Not Sure How To Run Fuel Lines

1. Gather the Required Materials: You will need new fuel lines, typically available at a local hardware store or an authorized Cub Cadet dealer. Make sure the fuel lines you purchase are compatible with your specific model.
2. Prepare the Trimmer: Before replacing the fuel lines, ensure that the Cub Cadet CC 330 trimmer is turned off and that the fuel tank is empty. It's also a good idea to disconnect the spark plug wire to prevent accidental starting.
3. Remove the Old Fuel Lines: Locate the existing fuel lines on the trimmer. In most cases, there will be a fuel line for the fuel filter and another line that connects to the carburetor. Carefully remove these lines from their respective connections, taking note of how they were originally routed.
4. Install the New Fuel Lines: Start by inserting one end of the new fuel line into the fuel tank. Feed the line through the opening until it reaches the fuel filter or the fuel pickup inside the tank. Ensure that the fuel line is securely attached to the filter or pickup.
5. Route the Fuel Lines: Follow the original routing path and connect the other end of the fuel line to the carburetor. Make sure it is properly secured and connected to the correct fitting on the carburetor.
6. Test the Fuel System: Double-check all connections to ensure they are tight and secure. Once you are confident that everything is correctly installed, reconnect the spark plug wire. Fill the fuel tank with fresh, clean fuel, and start the trimmer. Let it run for a few minutes to ensure the fuel lines are functioning properly and there are no leaks.

It's important to note that the exact steps and fuel line configurations may vary slightly depending on the specific model and design of your Cub Cadet CC 330 trimmer. If you have any doubts or require more specific instructions, it is recommended to refer to the user manual for your trimmer or consult a professional technician.