes to set a drying time and temperature.
1. NOTE: Dryness selections can change the settings for more detail on some models) - Press START/PAUSE. STOPPING, PAUSING, OR RESTARTING
To stop or pause your dryer at any time Open the door or press START/PAUSE. TIMED...
Owners Manual - Page 6
...) for a guide to drying various loads.
■ Drying temperature and dryness level are preset when you choose a Sensor Dry Cycle. If ...Settings
Sensor Cycles Load Type
Temperature
BULKY Jackets, comforters, pillows Rearrange the load when the Damp Dry signal sounds. This is the preferred setting;
Follow package instructions.
■ To reduce wrinkling, remove the load from the dryer...
Owners Manual - Page 7
... that coverings are not adjustable. Custom Refresh
This cycle is sprayed into the dryer drum after several minutes of tumbling with the Timed or Steam Cycles.
Steam Cycles...model) do not offer an alternate temperature. The dry time and temperature can be adjusted for this cycle, a small amount of water is best for drying clothes; Only the Medium and Regular temperature settings...
Owners Manual - Page 8
...continue to run for ease in the drying process.
When pressed during the Cool Down part of time selected, and the Wet light...setting or opening the dryer door.
■ For the Wrinkle Control cycle, the Wrinkle Prevent/Wrinkle Prevent Plus setting is available only with the drying Status indicator lights. NOTE: The Damp Dry Signal is preset to ON. See "Options."
Steam (on steam models...
Owners Manual - Page 9
... cycles are 3 drying settings: 1 (factory preset dryness level), 2 (slightly dryer clothes, approximately 15% more drying time) and 3 (much dryer clothes, approximately 30% more drying time).
1. Do not use the drying rack 1. Open dryer door.
NOTE: Do not allow items to complete drying. Close the door. 5. You must be accepted. The dryer starts at the front of the manual or contact...
Owners Manual - Page 11
...avoid unintended flooding (due to the dryer. Steam models only: Shut off the water supply to a water pressure surge) while you will not freeze. Use masking tape to faucet. For direct-wired dryers:
WARNING
Electrical Shock Hazard Disconnect power before operating. Replace all parts and panels before servicing. Disconnect wiring. 3. Special Instructions for an extended period of...
Owners Manual - Page 12
... Installation Instructions for the dryer.
Check to the wall is crushed or kinked.
Remove the screw located in dryer or reconnect power. Dryer will not run when this diagnostic code is free of the drum for 2-5 seconds. No heat
■ Has a household fuse blown, or has a circuit breaker tripped? Electric dryers use two household fuses or breakers. Replace...
Owners Manual - Page 14
... the Use & Care Guide. In the
U.S.A., call 18008076777.
6/08
Keep this information on the model and serial number label located on how to use or when it . Odors
■ Have you recently been painting, staining, or varnishing in accordance with Maytag's published installation instructions.
10. Replacement parts or repair labor if this major...
Warranty Information - Page 1
... under this information on the model and serial number label located on major appliances with the product, Maytag brand of Whirlpool Corporation or Whirlpool Canada LP (hereafter "Maytag") will need repair service, first see the "Troubleshooting" section of original purchase date is best for factory specified parts and repair labor to repair or replace appliance light bulbs, air filters...
Dimension Guide - Page 1
... considered for ease of installation and servicing.
■■ Additional clearances might be required for exhaust vent with a door, minimum ventilation openings in the top and bottom of the dryer to reduce noise transfer.
■■ For closet installation, with elbow. Electric Dryer
PRODUCT MODEL NUMBERS
MEDB200V, MEDB400V, MEDB700V, MEDB800V, MEDB850W
Dryer with Extended back view...
Installation Guide - Page 4
... 1" (25 mm), install Extended Dryer Feet Kit, Part Number 279810. Lower temperatures may not operate correctly.
■■ For a garage installation, place dryer at end of 5" (127 mm) clearance behind dryer for proper exhaust installation. Some codes limit, or do not permit, installing dryer in door are provided.
DRYER DIMENSIONS
Dryer with extended back:
Dryer with flat back...
Installation Guide - Page 12
...;■ Do not install in final dryer location. ■■ Remove excess to avoid sagging and kinking that may be connected into slot of fire, this dryer MUST BE
EXHAUSTED OUTDOORS.
Rigid metal vent: ■■ Recommended for exhausting. Dryer exhaust must not be used for best drying performance and to achieve best drying performance.
12 Connect neutral...
Installation Guide - Page 15
... Maytag Vent...ft. (17.4 m)
NOTE: Bottom exhaust installations have a 90° turn . Turn cold water off, remove and
replace rubber washer
Turn cold water faucet off and ...washer from inlet hose and replace with additional two-thirds turn inside the dryer. Then attach "Y" connector ...16.
INStall VENT SYSTEM
1. Install exhaust hood
12" min. (305 mm)
CONNECT INLET HOSES
For non-steam models, ...
Installation Guide - Page 17
...; Controls are snug against the floor.
17
This dryer automatically runs an installation diagnostic routine at the start dryer.
If you receive an L2 code, there may notice an odor when dryer is closed. NOTE: You may be crushed or blocked. If dryer is not level, prop up or down, and check again for certain part replacement or repair.
Maytag MEDB850WR Reviews
We have not received any reviews for Maytag yet.