Bosch WFMC2201UC Support Question
Bosch WFMC2201UC Support Question
Find answers below for this question about Bosch WFMC2201UC - Nexxt 300 Series Washer.Need a Bosch WFMC2201UC manual? We have 4 online manuals for this item!
Question posted by Wcorb19 on June 15th, 2011
Bosch 300 Series Front Loader
Where do the transportation bolts go
Current Answers
Related Bosch WFMC2201UC Manual Pages
Pedestal Installation Instructions - Page 2
...;observance of the following parts and tools in injury.
Figure 1 1. 17 mm open end wrench 2. 6 mm Allen (Hex) wrench 3. (4) Socket Head Cap Screws and
(4) Flat Washers 4. (4) Height Adjustable Feet 5. (4) Spacers 6.
This indicates that death or serious injuries may occur as a result of nonĆobservance of this warning. d CAUTION
Excessive Weight...
Pedestal Installation Instructions - Page 3
If you are reinstalled prior to pedestal installation to prevent potential damage to 2" off the floor (see Figure 6). NOTICE
Make sure the washer transportation bolts are installing the pedestal on a new washer or dryer, proceed to the drum may result if the plastic bushing is removed from the wall so it can be used as...
Pedestal Installation Instructions - Page 4
..., items such as the pedestal carton) or other suitable protective covering flat on its LEFT side (see Figure 8).
Failure to do not remove the washer transportation bolts prior to laying washer on
4 Retain the feet in the appliance (see Figure 9). Figure 7 2. Remove the protective film, four
corner supports, and two foam packaging pieces. 3.
Protect...
Pedestal Installation Instructions - Page 5
... to washers. Figure 11 5.
If the appliance slides, it . Screw the feet into the protruding threaded bushing in the base of the spacer with the pedestal.
Using the supplied 17 mm open end wrench, tighten only the two rear feet locknuts against the appliance housing. Remove the transport bolts. q Loosen all four bolts before...
Pedestal Installation Instructions - Page 6
... When you turn the level so that came with the
washer and bushing attached. This will turn with all 4 transport
bolt assemblies (bolt, washer and bushings) by turning it .
Otherwise, repeat the ... appliance. q After leveling the unit from the back (see Figure 15). q Store the transport bolts with your appliance to side, then turn the lock nut, the foot (see Figure 17,...
Pedestal Installation Instructions - Page 7
... foot touches the floor firmly. 3. If it to make sure the unit does not wobble. For Washers: Fine tune the leveling by aligning it does wobble, lower the foot on your pedestal contact BSH ...problems with a pair of the appliance manual.
7 Replace the drawer by placing a small load of laundry in the machine, starting it in the Customer Service" section of pliers to keep it will lower...
Pedestal Installation Instructions - Page 8
...state or province to the Operating, Care and Installation Instructions" that came with the washer or dryer that is installed with the Pedestal and contact the service department listed there...in Canada. Warranty Restriction If the Pedestal is subject to the instructions provided in the washer or dryer Operating, Care and Installation Instructions", supplier will repair or replace any other...
Installation and Use & Care (all languages) - Page 2
Stainless Steel Drum The Nexxt washer drum has hundreds of smooth double punched holes, which eliminates even the ...the optimum temperature, which allow your wash load. Bosch NexxtR washers deliver the most stubborn stains with ease.
An inclined drum works with Technology Operation Logic. Digital sensors care for your laundry a complete, even clean. And, working together with...
Installation and Use & Care (all languages) - Page 3
...transport bolts
7
Water connection
8
Hose and cable lengths 10
Electrical connection 10
Leveling procedure 11
Transport, such as when moving out 11
OPERATING INSTRUCTION 12
Your new washer 12
Panel 13
Summary of Instructions 14
Before Using For the First Time 15
Using For the First Time 15
First washing cycle (without laundry...21
Cleaning the washer 21
Descaling the ...
Installation and Use & Care (all languages) - Page 4
... repair instructions
that death or serious injuries may show different details than your laundry using your household. Do not tamper with the washing machine. These items ...that you .
ATTENTION
ATTENTION - i This symbol is a modern, high quality domestic appliance.
BOSCH washers are indicated in the washing machine and stick to important matters. Read and understand all hot...
Installation and Use & Care (all languages) - Page 6
.... If in doubt, have special requirements. Please ask your washer. d WARNING d
Keep children away from environmentally friendly recycling.... is a packet of your model are suitable for the transport bolts (after removing them). 2. Check that all listed warnings...package has protected your new appliance on the type of laundry and water hardness, and follow the detergent manufacturer's ...
Installation and Use & Care (all languages) - Page 7
.... weight = 220 lbs (100 kg)
Installation area
d WARNING d
Never ground the washer to
removing transport bolts. Order the holding brackets. q Units are not suitable. Sound, vibration, and risk of walking" ...on the rear of the bolts all 4 transport bolts must be removed before using the appliance for the first time and must be affected depending on the Bosch pedestal (accessory no ....
Installation and Use & Care (all languages) - Page 8
... cold and hot (max. 140 °F / 60 °C) tap water.
Observe the water pressure in completely.
q Completely remove all 4 transport bolt assemblies (bolt, spring, washer and bushings) by an authorized technician. Bent or flattened. -
Do not remove the strainers from the plastic bushings. Loosen them until they can
no longer ...
Installation and Use & Care (all languages) - Page 10
... (approx.) f = 34.6 in. / 88 cm (approx.) g = 55.0 in. / 140 cm (approx.)
h = 24.0 in . /2.44 m). Electrical connection
GROUNDING INSTRUCTIONS This appliance must correspond to whether the washer has been properly grounded.
Volts 110-120
Hertz 60
Amperes 15
Watts
1350 (max.)
Make sure that: - Replacement power cords are available from the socket...
Installation and Use & Care (all languages) - Page 11
...) by placing a small load of laundry in the machine, starting the first ...transport bolts. It the foot does turn with all transport bolts. q After making preliminary adjustments, press down on each corner of the washer to check the leveling status of the washer.) 3. Dismantle the supply and drainage
hoses. - Preparing and inserting the transport bolts
q Remove the covers. Level the washer...
Installation and Use & Care (all languages) - Page 12
OPERATING INSTRUCTION
Your new washer
Filling laundry detergent and/or additives into dispensers
Open the door (colored marking) ...
...and close the door
dCAUTION The access panel located on the bottom right of the washer is for Service Access
and is only to be opened by an Authorized or Qualified Service Technician. 12
Installation and Use & Care (all languages) - Page 26
...service providers will have responsibility, for the Product if it is under no event shall Bosch have been made without limitation cabinetry, walls, floors, shelving, etc.); in any travel...by BSH Home Appliances ("BOSCH") in this Statement of limited product Warranty applies only to the Bosch 300 Series washer ("Bosch") sold to you, the first using a
Bosch-authorized service provider during...
Installation and Use & Care (all languages) - Page 27
...RESTAURANT MEALS, REMODELLING EXPENSES IN EXCESS OF DIRECT DAMAGES WHICH ARE DEFINITIVELY CAUSED EXCLUSIVELY BY BOSCH, OR OTHERWISE.
How to alter, modify or amend this warranty shall be effective unless authorized ...: To obtain warranty service for your Product, you should contact the nearest Bosch authorized service center. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE ...
Installation and Use & Care (all languages) - Page 28
..., labor
charges excluded.
* Date of normal home use . In addition, the warranties provided in this Statement of Warranties apply only to Bosch LENGTH OF WARRANTY
Clothes washers sold to the earlier date the clothes washer is normal and customary for home use , shipping costs included, labor charges excluded.
2 Year Limited Warranty on Motor...
Installation and Use & Care (all languages) - Page 92
...of load and detergent, as well as other factors.
1/3 load
WFMC2201UC 02/2007
9000224447
Drain pump operates prior to pre-treat heavily ...laundry. Type of laundry Check care labels on water supply and quality, type and amount of delicate laundry.
2
* Actual program duration may be different from the indicated values depending on article! 92
Program selection table Nexxt 300 Series...
Similar Questions
Stacking Kit For Bosch 27 Inch 300 Series Washer And Dryer Set
I am searching for the correct kit to stack my 27 inch Bosch WFVC4400uc/24 washer and my WTVC4300US/...
I am searching for the correct kit to stack my 27 inch Bosch WFVC4400uc/24 washer and my WTVC4300US/...
(Posted by stevendebbie22 3 years ago)
Bosch Nexxt 300 Series Washer Will Not Spin Or Agitate.
Found on the internet to how to put into dervice mode, which I tried and received a P:01 and E:20 er...
Found on the internet to how to put into dervice mode, which I tried and received a P:01 and E:20 er...
(Posted by garrisonml 9 years ago)
Bosch Nexxt 300 Series Washer Water In Drum When Sitting
(Posted by niksaidyle 9 years ago)
Where Is The Bosch Nexxt 300 Series Washer Water Drain Hose Located
(Posted by najtoum 10 years ago)
How To Remove Front Access Panel On Bosch Nexxt 300 Series Washer
(Posted by eaaug 10 years ago)