Owners Manual
Page 1
POWERED MIXERS OWNER'S MANUAL PMX SERIES PMX-600 - 6 Channel Powered Mixer w/DSP Effects PMX-1600 -16 Channel Powered Mixer w/DSP Effects
POWERED MIXERS OWNER'S MANUAL PMX SERIES PMX-600 - 6 Channel Powered Mixer w/DSP Effects PMX-1600 -16 Channel Powered Mixer w/DSP Effects
Owners Manual
Page 2
... any other powered mixer in 32-bit DSP Echo Effects emulates plate, gate, room, hall, stadium reverbs and delays • 60 mm faders on the market today. Master Echo Effects Section 7 3. Tape/CD In and Record Out stereo RCA jacks with Tape level control; 10-segment LED display bargraph meters with balanced XLR Mic and 1/4" TRS line inputs, Trim controls, Peak LED's, Selectable Low Cut filters; Please read this manual carefully to main enable switch •...
... any other powered mixer in 32-bit DSP Echo Effects emulates plate, gate, room, hall, stadium reverbs and delays • 60 mm faders on the market today. Master Echo Effects Section 7 3. Tape/CD In and Record Out stereo RCA jacks with Tape level control; 10-segment LED display bargraph meters with balanced XLR Mic and 1/4" TRS line inputs, Trim controls, Peak LED's, Selectable Low Cut filters; Please read this manual carefully to main enable switch •...
Owners Manual
Page 3
... taken so that could cause permanent hearing loss. B. The product should be serviced by qualified service personnel if: A. The power supply cord or the plug has been damaged. C. The power supply cord should be used for a long period of time at a high volume level or at a level that is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure...
... taken so that could cause permanent hearing loss. B. The product should be serviced by qualified service personnel if: A. The power supply cord or the plug has been damaged. C. The power supply cord should be used for a long period of time at a high volume level or at a level that is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure...
Owners Manual
Page 4
... can become very warm during operation. Care should be taken to protect the units in question, it to power sources. In new installations and portable sound systems, or any signs of physical damage that there is damaged, do not place the PMX Series powered mixer on the rear panel Power On/Off Switch (38). Set the Channel (13), Group (22), and Master Stereo Volume Faders (24) to minimum to...
... can become very warm during operation. Care should be taken to protect the units in question, it to power sources. In new installations and portable sound systems, or any signs of physical damage that there is damaged, do not place the PMX Series powered mixer on the rear panel Power On/Off Switch (38). Set the Channel (13), Group (22), and Master Stereo Volume Faders (24) to minimum to...
Owners Manual
Page 5
... equalization to the line input, then a 1/4" TRS (stereo) phone plug should be wired for that can be necessary to adjust the channel gain with insert jacks to connect external signal processors such as compressors, noise reduction systems, or effects devices to ground, as a direct output, insert a 1/4" phone plug halfway into the Insert jack so the tip of microphones. If a balanced signal is normally applied across an entire signal. Here an Aux Send would be connected at the...
... equalization to the line input, then a 1/4" TRS (stereo) phone plug should be wired for that can be necessary to adjust the channel gain with insert jacks to connect external signal processors such as compressors, noise reduction systems, or effects devices to ground, as a direct output, insert a 1/4" phone plug halfway into the Insert jack so the tip of microphones. If a balanced signal is normally applied across an entire signal. Here an Aux Send would be connected at the...
Owners Manual
Page 6
... when all monitoring purposes: for example, for example, to combine the outputs of signal sent to the Aux Send 2 or the internal DSP Echo Effects. (6) LOW CUT FILTER Use this Aux 2 send to avoid excess. On the other unbalanced line level application. High, Mid and Low controls. During rehearsals, experiment with the equalizer controls on the input channels will light just before clipping to the Master Stereo Volume Faders (24) by enabling the Group To Main Switch (23...
... when all monitoring purposes: for example, for example, to combine the outputs of signal sent to the Aux Send 2 or the internal DSP Echo Effects. (6) LOW CUT FILTER Use this Aux 2 send to avoid excess. On the other unbalanced line level application. High, Mid and Low controls. During rehearsals, experiment with the equalizer controls on the input channels will light just before clipping to the Master Stereo Volume Faders (24) by enabling the Group To Main Switch (23...
Owners Manual
Page 7
... Echo Effects DSP (Digital Sound Processor). This will disable the internal Echo Effects. Turning the control clockwise sets the repeats to 200mS delays. MASTER CONTROL AND EQ SECTION (21) DUAL CHANNEL GRAPHIC EQUALIZER The 7-band graphic equalizers allow you to adjust the frequency response of the Master L and R mix providing a maximum of +/12dB of the internal Echo Effects, Aux Send 2 should be used and the Aux 2 / Effects Enable Switch (15) should be used for stadium reverbs and delay sounds with...
... Echo Effects DSP (Digital Sound Processor). This will disable the internal Echo Effects. Turning the control clockwise sets the repeats to 200mS delays. MASTER CONTROL AND EQ SECTION (21) DUAL CHANNEL GRAPHIC EQUALIZER The 7-band graphic equalizers allow you to adjust the frequency response of the Master L and R mix providing a maximum of +/12dB of the internal Echo Effects, Aux Send 2 should be used and the Aux 2 / Effects Enable Switch (15) should be used for stadium reverbs and delay sounds with...
Owners Manual
Page 8
... faders, which signal is depressed to monitor either the Master or Group mix. The input signals can cause damage to your speakers and even the internal amplifier. (26) POWER LED This LED will illuminate when the switch is sent to the Master/Main busses. The Record Output RCA jacks provide a stereo signal output to be used effectively. This submix can be added to the Main/Master mix by the Aux Send 1 & 2 Level Controls (14). (31) AUX RETURN 1 & 2 INPUTS These mono unbalanced 1/4" jacks enable convenient inputs...
... faders, which signal is depressed to monitor either the Master or Group mix. The input signals can cause damage to your speakers and even the internal amplifier. (26) POWER LED This LED will illuminate when the switch is sent to the Master/Main busses. The Record Output RCA jacks provide a stereo signal output to be used effectively. This submix can be added to the Main/Master mix by the Aux Send 1 & 2 Level Controls (14). (31) AUX RETURN 1 & 2 INPUTS These mono unbalanced 1/4" jacks enable convenient inputs...
Owners Manual
Page 9
... 1/4" speaker output jacks are paralleled together for the Master Right output signal and can deliver up to 200W RMS to a 4Ω load. [Caution: Never use less than 4Ω Total impedance for 230VAC. (41) AC VOLTAGE SELECTOR SWITCH Before plugging in the power cord, check to a 4Ω load. • LEFT - CONTROLS AND CONNECTIONS (38) (40) (39) (41) (37) 5. The PMX Series powered mixer uses 20mm glass tube Fast Blow fuses...
... 1/4" speaker output jacks are paralleled together for the Master Right output signal and can deliver up to 200W RMS to a 4Ω load. [Caution: Never use less than 4Ω Total impedance for 230VAC. (41) AC VOLTAGE SELECTOR SWITCH Before plugging in the power cord, check to a 4Ω load. • LEFT - CONTROLS AND CONNECTIONS (38) (40) (39) (41) (37) 5. The PMX Series powered mixer uses 20mm glass tube Fast Blow fuses...
Owners Manual
Page 10
CONNECTIONS 8Ω 8Ω 8Ω 8Ω OR USE SEPARATE CABLE MONITOR SPEAKERS & POWER AMP REVERB PA or RECORDING DEVICE EFX TAPE/DISK RECORDER 10
CONNECTIONS 8Ω 8Ω 8Ω 8Ω OR USE SEPARATE CABLE MONITOR SPEAKERS & POWER AMP REVERB PA or RECORDING DEVICE EFX TAPE/DISK RECORDER 10
Owners Manual
Page 11
... BALANCED MONO CHANNEL LINE 1/4" UNBALANCED 1/4" TRS BALANCED AUX RETURN 1/4" UNBALANCED TAPE IN STEREO RCA JACKS INSERT INPUT 1/4" UNBALANCED With Trim, Tape In, and Aux Return Level controls set to Mid (50%) *With Trim set to +10dB, 60mm sliders 3. GENERAL Power Requirements ...Voltage selectable, 115VAC/60Hz or 230VAC /50Hz Fuse Requirements ...5x20mm glass tube F.B. 8A 250V @ 115VAC 4A 250V @ 230VAC PMX-1600 Weight ...35.25 lbs. (16 Kg) Dimensions...
... BALANCED MONO CHANNEL LINE 1/4" UNBALANCED 1/4" TRS BALANCED AUX RETURN 1/4" UNBALANCED TAPE IN STEREO RCA JACKS INSERT INPUT 1/4" UNBALANCED With Trim, Tape In, and Aux Return Level controls set to Mid (50%) *With Trim set to +10dB, 60mm sliders 3. GENERAL Power Requirements ...Voltage selectable, 115VAC/60Hz or 230VAC /50Hz Fuse Requirements ...5x20mm glass tube F.B. 8A 250V @ 115VAC 4A 250V @ 230VAC PMX-1600 Weight ...35.25 lbs. (16 Kg) Dimensions...
Owners Manual
Page 12
DO NOT ATTEMPT TO SERVICE THIS UNIT YOURSELF AS IT CAN BE DANGEROUS AND WILL ALSO VOID THE WARRANTY. NADY SYSTEMS, INC. • 6701 SHELLMOUND STREET, EMERYVILLE, CA 94608 Tel: 510.652.2411 • Fax: 510.652.5075 • nady.com SERVICE FOR YOUR NADY AUDIO PRODUCT (U.S.) Should your NADY AUDIO product require service, please contact the Nady Service Department via telephone at (510) 652-2411, or e-mail at service@nady.com. (International) For service, please contact the NADY AUDIO distributor in your country through the dealer from whom you purchased this product.
DO NOT ATTEMPT TO SERVICE THIS UNIT YOURSELF AS IT CAN BE DANGEROUS AND WILL ALSO VOID THE WARRANTY. NADY SYSTEMS, INC. • 6701 SHELLMOUND STREET, EMERYVILLE, CA 94608 Tel: 510.652.2411 • Fax: 510.652.5075 • nady.com SERVICE FOR YOUR NADY AUDIO PRODUCT (U.S.) Should your NADY AUDIO product require service, please contact the Nady Service Department via telephone at (510) 652-2411, or e-mail at service@nady.com. (International) For service, please contact the NADY AUDIO distributor in your country through the dealer from whom you purchased this product.