Whirlpool WGT4027EW Support and Manuals
Get Help and Manuals for this Whirlpool item
View All Support Options Below
Free Whirlpool WGT4027EW manuals!
Problems with Whirlpool WGT4027EW?
Ask a Question
Free Whirlpool WGT4027EW manuals!
Problems with Whirlpool WGT4027EW?
Ask a Question
Most Recent Whirlpool WGT4027EW Questions
Dryer Does Not Run
When I press the the start button on my dryer it hums for about 20 seconds and then turns off. The d...
When I press the the start button on my dryer it hums for about 20 seconds and then turns off. The d...
(Posted by JTbaritone 6 years ago)
Popular Whirlpool WGT4027EW Manual Pages
Use & Care Guide - Page 10
... in loose piles around the agitator; Do not overfill. Do not use more information, see "Cycle Guide." For more than 1 cup (250 mL). For best results, do not pack the load tightly.... Liquid Fabric Softener Manually to Wash Load
On models without a fabric softener dispenser (24" models), or to pause the washer. load them in the Cycle knob to add fabric softener manually on your wash ...
Use & Care Guide - Page 11
... washer cycle once the washer has been started.
11 Select TEMPERATURE
On some models, set DEEP WATER WASH to ON for your faucet.
Warm Some cold water will ...instructions to avoid damage to help dissolve detergents.
NOTE: Some washers will be colder than your previous washer provided. Select SOIL LEVEL
9. Select Deep Water Wash option
(on 27" models)
Select the soil level setting...
Use & Care Guide - Page 12
..., or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS before each cycle. Roll lint off the screen with...setting. Select cycle
27" models
24" models
Clean the lint screen before operating this dryer. NOTE: Very Dry removes more information about each load. For additional cleaning information, see "Cleaning the lint screen."
2. Do not tightly pack the dryer; See "Cycle Guide...
Use & Care Guide - Page 13
...setting is on the dryer back ledge.
27" Models
24" Models...
Push and hold the PUSH TO START knob to turn the END OF CYCLE SIGNAL selector to remove a load from the dryer as soon as it stops.
3. When you use .
The drying rack does not move, but the rack remains stationary.
Rest the rear support... your dryer, follow the instructions included in the dryer door...
Use & Care Guide - Page 14
... avoid damage to help dry out the washer and prevent the buildup of odor-causing residue. When replacing your washer.
d. c. Rinse dispenser under warm water, then replace it.
Cleaning Your Top Loading Washer
Read these instructions completely before beginning the routine cleaning processes recommended below. c. Close the washer lid. To keep washer interior...
Use & Care Guide - Page 15
... damp cloth. 3.
Thoroughly dry lint screen with your fingers. On 27" models, the lint screen is in the Installation Instructions. Roll lint
off the screen with a clean towel. NOTE: Garments that would... dryer.
15 CLEANING THE LINT SCREEN
Every load cleaning A screen blocked by a qualified servicer. Roll lint off the screen into the dryer during removal, check the exhaust hood and...
Use & Care Guide - Page 19
... possibly avoid a service call.
Cycles with... Troubleshooting - Ensure there is balanced. Replace ...installation. This is higher than cycles with a low spin speed. To remove extra water in pump or between basket and tub, which can slow draining. Too much detergent causing suds
Always measure and follow detergent directions for your load. NOTE: If problems...at www.whirlpool.com/...
Use & Care Guide - Page 20
...with a slower wash action and spin speed; Increase soil level setting.
Load with water. In Canada www.whirlpool.ca for clothes to move freely.
This is tightly packed. ...avoid a service call.
See "Using Your Washer" section.
Check that hot and cold inlet hoses are not reversed.
The washer is less efficient at www.whirlpool.com/product_help -
Troubleshooting - Reduce...
Use & Care Guide - Page 21
...'s instructions to avoid damage to possibly avoid a service call.
Liquid chlorine bleach may have tangled.
washing. Using too much detergent. Incorrect dispenser operation (on some models) when... Troubleshooting - Washer (cont.)
First try the solutions suggested here or visit our website at www.whirlpool.com/product_help -
Wipe up
added incorrectly. In Canada www.whirlpool.ca...
Use & Care Guide - Page 23
...Troubleshooting - Dryer (cont.)
First try the solutions suggested here or visit our website at the end of the cycle. In Canada www.whirlpool.ca for assistance and to handle. Replace...setting on load or drum Loads are cooled slowly to reduced wrinkling and make it easier to possibly avoid a service...caused by dyes in a cycle.
If the problem continues, call . The odor will be ...
Use & Care Guide - Page 24
... shall be warranted by a Whirlpool designated service company. Please take a few minutes to review the Troubleshooting or Problem Solver section of the original unit's warranty period. call 1-800-807-6777.
Service must be addressed without service. Commercial, non-residential, multiple-family use, or use inconsistent with original model/serial numbers removed, altered...
Warranty Information - Page 1
...installation not in -home repair. 11. Pick-up or delivery.
This warranty gives you specific legal rights, and you also may have other damage to province.
03/14
24
Service must be warranted by Whirlpool. 7. Consumable parts (i.e. Conversion of the original unit's warranty period. Travel or transportation expenses for Factory Specified Replacement Parts and repair...
Installation Guide - Page 6
...washer/dryer)
Your installation may require additional parts. See "Remove Shipping Strap.")
Plastic strap (24" models)
Drain hose
Alternate parts: (Not supplied with nuts (2) (27" models)
Front leveling legs (2) (24" models)
Rear leveling legs (2) (24" models)
Shipping strap (27" models) (Not in parts bag. For further information, please reference the "Assistance or Service" section of...
Installation Guide - Page 7
...Parts" section for mobile home installations.
Check code requirements.
n S pecial provisions must be exposed to reduce noise transfer. A gas washer/dryer must be installed...installation.
Do not operate your dealer.
Install your dryer at or below 45°F (7°C). You will be exhausted to support...for spacing of installation and servicing. Recommended spacing...
Installation Guide - Page 12
...disconnected from the gas supply
piping system during pressure testing at the Btu rating indicated on the model/serial number plate is more than 1/2 psi.
†®... m) should be installed within six (6) ft. (1.8 m) of the washer/dryer in accordance with the B149.1, Natural Gas and Propane Installation Code. NOTE: Pipe-joint compounds that an individual manual shut-off valve
This...
Whirlpool WGT4027EW Reviews
We have not received any reviews for Whirlpool yet.