Netgear GSM7328S-200NAS Support and Manuals

Get Help and Manuals for this Netgear item

View All Support Options Below
Free Netgear GSM7328S-200NAS manuals!
Problems with Netgear GSM7328S-200NAS?

Ask a Question

Popular Netgear GSM7328S-200NAS Manual Pages

User Guide - Page 1

... conditions: This device may be determined by turning the equipment off and on a circuit different from that the NETGEAR Model GSM7328S ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch is subject to the notes in a particular installation. Consult the dealer or an experienced radio/TV technician for help. EN 55 022 Declaration of Conformance This is...
User Guide - Page 2

... with questions or problems following installation: • Check the NETGEAR Web page at http://www.NETGEAR.com. • Call Technical Support in North America at support@NETGEAR.com. Page 2 of Communications. Règlement sur le brouillage radioélectrique du ministère des Communications Cet appareil numérique (NETGEAR Model GSM7328S ProSafe 24+4 Gigabit Ethernet L3 Managed...
User Guide - Page 6

...-sensing 10/100/1000 ports. For a detailed description of the management features in getting your purchase of each other with your switch. It is 328 feet (100 meters) over Category 5 unshielded twisted-pair (UTP) cable. This Installation Guide will accept any standard SFP module. or full-duplex mode, increasing the maximum bandwidth of a NETGEAR Model GSM7328S ProSafe 24+4 Gigabit...
User Guide - Page 7

... identifies the key features of the NETGEAR Model GSM7328S ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch. • Twenty-four 10/100/1000 Mbps auto sensing Gigabit Ethernet TP ports • Four SFP module combo ports for a variety of fiber connections • Four I/O module bays can be used with the AX742 24 Gigabit Stacking Module to allow up to 8 switches to...
User Guide - Page 10

... RJ-45 ports support Auto Uplink. or full-duplex) of the NETGEAR Model GSM7328S ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch The front panel contains LEDs, RJ-45 jacks, SFP module bays, and a console port. Topics include: Front and back panels 10/100/1000 Mbps auto-sensing RJ-45 ports SFP module ports 10 Gigabit Ethernet / 24 Gigabit Stacking I/O module bays LED...
User Guide - Page 11

... four ports (21(21F),22(22F),23(23F),24(24F)) on GSM7328S can be used for either standards-based 10-Gigabit Ethernet or special 24-Gigabit Stacking connectivity. If the stacking functionality is IEEE 802.3z compliant. 10 Gigabit Ethernet / 24 Gigabit Stacking I/O module bays The high speed I /O modules can connect up to 8 switches to enable communications with a single...
User Guide - Page 13

...Console Port" in Chapter 3 Installation. This port is labeled ... the following settings: • Baud rate: 9,600 bps ...Manual located on the front panel. It also lets you can manage the switch using the null-modem cable supplied with your switch. The console port is required for initial management configuration of 24 Console Port Your NETGEAR Model GSM7328S ProSafe 24+4 Gigabit...
User Guide - Page 14

... for the switch is shown in Appendix C. Power specifications for your NETGEAR Model GSM7328S ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch. Install the switch in a position that is not controlled by a wall switch, which can accidentally turn off power to RPS Modules Step 1: Preparing the Site Before you access the front panel RJ-45 ports, view the...
User Guide - Page 16

...this procedure. Note: Ethernet specifications limit the cable length between the switch and the attached device to make these connections. Step 6: Installing a SFP Module The following procedure to attach devices using either straight-through or crossover cables. If you to apply AC power. 1. Step 4: Applying AC Power NETGEAR Model GSM7328S ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable...
User Guide - Page 19

... VLAN, please follow the instructions found in the above uses "192.168.1.100" as IP address, and "192.168.1.1" as gateway IP address. The switches will automatically select a master unit. You should provide your switch, note the IP address on the Sysinfo page. Figure 3-5. Connecting the stacking modules Step 9: Setup 10 Gigabit Ethernet Connections To set up...
User Guide - Page 20

... the RPS to RPS System Your NETGEAR Model GSM7328S ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch has a redundant power supply connector in case the primary power supply does. Figure 3-6. Connecting the RPS Page 20 of the additional I/O module bays can be used with an AX741 to support more than two 10 Gigabit Ethernet connections, then any of 24...
User Guide - Page 21

... (LACP) IGMP v1, v2 Snooping Support Layer 3 Services VLAN routing Port routing RIP v1/v2 OSPF v2 VRRP ACL ...support SNMP v1, v2c, v3 RFC1757 RMON 1 groups 1,2,3, and 9 RFC1213 MIB II RFC1643 Ethernet Interface MIB RFC1493 Bridge MIB RFC2131 DHCP client (& BootP) RFC2138 RADIUS client Broadcast storm control Telnet sessions for the NETGEAR Model GSM7328S ProSafe 24+4 Gigabit...
User Guide - Page 24

.... Verify that the plug is flashing continuously on the switch and the connected device are correct and comply with Ethernet specifications. APPENDIX B: TROUBLESHOOTING This chapter provides information about troubleshooting the NETGEAR Model GSM7328S Layer 3 Managed Stackable Fast Ethernet Switch. A network loop (redundant path) has been created (see Figure 2-3). Page 24 of 24 One...
User Guide - Page 25

... are outside of the installation do not exceed the Ethernet limitations. Page 25 of the link supports auto negotiation. In North America, call 1-888-NETGEAR. To reset the switch, use the Tools> Reset command or remove AC power from the switch and then reapply AC power. The gigabit port on the Gigabit module negotiates speed, duplex...
User Guide - Page 26

... This appendix provides the default settings for the NETGEAR Model GSM7328S ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch. Feature Port Speed Port Duplex Flow Control (half duplex) Flow Control (full duplex) Broadcast Storm Control Gigabit port type Management IP Configuration Password protection User Name Password Web Access Java Mode VLAN IP Multicast Filtering Spanning Tree...

Netgear GSM7328S-200NAS Reviews

Do you have an experience with the Netgear GSM7328S-200NAS that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Netgear yet.

Popular Netgear GSM7328S-200NAS Search Terms

The following terms are frequently used to search for Netgear GSM7328S-200NAS support:

Ask a New Question
Use the box below to post a new question about Netgear GSM7328S-200NAS.
Manuals / Documents
Download any of our Netgear GSM7328S-200NAS manuals for free!

We have the following 1 documents available for the Netgear GSM7328S-200NAS:
  • User Guide

Points & Prizes
  • You can earn points for nearly everything you do on HelpOwl.com
  • You can trade in those points for gift cards at leading retailers such as Amazon.com and Walmart
  • It's that simple!
See How it Works
Create a Free Account

Netgear Manuals

Find free Netgear GSM7328S-200NAS manuals and user guides available at ManualOwl.com. Try out our unique manual viewer allowing you to interact with manuals from directly within your browser!

Netgear Reviews

View thousands of Netgear GSM7328S-200NAS user reviews and customer ratings available at ReviewOwl.com.

Contact Information

Complete Netgear customer service contact information including steps to reach representatives, hours of operation, customer support links and more from ContactHelp.com.

Scoreboard Ratings

See detailed Netgear customer service rankings, employee comments and much more from our sister site.

Netgear Recalls

Find comprehensive Netgear recall information updated hourly on RecallOwl.com.