Xerox D105 Support and Manuals
Xerox D105 Videos
Popular Xerox D105 Manual Pages
User Guide - Page 20
... assistance.
8. Copy process completed but the copied flash devices are identical to upgrade the firmware
on a task. The failure rate is lit. Please make sure the original USB Storage Device is strongly suggested not to the
original flash device. The Read Error Skip or Write Error Skip settings under the "Setup" menu, may be poor.
User Guide - Page 21
...
If copying under the "Setup" menu to avoid unnecessary errors. Description: The "Async Copy" process... failed due to source flash device is not detected.
203
Source Removed
Possible Solution: Try to enable the "Size Tolerance" setting...Error Codes
Typically, the system will show an error message and error code if a problem occurs.
User Guide - Page 22
...: The system CANNOT locate the Firmware Update File during the Update Firmware process. Possible Solution: Try to use the correct password for the proper Update file.
19 If the problem persists, call Tech Support.
Description:
Unknown
The Firmware Update File is not meant for the system.
262 flash model
Possible Solution: Contact Tech Support for the next attempt...
User Manual - Page 3
...
Using Autocopy 53
Setup Guide
56
Menu Overview 56
Troubleshooting
61
Trouble Shooting 61
Error Messages 63
Software Installation Guide for Accessing the Hard Drive on a Computer 66
Minimum Requirements 66 Hardware 66 Operating System 66
Installing the File System Driver and Utility 66 Using the File System Utility 69
Accessing the Hard Drive on the Duplicator 72 Creating an...
User Manual - Page 8
...part of the following conditions occur, turn off the machine immediately and disconnect the power cable(s) from the electrical outlet.
It is not described in the customer documentation
Warning: Do not use aerosol cleaners. Xerox Duplicator
8 Aerosol
cleaners can maintain or service... used on this product which is attached to correct the problem:
■ The equipment emits unusual...
User Manual - Page 20
... the master disc.
■ 0 indicates that no failures in this run is completed, the successful copies will be ejected and you should see the progress indicator staying at 010% and 100% for approximately 30 seconds for CD duplication and up to continue making more copies.
Remove the successful copies and refill the trays...
User Manual - Page 22
... to refer to -disc duplicating.
■ Durability. The following steps will stabilize the duplication process as a partition and copy the stored partition onto blank discs. Xerox Duplicator
22 Making Hard Drive-to-Disc Copies
Copying from the hard drive is the best way to load your master disc into the installed hard drive as compared to disc-to image files...
User Manual - Page 28
... arrow buttons on the duplicator and press the >> key to the duplicator. Xerox Duplicator
28 Setup 1.
Step 4: Once you have loaded the files onto the duplicator's hard disk, you should see the following screen. XEROX 12.
Setup
2.14
Step 5: Press >> to enter Setup menu and you must return control of the hard disk to enter the setting:
Setup 14. USB Connection...
User Manual - Page 33
... in this run is normal to continue making more copies. Remove the good copies and refill the trays with additional blank media to see the following screen.
Copying
H4012MB
Copying
H4012MB...; 4012MB indicates the capacity of the master disc.
■ 481MB indicates the current MB from a hard drive image. Pass 7
Fail 0(7)
Waiting for DVD duplication. Note: It is completed, the good ...
User Manual - Page 55
... in this run.
■ 7 indicates that you have a failed disc(s) (bad copies), the failed disc(s) will not be ejected automatically. Step 7: Next, refill your blank discs to manually eject the disc(s) and discard them if they are write once recordable disc(s)
55
Xerox Duplicator
If you wish to copy a new master disc, you will need to continue making more copies.
User Manual - Page 59
..." menu. That information includes but not limited to manufacture's default. You can check the specifications by errors in the master disc.
■ System Info. This feature allows you to turn the ability to leave a small margin of failures reported by our duplicator are caused by pressing up or down button.
■ Device Info. Many...
User Manual - Page 60
... system to operate under the AutoCopy mode for this function will save all the settings you to not update your duplicator's firmware unless your duplicator. We strongly suggest you 've modified since last time the system is getting unstable.
■ Save.
Xerox Duplicator
60 Once you see the "Ready to Power OFF" message, then you , the administrator...
User Manual - Page 62
... 1. You will see the following screen. Cannot boot-up or fails to default (Troubleshoot item #9). ■ Contact our Tech Support.
9. XEROX 13.
5. Disc Info
■ Use the up or down arrow buttons to navigate to the Load Default menu and press >> to update my duplicator's firmware? ■ Unless your system is getting unstable, we strongly suggest not...
User Manual - Page 68
Xerox Duplicator
68 Step 6: When you have completed all of the installation steps, you will see the Completing the USB Driver Utility v1.1 Setup Wizard window:
Step 7: Restart your PC to complete the installation.
User Manual - Page 69
... 3: Press >> to the following screen. Press >> to the "USB Connection" setting under "Setup" on the duplicator's front panel, scroll to submit the change. Step 7: Once the duplicator has restarted, connect the duplicator to "On."
USB Connection
Step 5: Use the keypad on the Windows
69
Xerox Duplicator XEROX 1.Copy
2.14
Step 2: Use the up or down arrow buttons to...
Xerox D105 Reviews
Do you have an experience with the Xerox D105 that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Xerox yet.
Earn 750 points for your review!