2008 Chevrolet Cobalt Support Question
2008 Chevrolet Cobalt Support Question
Find answers below for this question about 2008 Chevrolet Cobalt.Need a 2008 Chevrolet Cobalt manual? We have 1 online manual for this item!
Question posted by Anonymous-154621 on September 25th, 2015
What Is Stopping My Gas From Reaching The Engine
The person who posted this question about this Chevrolet automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by TommyKervz on September 25th, 2015 11:56 AM
TommyKervz
Member since:
January 10th, 2013 Points: 17,776,793
Member since:
January 10th, 2013 Points: 17,776,793
- Could be bad fuel pump
- Bad fuel pump fuse
- Main relay
- You should also check fuel pressure.
See troubleshooting tips here: http://jalopnik.com/heres-how-you-diagnose-an-engine-that-wont-start-1717491831
See other suggested solutions here: http://www.rctech.net/forum/nitro-road/486086-fuel-wont-go-into-carburetor-engine.html
Related Manual Pages
Owner's Manual - Page 63
...whether an airbag should never be regarded as anything more evenly over the occupant's upper body, stopping the occupant more information. In moderate to inflate in frontal impacts, near the ...airbags, deployment is intended to a vehicle or because of what the vehicle hits, the angle of gas from the in flation is not toward those airbags. In a deployment event, the sensing ...
Owner's Manual - Page 87
... shut. • Turn the fan on page 2-36.
2-13 You cannot see or smell CO. See Engine Exhaust on your heating or cooling system to remove the key from the outside air into your vehicle. If ... that will unlock. If you must drive with the trunk lid open because carbon monoxide (CO) gas can come into your vehicle. Lockout Protection
If your vehicle has power door locks, it will have...
Owner's Manual - Page 95
...able to LOCK/OFF, and remove the key. 4. Do not make full-throttle starts. Hard stops with new linings can be gradually increased. 2-21 Your PASS-Key® III+ system, however... Transmission) on page 4-34 for the first 500 miles (805 km). Following break-in, engine speed and load can mean premature wear and earlier replacement.
Insert the already programmed key in guideline every...
Owner's Manual - Page 99
Automatic Transmission
Move the shift lever to PARK (P) if your vehicle is stopped.
• Audio System • Power Windows, if equipped • Sunroof, if ... 10 minutes or until any other position -- Hold the clutch pedal down . That is a safety feature. Starting the Engine
Place the transmission in ON/RUN or ACC/ACCESSORY.
Notice: Do not try to shift to PARK (P) or NEUTRAL (N)....
Owner's Manual - Page 100
... the accelerator pedal all moving parts. This clears the extra gasoline from the engine. If you could be stopped after cranking has ended, can be covered by turning the ignition switch to... cool down . With your vehicle. Any resulting damage would not be stopped by your dealer/retailer. If the engine does not start and the key is already running. Before adding electrical ...
Owner's Manual - Page 101
...before to keep it could be parking your vehicle. Instead of the cord may exist which will not reach, use a heavy-duty three-prong extension cord rated for at temperatures above 0°F (−18&#... on the passenger's side of oil you do not, it away from moving engine parts. For the 2.2L and 2.4L engines, the electrical cord is located on the outside temperature, the kind of the ...
Owner's Manual - Page 103
.... To rock your vehicle back and forth to REVERSE (R) only after your vehicle is for normal driving with the engine running at high speed may damage the transmission. DRIVE (D): This position is stopped. Shift to get out of snow, ice, or sand without damaging your transmission, see "Skidding" under Loss of PARK...
Owner's Manual - Page 105
...if you start or idle your warranty. The repairs would not be covered by your engine. United States Only When this position when you quickly change the position of the accelerator... FIFTH (5): Shift into REVERSE (R). Slowly let up on the clutch pedal as you accelerate, it is stopped. Let up on the clutch pedal slowly while pressing the accelerator pedal. Also, use REVERSE (R), along...
Owner's Manual - Page 110
...or smell. and • Have your vehicle and ignite. It can kill. It contains the gas carbon monoxide (CO), which you ever suspect exhaust is coming in a collision. • Your...vehicle: • Drive it only with all the windows down to blow out any CO; Engine Exhaust
{CAUTION:
Engine exhaust can cause unconsciousness and death. Do not park over road debris. Parking Over Things ...
Owner's Manual - Page 149
...with the brake system warning light on if your brake system inspected right away. If it will stay on can still work and stop you need both parts working well. Make sure the parking brake is on, the brake system warning light will also come on ...closer to an accident. If it means you set the parking brake. If one part is on briefly when the engine is divided into two parts.
Owner's Manual - Page 150
...working properly and your vehicle requires service. Then start the engine. See Brake System Warning Light on again while you are driving, stop as soon as an indicator and warning light. The LOW... That is actively limiting wheel spin. If the light does not come on briefly when the engine is a problem with the Antilock Brake System (ABS), this light will be limited. If the ABS...
Owner's Manual - Page 152
... vehicle serviced. A tire pressure message in flate to overheat. Stop and check your warranty. See Engine Overheating on when the engine has overheated.
If underinflated, in the Driver Information Center (DIC), may accompany the light. Engine Coolant Temperature Warning Light
The engine coolant temperature warning light will also come on page 5-23...
Owner's Manual - Page 154
... hauled as soon as it is usually corrected when the electrical system dries out. If the light stops flashing and remains on steady, see your vehicle. Turn the ignition off .
• ...missing fuel cap allows fuel to do so, stop the vehicle. A few driving trips should turn the light off , wait at least 10 seconds, and restart the engine. If so, your vehicle? The condition is ...
Owner's Manual - Page 161
...properly installed should be reset separately.
Tire Pressure on the DIC, stop as soon as possible.
3-43
See Brake System Warning Light ...This message displays, while the ignition is turned off . CHECK GAS CAP
This message displays if the fuel cap has not been...back on the next time the vehicle is on . See Engine Oil Life System on page 5-16 and Scheduled Maintenance on properly...
Owner's Manual - Page 162
...engine.
You may feel or hear the system working and see this message is temporary and normal under these conditions. See Electronic Stability Control (ESC) on page 4-10 and Electronic Stability Control (ESC)/Traction Control System (TCS) Indicator/Warning Light on for a few seconds after ESC stops... displays if one or more of the engine is active.
ESC (Electronic Stability Control...
Owner's Manual - Page 200
... heavy acceleration followed by heavy braking - rather than keeping pace with another. If your vehicle's engine ever stops while you are driving, brake normally but this is normal. But you will use it is used ... reaction time is wet, dry, or icy; Avoid needless heavy braking. If the engine stops, you might not have some power brake assist. So do it is about three-fourths of heavy ...
Owner's Manual - Page 201
... When you start your vehicle has ABS, this is programmed to stop , even though you . Here is normal. Just hold the ...stop rolling, the computer will separately work for you steer around the obstacle while braking hard. This is what happens with ABS: A computer senses that wheels are driving safely. Let us say the road is going on briefly when you start the engine...
Owner's Manual - Page 202
... assist cannot compensate for you. The system operates only if it was headed when the wheels stopped rolling. Your wheels can help you retain steering control. Once they do not have ABS,...while maintaining steering control. In many emergencies, steering can stop rolling. When this happens, the system works the front brakes and reduces engine power by pushing on the condition of the road, ...
Owner's Manual - Page 208
.../non-retailer accessories can affect your dealer/retailer for service. The traction control system can steer, but it stops, or hold the button from five to warn the driver that a problem exists with the system....not functioning, you are disabled. Steering
Electric Power Steering
If the engine stalls while you are driving, the power steering assist system will take more effort.
Owner's Manual - Page 219
... remain icy when the surrounding roads are clear. Unless your vehicle's stability when you make a hard stop rolling, you will spin and polish the surface under bridges. Without ABS, if you feel your vehicle...Sometimes the surface of a curve or an overpass can appear in shaded areas where the sun cannot reach, such as around clumps of you, brake before you would on it. If you do have ABS...
Similar Questions
Engine Size Info
where is the engine displacement located on the vehicle?
where is the engine displacement located on the vehicle?
(Posted by ballshane22 8 years ago)
2007 4dr Cobalt Ls Engine Racing Sound As Car Accellerates
Why would 2007 Cobalt LS engine souund louder or racing sound when driveing over 35 mph. The car shi...
Why would 2007 Cobalt LS engine souund louder or racing sound when driveing over 35 mph. The car shi...
(Posted by dgranger40 11 years ago)
Over Loading Fuel
I have an 2008 colbalt 2.2 that is overloading with fuel, when you start it it acts like it is flood...
I have an 2008 colbalt 2.2 that is overloading with fuel, when you start it it acts like it is flood...
(Posted by cindytindle 11 years ago)
Engine Light 2010 Colbat
had oil change yesterday now engine light on was told could be air pump
had oil change yesterday now engine light on was told could be air pump
(Posted by Anonymous-68065 11 years ago)
What Causes A 2006 Cobalt To Not Shift Out Of Park, Blows The Lp Stop Fuse?
We can manually trip the shifter under the hood and when we do, this resets everything. Then we repl...
We can manually trip the shifter under the hood and when we do, this resets everything. Then we repl...
(Posted by brendawahl 12 years ago)