Tripp Lite PDU330AT6L21 Support and Manuals
Get Help and Manuals for this Tripp Lite item
This item is in your list!
View All Support Options Below
Free Tripp Lite PDU330AT6L21 manuals!
Problems with Tripp Lite PDU330AT6L21?
Ask a Question
Free Tripp Lite PDU330AT6L21 manuals!
Problems with Tripp Lite PDU330AT6L21?
Ask a Question
Popular Tripp Lite PDU330AT6L21 Manual Pages
Owner's Manual for 3-Phase 1U Monitored Rack PDU with Automatic Transfer Switch (ATS) 933363 (Multi-language) - Page 1
... Service
22
5 8. Register your product for quicker service...support
Copyright © 2015 Tripp Lite. Owner's Manual
PDU330AT6L15, PDU330AT6L21
(Series Number: AG-00D5)
3-Phase 1U Monitored Rack PDU with Automatic Transfer Switch (ATS)
PDU3VD351
(Series Number: AG-00C2)
PDU3V20D354, PDU3V20D354A, PDU3V20D354B
(Series Number: AG-013C)
3-Phase Vertical Power Strip
1. Important Safety Instructions...
Owner's Manual for 3-Phase 1U Monitored Rack PDU with Automatic Transfer Switch (ATS) 933363 (Multi-language) - Page 2
...Instructions
SAVE THESE INSTRUCTIONS
This manual contains instructions...or attempt to open any models that are no user-serviceable parts inside.
• Do ...part of the life support equipment or to cause the failure of the Automatic Transfer Switch or Power Strip housing. There are permanently installed... protection for the installation, in accordance with your local building codes and that is...
Owner's Manual for 3-Phase 1U Monitored Rack PDU with Automatic Transfer Switch (ATS) 933363 (Multi-language) - Page 3
...into place.
Installation
2.1 Mounting the Automatic Transfer Switch (ATS)
Important: The ATS should be installed onto the rack rails in the lowest U space available (height < 36 in this manual are for ...4 3
6/29/2015 9:08:01 AM Then push the rear
bracket toward the
enclosure support for your application, contact the manufacturer of your equipment in slide rail assembly consists of ...
Owner's Manual for 3-Phase 1U Monitored Rack PDU with Automatic Transfer Switch (ATS) 933363 (Multi-language) - Page 4
... the Power Strip
Note: Mounting buttons come pre-installed to the ATS
The power strip has a 7 conductor cord with the rack mounting slots and slide the Power Strip downward into position. 2. A second set of the unit.
15-05-226-933363.indb 4
Your model may differ slightly from image.
4
6/29/2015 9:08:02 AM...
Owner's Manual for 3-Phase 1U Monitored Rack PDU with Automatic Transfer Switch (ATS) 933363 (Multi-language) - Page 5
...instructions below assume Source A is printed on a label and attached to Power Strip
Do not exceed the load rating of the ATS via DHCP server (dynamic) or static (manual... A to www.tripplite.com/support and typing SNMPWEBCARD into the ... your network administrator for instructions on the digital meter.
... preferred 3-Phase AC power source. Installation
2.4 Connecting the ATS
2.4.1 Connect ...
Owner's Manual for 3-Phase 1U Monitored Rack PDU with Automatic Transfer Switch (ATS) 933363 (Multi-language) - Page 6
... the ATS.
6
15-05-226-933363.indb 6
6/29/2015 9:08:07 AM Features
Power Strip (PDU3VD351 , PDU3V20D354, PDU3V20D354A, PDU3V20D354B)
2 11
1
ATS Automatic Transfer Switch (PDU330AT6L15/PDU330AT6L21)
4
11
10
5
89
3
12
76
1 Power Strip Outlets: These single-phase IEC C13 and C19 outlets receive power from the interlaced 3-phase power input connections...
Owner's Manual for 3-Phase 1U Monitored Rack PDU with Automatic Transfer Switch (ATS) 933363 (Multi-language) - Page 7
...
Flashing Amber Error - Features
3 ATS Source A and Source B Input: The cords are permanently attached to order a replacement cable, contact Tripp Lite Customer Support at www.tripplite.com/support.
8 IEC...thermal breakers to connect equipment that phase, the circuit breaker will not erase network settings or interrupt AC power. Use a paper clip or other information. It contributes ...
Owner's Manual for 3-Phase 1U Monitored Rack PDU with Automatic Transfer Switch (ATS) 933363 (Multi-language) - Page 9
... for Source A.
The reset button is selected: Source Input Phase (A# or b#), % Unbalanced (Ub), Output Circuits (C#), Total Output Power (OP), Temperature (tC or tF), or Fault Code (FC). 4. They include phase current (B), Voltage (V) and Frequency (Hz).
% Unbalanced (Ub): The display shows the unbalanced load percentage deviance from the average measured value. Fault...
Owner's Manual for 3-Phase 1U Monitored Rack PDU with Automatic Transfer Switch (ATS) 933363 (Multi-language) - Page 11
... (L1-L2)
6.0 A i
Note: Since this is outlined below. Press and hold MODE button for 2 seconds to show the IP address of the menus is a 208V model, voltages displayed are phase-to Navigating Config Menus and Submenus section). The scrolling pattern of the connected SNMP card. 5.
Owner's Manual for 3-Phase 1U Monitored Rack PDU with Automatic Transfer Switch (ATS) 933363 (Multi-language) - Page 17
...Note: This display supports IPv4 AND IPv6 addresses. The 2 digit display to the Fault Menu but Auto Scroll feature will remain active within the fault code menu while a fault...
Breaker 2 Tripped
F C
Breaker 3 Tripped
F C
IP Address Display
At any time you must manually scroll through the tripped breakers (Only tripped breakers will show "IP". The display will automatically transition back...
Owner's Manual for 3-Phase 1U Monitored Rack PDU with Automatic Transfer Switch (ATS) 933363 (Multi-language) - Page 18
... function is disabled. 5. "n" indicates that it is enabled; Note: If both sources are available, the unit will transfer to the preferred source immediately once the setting is a 10 second timeout and auto scroll will resume from the current menu.
18
15-05-226-933363.indb 18
6/29/2015 9:08:14 AM...
Owner's Manual for 3-Phase 1U Monitored Rack PDU with Automatic Transfer Switch (ATS) 933363 (Multi-language) - Page 20
...
The Automatic Transfer Switch function provides increased availability when the Source A and Source B inputs of the ATS are matching with pure sine wave output for instructions on changing the preferred source).
The default preferred source is Source A (Refer to power sources, the ATS operates as an Automatic Transfer Switch, providing redundant...
Owner's Manual for 3-Phase 1U Monitored Rack PDU with Automatic Transfer Switch (ATS) 933363 (Multi-language) - Page 21
...Range
Input Voltage Ranges 208V 163V
172-241V 144-171V
0-143V
6.1.3 Quick Test
After installing the ATS/power strip and connecting equipment, you may lose power. The automatic transfer switch... source, the unit will select the preferred source according to the preferred source selection setting (Refer to that the equipment may test the Automatic Transfer Switch function by detaching power...
Owner's Manual for 3-Phase 1U Monitored Rack PDU with Automatic Transfer Switch (ATS) 933363 (Multi-language) - Page 22
... this manual to jurisdiction). If the problem requires service, visit www.tripplite.com/support and click the Request Return (RMA) link. This simple on how long an implied warranty lasts, and some states do not allow limitations on -line form will repair or replace the product, in this manual. Before returning your product for your unit's model and...
Owner's Manual for 3-Phase 1U Monitored Rack PDU with Automatic Transfer Switch (ATS) 933363 (Multi-language) - Page 23
...device complies with the instruction manual, may cause undesired... USA • www.tripplite.com/support 23
15-05-226-933363.indb ...part 15 of this product. The series number can radiate radio frequency energy and, if not installed...accordance with part 15 of continuous improvement. Specifications are designed...with the marketing name or model number of regulatory compliance certifications...
Tripp Lite PDU330AT6L21 Reviews
Do you have an experience with the Tripp Lite PDU330AT6L21 that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Tripp Lite yet.
Earn 750 points for your review!