Nady MGT-16 Support and Manuals
Get Help and Manuals for this Nady item
Nady MGT-16 Videos
Nady MGT-16 Video
Duration: 6:04
Total Views: 10,893
Duration: 6:04
Total Views: 10,893
NADY SYSTEMS: UHF V-800, MGT-16, MRX-16, W-1KU, 2W-1KU - NAMM 2012 - AudioSavings.com
Duration: 4:00
Total Views: 3,407
Duration: 4:00
Total Views: 3,407
Popular Nady MGT-16 Manual Pages
Owners Manual - Page 2
... Manual...2 System Features...3 Quick User Controls Guide...4 System Operation...7
MGT-16 Wireless Instrument Receiver 7 MT-16A/R Instrument Transmitter 9 Specifications...11 Cautions and Troubleshooting 12 Miscellaneous Tips...13 MGT-16 DIP-Switch Frequency Selection Chart 14 Accessories...14 Service Information...14 Warranty...15
Introduction
Thank you for choosing the Nady MGT-16 wireless...
Owners Manual - Page 3
...; Dual ¼ wave antennas • Infrared sync with receiver for instant setup
• Power On/Off switch; Volume Control;
Internal audio level control trim-pot
• External flexible antenna
3 System Features
MGT-16 System Features
• UHF wireless system for guitar/bass • 16 user-selectable PLL frequencies
for interference-free operation • Up to 250...
Owners Manual - Page 5
... about +4dB over a direct instrument-tocord-to achieve desired setting.
14. POWER ON LED Indicates the receiver is turned past minimum and maximum adjustment points it may need
replacement (if not using power adapter...
from the RX IR window, press the SYNC button once and wait one of 16 pre-set channels per MGT-16 DIP-Switch Frequency Selection Chart (see page 14)
5. turn off and then on...
Owners Manual - Page 6
... AUDIO LEVEL ADJUST Remove battery to achieve desired setting.
24. Note: Set control carefully. BATTERY COMPARTMENT COVER ANTENNA Permanently attached antenna
25. BATTERY Single AAA alkaline or NiMH battery required for most guitars and basses and 15dB Pad also available. Quick User Controls Guide
MT-16A/R Instrument Transmitter
MT-16R
(Straight plug)
18 17...
Owners Manual - Page 7
...installed batteries are automatically disconnected internally and are not operational.
They should be extended fully to obtain maximum range.
System Operation
IR PO LO RX OFF ON POWER
15dB PAD
14
ACT SQ
21
MGT-16 Wireless Instrument Receiver
Antennas
The MGT-16... the batteries be replaced after six hours of the antennas are now too low and should be replaced as soon as ...
Owners Manual - Page 8
...RX OFF ON POWER
LEVEL
Note: Set controls carefully.
Selecting the MGT-16 Receiver Channel and IR Sync
The... a clockwise (maximum squelch) setting will not charge NiMH rechargeable batteries if installed.
CHANNEL
ACT SQ
8
The...MGT-16 receiver by holding the wireless transmitter's IR Receptor/Sensor Window (21) about 6-12" from the receiver to the transmitter for each of the 16...
Owners Manual - Page 9
...the arrow.
To install the battery, push the locking tabs on the transmitter, slide the Power Switch (17) in the direction of these transmitters into one wireless receiver. To ...Instrument transmitter. Your MGT-16 receiver is now operational and ready to warn that the battery be replaced after turning the transmitter off and then on the receiver lights up to the following instructions...
Owners Manual - Page 10
...Manually matching the transmitter frequency without the receiver is finished, close the battery compartment door, ensuring that it may need to achieve desired setting...16A/R Instrument Transmitter
During normal operation with a hard-wired cord.
The MT-16A/R is for normal use , set to maximum... volume on the receiver (see Selecting the MGT-16 Receiver Channel and IR Sync on (or off...
Owners Manual - Page 11
Specifications
MGT-16 System Frequency Response Dynamic Range Oscillating System Total Harmonic Distortion (THD) RF Carrier Frequency Range Modulation Operating Range
MGT-16 Receiver Controls
Connectors LED Indicators
Antennas Signal-to-Noise Ratio Receiver Sensitivity Squelch Sensitivity Output Impedance Power Consumption Battery Battery Life Dimensions Weight (w/o batteries) Housing ...
Owners Manual - Page 12
...MGT-16 receiver is important to one for optimal interference-free operation, the Signal LED must cease operation or change the receiver DIP switches setting...wireless microphone operation is not protected from interference from the receiver, it can often be clear). To do this procedure every time a new channel is far from other radio services...only. Cautions and Troubleshooting
No or Low ...
Owners Manual - Page 13
... transmitter off in use "general purpose" carbon batteries. Also, since batteries installed for optimal results.
• Although placement of -sight is best.
&#... electric guitars with dirty pots or connections are used with a wireless system. Do not use . For longest life, remove the batteries... settings. When batteries are weak, replace all of the guitar's volume and tone pots-this...
Owners Manual - Page 14
...
16
923.7
1234
Accessories
Part Number AC-MGT-16
Description 10VDC/200mA AC/DC receiver power supply adapter included
Service Information...instructions in your wireless system require service, please contact the Nady Service Department at www.nady.com for assistance.
Ship your unit is clearly marked on the outside of the problem you are returning.
Outside the U.S. MGT-16...
Owners Manual - Page 15
... parts; This warranty gives you specific legal rights and you at the buyer's expense.
15 The warranty is required, please contact our Service ...Nady dealer, agent, or employee is authorized to assume for repair or replacement.
will inform the buyer if product sent in lieu of sale) or Nady cannot be made against the shipping company by Nady will perform all warranty service...
Nady MGT-16 Reviews
We have not received any reviews for Nady yet.