Snapper M1227E Support and Manuals
Get Help and Manuals for this Snapper item
View All Support Options Below
Free Snapper M1227E manuals!
Problems with Snapper M1227E?
Ask a Question
Free Snapper M1227E manuals!
Problems with Snapper M1227E?
Ask a Question
Popular Snapper M1227E Manual Pages
Operater's Manual - Page 4
...61623; If engine floods, set choke (if equipped) to OPEN/RUN position, move throttle
(if equipped) to be...instructions for the equipment. WARNING indicates a hazard which , if not avoided, will be damaged beyond repair and will power, it is labeled in accordance with SAE J1995 (Revision 2002--05).
For replacement parts or technical assistance, record below the engine model, type, and code...
Operater's Manual - Page 5
...for spark: Use approved spark plug tester. Do not check for the exhaust system installed on any forest-covered, brush-covered, or grass-covered land unless the exhaust system...Use only correct tools. Do not tamper with a spark arrester, as defined in Section 4442, maintained in the same
position as , but not limited to increase engine
speed. Replacement parts...
Operater's Manual - Page 6
... starting .
** Above 80°F (27°C) the use , see the Specifications section) fo tio Oil Recommendations
We recommend the use special additives. See Storage. To remain emissions compliant, high altitude adjustment is EM (Engine Modifications). Safety Key (optional) *
M. Snow Hood
How To Add Fuel - See the equipment manual for cracks or leaks. o u Outdoor temperatures determine...
Operater's Manual - Page 7
... position.
Emissions Control
Maintenance, replacement, or repair of remote controls. 1. Other parts may not perform as the original parts. Note: If the engine does not start -up can cause severe burns or death.
Do not choke the carburetor to increase engine
speed. Replacement parts must be performed by the manufacturer or its service agent or a similarly...
Operater's Manual - Page 8
... gasoline from lack of the equipment on this engine. The use this speed.
3.
DO NOT use of California Public Resource Code, Section 4442, to instructions. See How To Access The Spark Plug. the top speed at the factory to operate efficiently under most conditions.
Before installation of the snow hood to suppress ignition
signals. After adding oil, wait...
Operater's Manual - Page 9
..., 210000)
793541
n We recommend that you see any Briggs & Stratton Authorized Dealer for all maintenance and service of the engine and engine parts. en
9
The engine will operate satisfactorily at an o angle up Specifications *
Model
120000, 150000
Model
200000, 210000
Spark Plug Gap
0.030 in (0.76 mm)
Spark Plug Gap
0.030 in (0.76 mm)
r n Spark...
Operater's Manual - Page 10
... use " means all mechanical devices, need periodic parts service and replacement to the Authorized Service Dealer for warranty service may
e not be mounted. At recommended intervals, clean and/or replace the filter as stated in material or workmanship or both. Clean engine debris at time of publication. This warranty is defective in the Operator's Manual.
7 Parts damaged by over -speeding...
Operater's Manual - Page 11
...parts caused by the owner will repair your owner's manual. Owner's Warranty Responsibilities:
As the engine/equipment owner, you retain all receipts covering maintenance on or modified parts by the use of a warranted part...are specific provisions relative to the first scheduled replacement, the part will be emissions compliant for which the engine has been shown to the owner....
Snapper M1227E Reviews
We have not received any reviews for Snapper yet.