Waring CB15TSF Support and Manuals
Get Help and Manuals for this Waring item
View All Support Options Below
Free Waring CB15TSF manuals!
Problems with Waring CB15TSF?
Ask a Question
Free Waring CB15TSF manuals!
Problems with Waring CB15TSF?
Ask a Question
Popular Waring CB15TSF Manual Pages
Instruction Manual - Page 1
...
MÉLANGEURS DE 4 L AVEC ROBINET
120V
CB15 SERIES SERIE CB15 SÉRIE CB15
For your safety and continued enjoyment of this product, always read the instruction book carefully before using.
Instruction Manual - Page 2
... authorized service facility...Instructions, page 12.
13. Avoid contact with cover in place.
12. IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be used only when the blender is not intended for examination, repair... 2 Always operate blender with moving parts.
5. Do not use , before putting on or taking off parts, and before turning on the blender...
Instruction Manual - Page 3
... jar or any blending container. Do not run the spigot through the dishwasher.
19. models only) • Base: Die-cast -
grey coating • Container: Stainless steel...8226; Cord: 7 foot (2.44 m) - 3-conductor ground cord with stainless steel blades - SAVE THESE INSTRUCTIONS
SPECIFICATIONS
• Capacity: 4 Litre Working Capacity • Rating: 120 Volts-60HZ-Single Phase AC -15.0 ...
Instruction Manual - Page 5
Metal Clamps 4. O-ring 6. Lever 8. Vinyl Lid 3. Spigot Adapter 5. Rubber Insert
1
2
3
7
5
6
4
8 5 SPIGOT ASSEMBLY (FOR SF MODELS ONLY)
Your spigot assembly includes the main spigot housing, O-ring and rubber insert.
1. Spigot housing 7. Plastic Feed Cap 2.
Instruction Manual - Page 6
...
figure 3 and position the insert
inside the housing so that the
lever slides inside to fit the lever
(refer to figure 2). SPIGOT ASSEMBLY (FOR SF MODELS ONLY)
Your spigot assembly includes the main spigot housing, O-ring and rubber insert. Figure 1. Push the bottom of the lever
through the bottom loop of...
Instruction Manual - Page 7
... cord into outlet.
3. Put ingredients into the adapter on the jar and rotate clockwise until the button is firmly seated and not tilting to the setting selected. Note: Your CB15 utilizes a Slow Start™ feature. Place cover securely on container and fasten the cover clamps.
4. Press the STANDBY button to turn...
Instruction Manual - Page 9
... off and return to the maximum of 3 minutes.
6. Select and press a speed button; Timer can be the last time set. the blender will be 10 seconds.
5. Push the UP arrow to set to manual mode.
7. When using the timer again, the initial time will increase or decrease in recipe. Always add liquid ingredients...
Instruction Manual - Page 10
Spigot Instructions
When pouring jar contents through the spigot. CB15V/CB15SF OPERATION
1. Before starting, make sure that... protection is recommended during blending. If contents are too thick, it is firmly seated and not tilting to Cleaning and Sanitizing Instructions, page 13.
10. Do not fill above MAX line. When finished blending, press START/STOP button.
10 Not for ...
Instruction Manual - Page 11
...can help the flow. Not for waterjet cleaning. 11. The use . Spigot Instructions When pouring jar contents through the spigot. Never place the container on HIGH speed until...to pour through the spigot, simply
push the lever toward the blender jar.
See Cleaning & Sanitizing Instructions. 10. Running the blender on the blender with one hand when starting and while blending. motor...
Instruction Manual - Page 12
...container lid
gasket and the container lid clamps is mandatory. These parts are 100˚F (38˚C) or hotter. • Always start blending on lowest speed setting, then
progress to less than the full 4-liter capacity when ...while it in any way.
12
TO REALIZE MAXIMUM SERVICE LIFE, OBSERVE THE FOLLOWING PRECAUTIONS:
1. Do not lubricate container bearing, drive shaft, or shaft seals.
Instruction Manual - Page 13
... CX/A
Hot 115° F (46° C)
Rinsing:
Plain Water -
CLEANING AND SANITIZING INSTRUCTIONS
THE CONTAINER MUST BE CLEANED AND DRIED ACCORDING TO THE FOLLOWING INSTRUCTIONS AFTER EACH USE OF THE BLENDER.
SOLUTION PRODUCT
DILUTION IN WATER
TEMP. For Food Service Applications
• Wash, rinse, sanitize and dry container prior to store processed foods...
Instruction Manual - Page 15
... Not for two (2) minutes. Prevent liquid from running on motor base, and running into motor base by wringing all parts to air-dry. Dislodge any residual moisture from cloths or sponges before using the spigot.
Wipe down exterior surfaces of container...TEMPERATURES OR LARGER QUANTITIES ARE USED, OBSERVE ALL PRECAUTIONS GIVEN IN THE OPERATING MANUAL UNDER "HOT BLENDING INSTRUCTIONS".
Instruction Manual - Page 16
... without injury to be replaced only by the manufacturer's authorized importer (or, in this warranty, Waring, during the warranty period, will repair or replace any one of the ...that container blade assemblies be replaced by an authorized Service Center).
When any part which, upon our examination, is defective in the separate Cleaning and Sanitizing Instructions. Power Supply Cord - ...
Instruction Manual - Page 17
...-492-7464 • FAX (860) 496-9017
or nearest Authorized Service Center
Replacement parts for service must be clearly identified as having been sterilized, both by a tag on this supersedes all other than the Waring Service Center or a Factory Approved Service Center, or due to repairs or servicing by a statement in USA or Canada be sterilized before being...
Spec Sheet - Page 2
Specifications
Item
CB15, CB15T CB15SF, CB15TSF
Ordering Information
One-Gallon Blender CB15 Series
Electrical...Std Pkg. 1
Ship Wt. (lbs.)
38
Cubic Feet 2.8
CB15T
1
38
2.8
CB15SF
1
38
2.8
CB15TSF
1
38
2.8
UPC Code 040072000836 040072000829 040072029189 040072029219
CAC72
1
9
.74
040072930539
CAC125
1
9
.74
040072029141
26"
15"
147∕8"
©2014 Waring Commercial...
Waring CB15TSF Reviews
We have not received any reviews for Waring yet.