Xerox 6200B - Phaser Color Laser Printer Support and Manuals
Most Recent Xerox 6200B Questions
Popular Xerox 6200B Manual Pages
Service Manual - Page 3
To avoid personal injury, do so. First Printing: March 2002 071-0784-00 PHASER® 6200 COLOR LASER PRINTER Service Manual
Warning The following servicing instructions are qualified to do not perform any servicing other than that contained in the operating instructions, unless you are for use by qualified service personnel only.
Service Manual - Page 10
... and other normative documents:
viii
Phaser 6200 Color Laser Printer - This product is no guarantee that the printer to which can affect the emission and immunity compliance and could void the user's authority to radio or television reception, which this declaration relates, is not installed properly in strict accordance with Xerox instructions, it is in this product...
Service Manual - Page 12
... Performance Problems, Image-Quality Problems and Electrical Problems.
Chapter 4 - x
Phaser 6200 Color Laser Printer - Service Manual
Chapter 3 -
Chapter 6 - FRU Disassembly Removal and Replacement Procedures (RRPs) This large chapter provides many procedures and illustrations for the printer.
Error Messages and Codes Information regarding printer specifications.
General...
Service Manual - Page 36
...
Page
31 33 35 37 40 43
47
48 49 50 51 52 53 54
55 57
58 59 60 61 62 63 64
18
Phaser 6200 Color Laser Printer - Service Manual
Service Manual - Page 50
... Driver Board is +24
Motor Driver
VDC.
Troubleshooting Procedure Table (cont'd.)
Steps Actions and Questions
9
Use service diagnostics to step [12].
12
Check the DRV 1 Harness for continuity. Does the Fuser Motor function correctly?
Complete
Does the Fuser Motor function correctly? Service Manual
Go to test the Fuser
Motor. PL 13.1.2.
32
Phaser 6200 Color Laser...
Service Manual - Page 81
... Sensor, PL 6.1.4
"Paper Feed" on page 362
Does the problem recur if any defective parts are resting securely against the both sides of fault
or damage:
MPT No Paper Sensor PL 6.1.4 MPT Actuator, PL 6.1.37
3
Use service diagnostics, to the printer and the guides are replaced.
Yes
Go to step [4]. Go to step [2]. Does the...
Service Manual - Page 97
... and Plug/Jack Map References
"Laser Unit" on page 359
Troubleshooting Procedure Table
Steps Actions and Questions
Yes
No
1
Is the Imaging Unit the correct Xerox part Go to step [3].
Is the Rack V out of alignment?
Non-Xerox Imaging Unit
Code 95: A non-Xerox Imaging Unit has been detected in the proper position.
Damage can go
and...
Service Manual - Page 110
... the Xerox web site at: www.xerox.com/officeprinting/support. Make sure that just printed. 5. Not selecting the appropriate PPD can cause PostScript errors. 6. If the PostScript error does not occur, then the original document may be causing the problem. Image prints in the printer.
1. In the application's Page Setup, make sure that just printed.
92
Phaser 6200 Color Laser Printer...
Service Manual - Page 133
... OK to reset the color, margins and
paper (transfer) settings to reset the margin settings. Resetting Printer setup values to default
Resetting the Printer setup values resets the job defaults, front panel language, Intellegent ready, MPT Tray setup, Tray 1 -3 setup, startup page, front panel intensity, front panel contrast, PostScript error information and energy star to the factory-default...
Service Manual - Page 140
... Tray Guide (PL14.3.5) Low Paper Lever (PL 14.5.8) RRP 14.9 - No Paper, Low Paper Sensor (PL14.5.7) RRP 14.14 - Service Manual Electrical ...Driver Board (PL 12.1.12) RRP 12.4 - Left Tray Guide (PL14.3.3) RRP 14.10 - Paper Size Switch Assembly (PL14.3.6)
RRP Page
221 222
223 224 226 227 228 230 231 233
234 235 236 237
239 240 241 242 245 247 248 250 251 252
122
Phaser 6200 Color Laser...
Service Manual - Page 160
... 1.10). 6. Service Manual On the right side of the printer, disconnect P/J2361 (gray) from the Printer
Chassis. 10.On the left side of the printer, disconnect P/J210 (yellow) from the Printer
Chassis. 11.Disconnect P/J47 (yellow/blue) from the Motor Driver Circuit Board on the right
side of the printer.
142
Phaser 6200 Color Laser Printer - RRP...
Service Manual - Page 238
Remove the Motor Driver Board (RRP 12.3). 3. Service Manual Remove the Right Cover (RRP 1.6) 2. Remove the 4 screws securing the Developer Drive Assembly and remove.
220
Phaser 6200 Color Laser Printer - Disconnect P/J52 from the Motor Driver Board. 4. RRP 11.4 Developer Drive Assembly (PL 11.1.13)
S6200-163
Removal 1.
Service Manual - Page 244
Disconnect all the connectors on the Motor Driver Board. 5. Remove the 4 screws securing the Motor Driver Board to the printer and remove
the board.
226
Phaser 6200 Color Laser Printer - Remove the Right Cover (RRP 1.6). 4. Service Manual RRP 12.3 Motor Driver Board (PL 12.1.12)
S6200-171
Removal
1. Remove the Top Main Cover (RRP 1.4). 2. Remove the Front Right Cover (RRP...
Service Manual - Page 246
....
228
Phaser 6200 Color Laser Printer - Remove the Chute Assembly Registration (RRP 9.3). 2. Remove the Housing Assembly Bias (RRP 9.2). 3. RRP 12.5 Card Cage
1
S6200-173
Removal
Note: You do not need to prevent damaging the Bias Springs.
1. Disconnect P/J141, P/J1361, P/J138, P/J221 and P/J139 from the Laser Unit. 6. Remove the LVPS (RRP 12.2). 5. Service Manual Disconnect...
Service Manual - Page 272
... number
254
Phaser 6200 Color Laser Printer - Service Manual
SSSSS - The serial number is based on that day. Initiated with a change occurs. To be rolled when a major product change request. Five digit numeric serial number.
Particular fields in the barcode. I The nine digit serial number is coded as they become available. It is important when ordering parts to...
Xerox 6200B Reviews
Do you have an experience with the Xerox 6200B that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Xerox yet.
Earn 750 points for your review!