Whirlpool WVW91330KS Support and Manuals
Get Help and Manuals for this Whirlpool item
View All Support Options Below
Free Whirlpool WVW91330KS manuals!
Problems with Whirlpool WVW91330KS?
Ask a Question
Free Whirlpool WVW91330KS manuals!
Problems with Whirlpool WVW91330KS?
Ask a Question
Popular Whirlpool WVW91330KS Manual Pages
Owners Manual - Page 2
... 4
Tools and Parts 4 Location Requirements 4 Venting Requirements 5 Electrical Requirements 6 INSTALLATION INSTRUCTIONS 7 Prepare Location 7 Install Range Hood 8 Connect Vent System 8 Make Electrical Connection 9 Install Vent Covers 9 Complete Installation 10 RANGE HOOD USE 10 Range Hood Controls 10 RANGE HOOD CARE 11 Cleaning 11 WIRING DIAGRAM 12 ASSISTANCE OR SERVICE 13 In the...
Owners Manual - Page 3
IMPORTANT SAFETY INSTRUCTIONS
Ducted fans must always be vented to operate the appliance by a person who accepts responsibility for their safety. To Reduce The Risk Of Fire Or ... are trained to the outdoors. Do Not Use
To Exhaust Hazardous Or Explosive Materials And Vapors.
For General Ventilating Use Only. READ AND SAVE THESE INSTRUCTIONS
3
Owners Manual - Page 4
...;TORX and T20 are shown must conform to order.
■ 6" (15.2 cm) dia.
Read and follow the instructions provided with local codes. It is factory set for Manufactured Home Installation 1982 (Manufactured Home Sites, Communities and Setups) ANSI A225.1/NFPA 501A, or latest edition, or with any tools listed here. Cabinet opening dimensions that all...
Owners Manual - Page 5
... than 1 elbow is needed . Consult your HVAC professional for specific requirements in the vent system.
■ The vent system must terminate to seal all joints in your dealer or an authorized parts distributor. A 6" (15.2 cm) round vent system is used.
■ Do not install 2 elbows together.
■ Use clamps to the outdoors, except...
Owners Manual - Page 6
... the rating of the appliance as specified on the model/serial/rating plate. Aluminum/copper connection must conform with National Electrical Code, ANSI/NFPA 70 (latest edition), or CSA Standards C22.1-94, Canadian Electrical Code, Part 1 and C22.2 No. 0-M91 (latest edition) and all local codes and ordinances.
2 ft (0.6 m)
The following example falls within the...
Owners Manual - Page 7
...Ceiling B.
Tighten until installation is complete.
4. Failure to the bottom of the screw head to screw into, additional wall framing supports may be installed (A).
2. Select a... cable according to move and install range hood. Range Hood Mounting Screws Installation
1. Disconnect power. 2. Centerline B. Remove the template.
5. INSTALLATION INSTRUCTIONS
Prepare Location
■ It ...
Owners Manual - Page 8
... Hood Care" section. 4.
A. A
B
C A. Mounting screws B. Level the range hood and tighten upper mounting screws. 5. A B
X
C
D
E
A. A B
For non-vented (recirculating) installation only:
1. Assemble the air deflector with vent clamps. Measure from wooden shipping supports. Use a T20® Torx® drive (or T20® adapter provided) to tighten. Place the assembled air deflector...
Owners Manual - Page 9
Make Electrical Connection
WARNING
6. Replace all light bulbs are secure in their sockets. 11. Connect... screw. 9. Check that all parts and panels before servicing. Install with (2) 4.2 x 8 mm T20® screws using UL listed wire connectors.
8. NOTE: For vented installations, upper vent cover may be reversed to ceiling. White wires F. Install Vent Covers
When using both upper...
Owners Manual - Page 10
...range hood is disabled, the blower will turn to turn ON. Louver holes (non-vented [recirculating] installations only)
B. Blower on/off and minimum speed button C. The LED will turn the blower medium ...Control Panel E. Blower medium speed button D. The LED will turn the blower off . Install metal filters.
A B
C
A. Light on the front side of the canopy. Blower ...
Owners Manual - Page 11
...to the following instructions. RANGE HOOD CARE
Cleaning
IMPORTANT: Clean the hood and grease filters frequently according to latch into upper track.
4. Remove the filter by a service technician only.... use only conversion kit Models: ■ Recirculation Kit W11446297 ■ Charcoal Filter Kit W11446294
Replacing an LED Lamp
The LED lights are replaceable by pulling the spring release...
Owners Manual - Page 12
...
BK WH
L2 N L1 N N L
CN9 CN10
CN7
CS-16004.A0
BU YL
CN11 CN12
V4 V1 V3 V2 N
LED
INPUT: 120 VAC
- RED
34.6
BLUE - DRIVER
+ OUTPUT:700mA (2-15 VDC)
MOTOR SPECIFICATIONS
POWER SUPPLY
120 VAC
FREQUENCY
60 Hz
POWER ABSORTION 240 W
MOTOR RESISTANCE (Ω)
BLUE -
Owners Manual - Page 13
... and specifications on our full line of appliances.
■ Installation information.
■ Use and maintenance procedures.
■ Accessory and repair parts sales.
■ Specialized customer assistance (Spanish speaking, hearing impaired, limited vision, etc.).
■ Referrals to local dealers, repair parts distributors, and service companies.
In the U.S.A. Our service technicians...
Whirlpool WVW91330KS Reviews
We have not received any reviews for Whirlpool yet.