Cisco SG100D-08 Support Question
Cisco SG100D-08 Support Question
Find answers below for this question about Cisco SG100D-08.Need a Cisco SG100D-08 manual? We have 2 online manuals for this item!
Question posted by rperaza26 on August 10th, 2012
Non-poe Device On Sg100d08pna?
Can I use a POE product like: http://www.kl-security.com/productsbig-111.html on a Cisco SG100D08PNA Switcht and also connect a regular device ie: computer or switch?
Current Answers
Related Cisco SG100D-08 Manual Pages
Quick Start Guide - Page 2
...switches support frames up to use less energy and save money. For additional information, see www.cisco.com/...Switch, a Cisco Small Business network communications device.
Welcome
Thank you with attached devices.
This guide will familiarize you for the cable type (straight-through or crossover) used to connect the unmanaged rackmount switch to deploy the device in each packet.
1
Cisco...
Quick Start Guide - Page 3
Cisco Unmanaged Rackmount Switches
2
Do not deploy the device in a location where any of the following guidelines:
• Make sure that the switch is accessible and that circuit. Reduced Air Flow-Both side panels must be level, stable, and secure to prevent overheating.
Mechanical Overloading-The device should be unobstructed to avoid it sliding or shifting out...
Quick Start Guide - Page 4
..., SG 100-16, or SG 102-24 Unmanaged Rackmount Switch can be wall-mounted. WARNING Insecure mounting might damage the device or cause injury. STEP 3 After the brackets are attached to the switch, use suitable screws to securely attach the brackets to any standard 19-inch rack. Cisco is smooth, flat, dry, and sturdy. Verify that...
Quick Start Guide - Page 5
...switch down until the screws fit snugly into each hole, leaving a gap between the surface and the base of the screw head of a typical network configuration.
STEP 3 Insert a screw into the wall-mount slots.
276583
2 Connecting Network Devices...
11
12
21
22
23
24
(Shared with 12)
(Shared with 24)
miniGBIC1
miniGBIC2
Cisco Small Business SR2024
24-P or t 10/ 100/ 1000 Swit ch
193803...
Quick Start Guide - Page 6
... to one port to another is moved from one unmanaged, cascaded switch to another port, it can take up to five minutes for each device you want to connect to the switch and a power source.
5
Cisco Unmanaged Rackmount Switches The LED of the connected devices. On some devices, such as some IP phones and IP cameras, flow control might...
Quick Start Guide - Page 7
... a combination port, shared with Cisco miniGBIC modules MGBSX1, MGBLH1, MGBT1, MGBLX1, and MGBBX1, as well as other brands of the switch.
1 13 2 14 3 15 4 16 5 17 6 18 7 19 8 20 9 21 10 22 11 23 12 24
LINK GIGABIT ACT
RJ-45 Ethernet Ports -Use these ports to connect network devices, such as computers, printers, and...
Quick Start Guide - Page 8
...
7
Cisco Unmanaged Rackmount Switches MiniGBIC (if present)-Lights green when a connection is active. POWER
Side Panel
The Kensington lock is cabled to the port, is powered on, and a 100 Mbps link is located on the side panel of the unmanaged rackmount switch. Gigabit LED (if present)-Lights and remains lit when another device is connected to...
Hardware Installation Guide - Page 2
... not installed and used in accordance with the limits for illustrative purposes only.
In that is for FCC compliance of Class B devices: The equipment described in part 15 of the word partner does not imply a partnership relationship between Cisco and any interference to operate the product. CCDE, CCENT, Cisco Yes, Cisco Stadium Vision, the Cisco logo, DCE...
Hardware Installation Guide - Page 9
... be careful. In this situation, you work on any equipment, be aware of all warnings used in this device. Preface
• Cisco Internet Streamer CDS 2.x Product Documentation You can access the software documents at the following URL: http://www.cisco.com/en/US/products/ps7127/tsd_products_support_series_home.html You can access the hardware documents at the end of data.
Hardware Installation Guide - Page 17
... services: • Content caching and hosting • Proxy services • Content replication • Video streaming To deploy Cisco SEs with a specific device mode. The CDE refers to manage registered Service Engines and Service Routers. The following device modes are asked to distribute and receive high-bandwidth, media-rich content across the Internet without performance...
Hardware Installation Guide - Page 18
...: • A Vault Group consisting of one CDE200 ISV. Cisco TV CDS Overview
The Cisco TV CDS is used , where the Vault and Streamer functionality exist in one or more CDE300s.
Cisco TV CDS Overview
Chapter 1 Overview of the Content Delivery Engines
Note The CDE100 supports device-mode configuration and can be configured with the CDS...
Hardware Installation Guide - Page 22
...used to receive new content from the CDE200 or CDE400.
3. Normally configured with the CDSM.
2. Figure 1-9
CDE100 Front Panel Control Buttons
1
2
3
211766
1 Power 2 Reset 3 CD eject
Powers up to 250 simultaneous streams and to deliver up the device... 300 or 400 GB of storage. Opens the CD drive tray. Cisco Content Delivery Engine 100/200/300/400 Hardware Installation Guide
1-6
OL-...
Hardware Installation Guide - Page 23
... Control Buttons
12
211767
1
2
1 Power 2 Reset
Powers up the device. Resets the device and runs the power-on self-test (POST). Figure 1-11 shows the...Control Buttons
12
270625
1 Power 2 Reset
Powers up the device.
OL-13478-03
Cisco Content Delivery Engine 100/200/300/400 Hardware Installation Guide
1-7 Resets the device and runs the power-on self-test (POST). Chapter 1...
Hardware Installation Guide - Page 24
...CDE400 Back Panel Control Buttons
203753
1 Power 2 Reset
1
2
Powers up the device. LED Indicators
Figure 1-13 shows the location of the Content Delivery Engines
Figure ... of the CDE100 front panel LEDs, and describes their functions.
Cisco Content Delivery Engine 100/200/300/400 Hardware Installation Guide
1-8
OL-13478-03 Resets the device and runs the power-on self-test (POST).
Hardware Installation Guide - Page 32
...inches (2.5 cm) 3.6 inches (9.2 cm)
Cisco Content Delivery Engine 100/200/300/400 Hardware...These devices prevent...non-operating
Specification 0 to 50°C (32 to 122° F) -40°C to 70°C (-104°F to 158°F)
60 to 4000 m 5 to 95%, noncondensing at temperatures of 23°C (73°F) to Install the Content Delivery Engines
• When removing or installing a component, use...
Hardware Installation Guide - Page 37
... do so by shorting out interior components.
• Use the product only with other Cisco-approved equipment.
• Allow the product to cool before you have not been provided with a...Doing so can harm delicate components inside the device. Make sure that nothing rests on your local or national wiring rules. If possible, use a surge suppressor, line conditioner, or ...
Hardware Installation Guide - Page 38
...stable.
Intended Uses
This product was evaluated ...Cisco Content Delivery Engine 100/200/300/400 for disconnection then you must include a third wire safety ground conductor with the CDEs.
If the individual server power cord(s) will not be readily accessible when installed. Mains AC power disconnect: The AC power cord(s) is an FCC (Federal Communications Commission) Class A device...
Hardware Installation Guide - Page 41
...connected through Ethernet switches. There are two types of servers that are four distinct server types in the IS Content Delivery System: • Content Delivery System Manager (CDSM)-CDE100 or CDE200 • Service Engine (SE)-CDE200 • Service Router... • Integrated Streamer Vault (ISV)-CDE200
OL-13478-03
Cisco Content Delivery Engine 100/200/300/400 Hardware Installation Guide
...
Hardware Installation Guide - Page 69
... 100/200/300/400 Hardware Installation Guide
4-17 Refer to the Cisco Internet Streamer CDS 2.0-2.1 Software Configuration Guide for your registered Service Engines and Service Routers appears (see Figure 4-20).
If a device is now complete. Figure 4-20
Devices Page
Step 4 Step 5
Verify that device by using the CDS.
Chapter 4 Installing the Internet Streamer CDS Software and...
Hardware Installation Guide - Page 108
... Engine, see SE Service Router, see SR site requirements 2-1 specifications
CDE100 A-2 CDE200 A-2 CDE300 A-3 CDE400 A-3 management A-4 Serverworks chipset
CDE100 C-1 CDE200 C-2 CDE200 (IBM) C-3 CDE300 C-3 CDE400 C-4 technical A-1, C-1 SR 1-1, 3-1 connections 3-8 streamer 1-2, 3-1 CDE300 1-2 connections 3-8 stream interfaces 4-2 SX CDE300 3-7
troubleshooting Cisco Technical Assistance 5-2 Ethernet...
Similar Questions
Port Mirroring On The Cisco Rv016 Router
Can we port mirror on the Cisco RV016?
Can we port mirror on the Cisco RV016?
(Posted by edw93576 10 years ago)
Router Rebooting And Dsl Connection Disconnecting Frequently
I have link sys rv042 h/w ver 1 router with the latest firmware. suddeny the router is malfunctionin...
I have link sys rv042 h/w ver 1 router with the latest firmware. suddeny the router is malfunctionin...
(Posted by info160 10 years ago)
Shipping/packing Materials For A 12416 Cisco Router Chassis
We need to remove a 12416 Router chassis and ship to another site how do we go about ordering the or...
We need to remove a 12416 Router chassis and ship to another site how do we go about ordering the or...
(Posted by paulgarcia 10 years ago)
Password Reset For My Router...wrt100 Rangeplus
few years ago, my wife bought a router but we have never used a password. we just moved into an ap...
few years ago, my wife bought a router but we have never used a password. we just moved into an ap...
(Posted by scorebin 11 years ago)
How Can I Get A New Password For My Wifi, Without Buying A New Router?
(Posted by Anonymous-46816 12 years ago)