Poulan P54ZX Support and Manuals
Get Help and Manuals for this Poulan item
View All Support Options Below
Free Poulan P54ZX manuals!
Problems with Poulan P54ZX?
Ask a Question
Free Poulan P54ZX manuals!
Problems with Poulan P54ZX?
Ask a Question
Popular Poulan P54ZX Manual Pages
Owner Manual - Page 2
...manual. Certificates can be placed based on the engine and/or in the engine compartment stating that no longer used, return it to cause cancer and birth defects or other parts... other reproductive harm. To implement improvements, specifications and designs can also be under the influence... for repairs. Failure to the unit without prior notification. WARNING! Do not modify or install non...
Owner Manual - Page 9
... .
• The blades are properly tightened and torqued.
• Maintain or replace safety and instruction labels as on a water heater or other debris buildup. Replace gas cap and tighten ... adjustments or repairs with a safety device that the equipment is a risk for the mower deck's drive belt is an open vessel.
9 Gasoline is spilled on clothing, change the settings of governors...
Owner Manual - Page 10
... working with this machine, do not use approved repair parts for loading machine into a truck or trailer using... ramps for the machine.
• The mulch blades must be used on public roadways.
• ... doctor immediately.
• Be careful when servicing the battery. Explosive gases form in familiar areas...driving up ramps of the deck. Only use more distance to avoid jack-knifing.
Owner Manual - Page 11
....
5
6 7
8 9 10 11 12 13
14
4
3 2
1. Ignition switch 10. Motion control levers 2. Fuel tank 8. Choke control 12. CONTROLS
This operator manual describes the PoulanPro Zero Turn Rider. Deck lift
11 Fuse 5. Seat adjustment lever 14. Bypass Linkages
1
6. Blade switch 9. Park brake 3. Transmission from the engine is made via belt-driven hydraulic pumps. Throttle control
11.
Owner Manual - Page 13
.... Seat Adjustment Lever
To engage the mower deck blades, pull the knob up .
To service the engine and mower, see the Service Journal of hours the engine has run and indicates when the engine and mower need servicing. Blade Switch
The service meter displays the total number of this manual.
On models equipped with headlights, turn the key off...
Owner Manual - Page 17
... and then release the button.
4. Disengage the mower blades by moving the lever
downward. Set the engine speed with an operator presence system. Push the release button on the cutting height lever, move lever to the locked (transport) position.
6. Engage the mower deck by pulling the blade switch up .
7. WARNING! Allow the engine to...
Owner Manual - Page 18
... the average lawn to the center of the deck. The total time taken is necessary, pull drive levers into the neutral position and push outward. The mowing result is standing still, activate the park brake by mowing often. Operating on Hills Read the Safety Instructions Driving on hills.
• If stopping is not increased...
Owner Manual - Page 20
...machine in this manual, visit an authorized service workshop. An annual service
carried out by authorized service workshop.
4) If equipped.
WARNING! When operating with a heavy load or at high ambient temperatures, replace at 50 hour intervals.
2) In dusty conditions, cleaning and replacement are required more frequently.
3) Performed by an authorized service workshop is a list of safe...
Owner Manual - Page 21
...service 3)
♦
■ ●
● ●
♦
■
■ ■ ■
♦
1) First change after 8-10 hours. IMPORTANT INFORMATION The mower is equipped with a heavy load or at high ambient temperatures, replace...50 100 300
CHECK
Throttle cable for adjustment Mower deck for adjustment Condition of belts, belt pulleys Caster wheels (at the same time. Always...
Owner Manual - Page 23
... belt will result in usual operation.
Remove the blade bolt by attempting to start the engine when one of operation.
Lower the deck into the neutral position, otherwise the engine will stop.
For park brake adjustments, contact the PoulanPro service workshop. Install and tighten the blade bolt securely.
4.
Apply park brake.
2.
Torque blade bolt to drive, the driver must...
Owner Manual - Page 24
...) position. Raise the deck to the correct pressure. Measure from the deck. Deck Belt Installation
NOTE: For ease in the rear. Tighten the belt guide and replace belt shields on both measurements ....
24 The deck must be adjusted slightly higher in installing the deck belt, refer to the bottom of the blade tip on the front suspension linkage. If the front blade tip does not...
Owner Manual - Page 27
...openings in the belt shields.
Let the...deck completely. If a grease gun without rubber hose is maintenance free with a grease gun on each set of wheel bearings. To prevent burns, the engine should be removed to cool slightly so the engine is located close to fully drain from the engine.
6.
Replace...to the engine owner's manual for the correct replacement oil and filter change ...
Parts Manual - Page 2
When you need spare parts or support in U.S.A.
The plate states:
• The engine's model.
• The engine's type.
• Code Please have a barcode decal affixed at the rear.
Orangeburg, SC. The wheel motors and hydrostatic pumps have these available when ordering spare parts. Accessories
Collection System 966 72 12-01 Mulch Kit 531 30 96...
Parts Manual - Page 19
QTY. QTY. MOWER DECK / CUTTING DECK
ITEM PART NO. DESCRIPTION
27.. 585 32 28-05 1 PLATE, SIDE 28.. 874 78 07-40 1 BOLT 7/16-...532 18 76-90 3 WASHER/SPACER
19 DESCRIPTION
1.. 522 52 70-06 1 DECK 2.. 539 11 45-57 1 V-BELT 3.. 532 18 72-56 3 BLADE, BAGGING 4.. 532 18 72-97 1 BELT SHIELD, LT 5.. 532 18 81-87 1 BELT SHIELD, RT 6.. 532 18 72-92 3 HOUSING ASSY, CUTTER 7.. 532 13...
Parts Manual - Page 23
...-01 2 DECAL, BLADE WARNING 8.. 539 11 57-17 1 DECAL, DEFLECTOR
ITEM PART NO. QTY. DESCRIPTION
9.. 587 60 91-01 1 DECAL, PARK BRAKE 10.. 587 60 88-01 1 DECAL, HEIGHT 11.. 587 60 89-01 2 DECAL, TRACKING 12.. 587 60 95-01 2 DECAL, POULAN, FRT 13.. 587 61 24-01 1 DECAL, P54ZX 14.. 539 11...
Poulan P54ZX Reviews
We have not received any reviews for Poulan yet.