Whirlpool WETLV27HW Support and Manuals
Get Help and Manuals for this Whirlpool item
This item is in your list!
View All Support Options Below
Free Whirlpool WETLV27HW manuals!
Problems with Whirlpool WETLV27HW?
Ask a Question
Free Whirlpool WETLV27HW manuals!
Problems with Whirlpool WETLV27HW?
Ask a Question
Popular Whirlpool WETLV27HW Manual Pages
Installation Instructions - Page 3
... this
or any electrical switch; Installation and service must not exceed 4 feet (121.9 cm). Do not store or use any phone in the vicinity of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54, or the Natural Gas and Propane Installation Code, CSA B149.1. Follow the gas supplier's
instructions.
• If you cannot reach...
Installation Instructions - Page 6
...washers
Check local codes, electrical supply and venting, and read "Electrical Requirements" and "Venting Requirements" before purchasing parts. Plastic strap
Drain hose
Silver double-wire hose clamp
Anti-tip brackets (2) and screws (4) (27" [69 cm] models)
Parts needed: (Not supplied with washer/dryer)
n Vent clamps n Vent elbows and ductwork n Mobile Home Installation Kit
(Part Number 346764...
Installation Instructions - Page 7
..., closet, or recessed area.
Some codes limit, or do not permit, installation of installation and servicing.
n Mobile Home Installation Kit Part Number 346764 (gas models only). n For 27" (69 cm) and 24" (61 cm) 240V electric models, a separate 30 amp circuit. For 24" (61 cm) 120V electric models, a separate 20 amp circuit. n A water heater set to deliver 120°F (49...
Installation Instructions - Page 10
... 285834), two Connector Kits (Part Number 285385), and an Extension Drain Hose (Part Number 285863) that may be purchased separately. install no higher than 4.5" (114 mm) of wash tub.
Secure drain hose with plastic strap.
10 To order, please see toll-free phone numbers in your Use and Care Guide. Laundry tub drain system...
Installation Instructions - Page 12
... To contact a qualified electrical installer.
n Do not use Power Supply Cord Replacement Part Number 9831317.
latest edition and all local codes. Be sure wall receptacle is within reach of above code standards can be provided. Electrical Requirements, 240V Electric Models - and Canada (24" [61 cm] Models Only)
n It is adequate. n If codes permit and a separate ground wire...
Installation Instructions - Page 13
... is also recommended that the ground path is adequate. Install a shut-off valve. Failure to do so can result..., grounded in accordance with local codes and ordinances.
Examples of a qualified person include: licensed heating personnel, authorized gas company personnel, and authorized service personnel. Burner information is located on the model/serial rating plate for use with...
Installation Instructions - Page 14
... washer/dryer is recommended.
■ Must include shut-off valve:
In the U.S.A.:
An individual manual shut-off valve must be used. GAS SUPPLY LINE
■ Must include 1/8" NPT minimum plugged...B149.1, Natural Gas and Propane Installation Code. Elevations above 10,000 ft (3,048 meters):
■ When installed above sea level at the Btu rating indicated on the model/serial number plate. Pull ...
Installation Instructions - Page 25
... interior of duct and catch lint. Replace plastic or metal foil vents with screws... performance.
■■Do not install in final dryer location.
■■... Dryer exhaust must not be fully extended and supported in enclosed walls, ceilings, or floors.
■.... 25 Review "Vent System Chart" and, if necessary, modify existing vent system to seal all governing codes and ordinances...
Installation Instructions - Page 26
... to the manufacturer's instructions. Rigid metal or flexible metal vent C. Clamps G. Vent system with one standard elbow C.
Wall
E. Exhaust hood
Optional exhaust installations:
24" (61 cm) washer/dryer models can be converted to install. Loop system with standard elbows B. In Canada, call 1-866-698-2538, or visit us at www.whirlpool.com. Other installations are shown...
Installation Instructions - Page 27
... or elbows
0
Type of vent
Rigid metal
Angled hoods
36 ft. (11.0 m)
1
Rigid metal
26 ft. (7.9 m)
2
Rigid metal
16 ft. (4.9 m)
NOTE: Side exhaust installations (24" [61 cm] models only) have a 90º turn to the chart. Use clamps to dryer location using straightest path possible.
n Reduce performance, resulting in Vent System Chart...
Installation Instructions - Page 28
...to the following instructions: IMPORTANT: To ensure proper installation, this procedure must be inside of the straight end of the drain hose.
Open clamp. On 24" (61 cm) models, place clamp ... drain hose form
(floor drain installations only)
The appearance of the 24" (61 cm) model will vary
For floor drain installations, you will need additional parts with tap water. Continue until ...
Installation Instructions - Page 29
...] models only)
If you must be connected to water faucets with new inlet hoses with second hose for cold water faucet. Complete hookup of washer/dryer installation.
29 NOTE: Both hoses must use old hoses. Clear water lines
Washer
Coupling
Run water for future reference. HELPFUL TIP: Make note of hose failure, replace...
Installation Instructions - Page 30
...compound. Flexible gas
E
connector
Install the adapter on water faucets to install and secure the drain hose into the provided plumbing/drain in the parts package. Use pipe-joint compound...metal tubing is the responsibility of the installer to check for wall standpipe with plastic strap included in a manner that will drain later.
7. Install adapter
44..545"."5" (1(11134mmmm) )
4.5"...
Installation Instructions - Page 32
...
With washer/dryer in the left-hand bracket with a 1/4" (6.5 mm) nut driver or socket wrench and secure tightly to turn jam nuts clockwise on 27" (69 cm) models to step 3 (24" [61 cm] models) or "Install Anti-Tip Brackets" (27" [69 cm] models). When washer/dryer is level, use a 9/16" or 14 mm open -end...
Installation Instructions - Page 35
...
20 amp (5-20R) outlet
Complete Installation Checklist
❑ Check that you...amount of /recycle all parts are set the dryer on model) and push START/...part, go away.
35 If it , then repeat the 5-minute test as outlined above. This odor is common when the heating element is open the dryer door and feel heat, turn on the washer/dryer.
❑ Read the Washer/Dryer Use and Care Guide...
Whirlpool WETLV27HW Reviews
Do you have an experience with the Whirlpool WETLV27HW that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Whirlpool yet.
Earn 750 points for your review!