Whirlpool WDT705PAKZ Support and Manuals
Get Help and Manuals for this Whirlpool item
View All Support Options Below
Free Whirlpool WDT705PAKZ manuals!
Problems with Whirlpool WDT705PAKZ?
Ask a Question
Free Whirlpool WDT705PAKZ manuals!
Problems with Whirlpool WDT705PAKZ?
Ask a Question
Popular Whirlpool WDT705PAKZ Manual Pages
Quick Reference Manual - Page 1
... this change your dishwasher without rinse aid. � Rinse aid keeps water from forming droplets that All Arms Spin Freely
Cycle Guide
This information covers several different models.
Adding options may be heard, and cycle will display the remaining time for daily, regular, or typical use and installation, please visit https://www.whirlpool.com/owners...
Owners Manual - Page 2
...from service or discarding it.
� Do not use in this manual and on all instructions before using the dishwasher.
� Use the dishwasher only ...dishwasher unless all safety messages. If the hotwater system has not been used for use replacement parts that has not been used for such a period, before using the dishwasher, turn on your dishwasher, follow instructions. parts...
Owners Manual - Page 3
... plug. Check with a qualified electrician or service representative if you are in accordance with all local codes and ordinance. Do not push down on the dishwasher. The plug must be plugged into an appropriate outlet that is installed and grounded in doubt whether the dishwasher is equipped with the dishwasher;
In the event of a malfunction or...
Owners Manual - Page 4
...Whirlpool, U.S.A.
4 Damage from hard water, a soft brush may have a coating that you have used to the dishwasher.
Make sure the water supply lines are removed.
If you have hard-to fingerprints. DISHWASHER MAINTENANCE AND CARE
User-Maintenance Instructions... service personnel.
Monthly use detergent. For tips on removing spots and stains, see the online "Troubleshooting"...
Owners Manual - Page 5
.../green)
5/16" (8 mm) and 1/4" (6.35 Small level mm) nut drivers or hex sockets
#10 x 1/2" (12.7 mm) Phillips- INSTALLATION INSTRUCTIONS
REQUIREMENTS
Tools and Parts
Gather the recommended tools and parts before starting installation. Undercounter mounting
head screws (2)
brackets (2)
Make sure all these parts are registred trademarks of Acument Intellectual Properties, LLC.
5 Measuring...
Owners Manual - Page 6
...for connecting your appliance. To order, refer to the contact information referenced in the dishwasher.
� Use only: Straight: Whirlpool Part Number 4317824, 90°: Whirlpool Part Number W10278923RP
Copper Tubing (3/8" [9.5 mm] O.D. Record hose installation or replacement dates on the Quick Start Guide for future reference. Screw-Type Clamps 1 1/2"- 2" (38 mm-50 mm) (3 maximum)
With...
Owners Manual - Page 7
... to the installation instructions provided with the kit. An optional moisture barrier accessory is not covered by authorized service personnel.
• If installed in cabinet
NOTE: Required for your Quick Start Guide. Motor should not touch the floor. � Do not install dishwasher over carpeted flooring. Your installation may be installed. Check location where dishwasher will be...
Owners Manual - Page 8
...these instructions. � Installation should be verified by a qualified service technician. � The dishwasher must ensure that meets the wiring requirements for your home and local codes ... connection with the air gap installation instructions. NOTE: If replacing an existing dishwasher, it is recommended to 862 kPa) water pressure can be installed in accordance with rubber washer
...
Owners Manual - Page 10
... the cable as shown. route cable
Helpful Tip: Place cardboard under dishwasher until installed in use the door panel as needed
Prepare Dishwasher
WARNING
Built-up floors - Do not use .
6.
Do not ... the power cord to avoid scratching the door panel.
Direct wire - NOTE: On some models, once the dishwasher is moved into a 33 1/2" (851 mm) opening to remove it with a power cord,...
Owners Manual - Page 13
... of the dishwasher.
NOTES: � Do not use .
23.
Remove terminal box cover
Using a 1/4" hex-head socket, nut driver, or Torx...Whirlpool Part Number 4317824, 90°: Whirlpool Part Number W10278923RP).
Route cord so that it onto the connector between stops. Install strain relief
Place towel under drain hose to the new dishwasher.
22. Slide clamp onto connector
Install...
Owners Manual - Page 14
... hex key with the setscrews facing down. Make sure wires are already installed in strain relief
Electrical Shock Hazard Electrically ground appliance. Wiring configuration
IMPORTANT: Do not scratch the front panel during this kit (Straight: Whirlpool Part Number 4317824, 90°: Whirlpool Part Number W10278923RP) . NOTE: Do not pre-twist stranded wire. Twist on mounting...
Owners Manual - Page 18
...
Using a 1/4" hex-head socket, nut driver, or Torx® T20® screwdriver, remove terminal box cover. For some models, you are securing dishwasher to cabinet with two #10 x 1/2" Phillips...screws, brackets, or countertop.
Retain for easier access.
Secure dishwasher to countertop or cabinet.
46. Install strain relief
Install a UL-listed/CSA-approved metallic strain relief. 18 This...
Owners Manual - Page 23
... have been installed and no steps were skipped.
If none of a cycle.)
23 Energy-efficient dishwashers use nearly 40% less energy than older models. Certain models are equipped with your dishwasher.
� Check that you press it again. (You must make sure the door is closed tightly and latched? � Has the cycle been set correctly...
Dimension Guide - Page 1
... marked for part details and orders. Air gap
If connecting dishwasher with direct wiring:
n Use flexible, armored, or nonmetallic sheathed copper wire with a maximum length of the guide for use with rubber washer.
Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice...
Dimension Guide - Page 2
...dishwasher. May be reduced to change materials and specifications without notice. D Minimum, measured from the lowest point on all models). For complete details, see Installation Instructions...dishwasher installation.
34" (864 mm)
C
4" (102 mm)
101/2" (267 mm)
63/4" (172 mm)
NOTE: Shaded areas of opening is 341/2" (876 mm).
33/4" (94 mm)
21" (533 mm)
A. with product. Because Whirlpool...
Whirlpool WDT705PAKZ Reviews
We have not received any reviews for Whirlpool yet.