Get support for Cub Cadet CS 202

Cub Cadet CS 202 Support Question

Cub Cadet CS 202 Support Question

Find answers below for this question about Cub Cadet CS 202.
Need a Cub Cadet CS 202 manual? We have 3 online manuals for this item!
Question posted by Anonymous-160138 on September 19th, 2016

How To Replace The Pull String

Replace the pull string

Current Answers

Answer #1: Posted by Odin on September 19th, 2016 4:52 PM
This answer was accepted by the poster of the original question.
Odin

Member since:
April 10th, 2010

Points: 41,236,630
1,100
points


Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.

Related Cub Cadet CS 202 Manual Pages

Cultivator Warranty Information - Page 1

...including any product previously manufactured. During the period of America, its option, repair or replace, free of Cub Cadet. To locate your property and/or to others and their property... arising out of any Cub Cadet Product without limitation, expenses incurred for substitute or replacement lawn care services, for transportation or for related expenses, or for loss, damage, or ...
Handheld Blowers Brochure - Page 1

... for a better experience. BC210 BC509 Designed for all-purpose clean-up of heavy brush and grass. Cub Cadet offers a full line of your perfectly manicured lawn. smarter features for trimming and edging.
Handheld Blowers Brochure - Page 2

handheld equipment SPECIFICATIONS Engine Power Start Optional Crankshaft Shaft Attachment Capable Cutting Swath Line Diameter Handle Feed Head Hour Rating Warranty† string trimmers CS202 SS418 ST228 25cc, 2-cycle 29cc, 4-cycle 27cc PRO, 2-cycle No No Yes Half-crank Half-crank Full-crank Curved, Steel Straight, Steel Straight, ...
CS 202 Operator's Manual - Page 1

...for ALL further steps. 5 X 11 Pull rope 5 times. Call 1-877-282-8684 DIDN'T START? Run unit for an additional 60 seconds to the Replacing the Trimming Line section of this time. .... 10 SQUEEZE and HOLD throttle for additional starting instructions. For single line installation or replacement spool installation instructions, refer to complete warm-up . Rotate shield onto shaft. Turn ...
CS 202 Operator's Manual - Page 2

...properly before operating the unit. • Inspect the unit before starting position whenever pulling the starter rope. See Starting and Stopping instructions. • Use the right... unit immediately. • Use only 0.095 inch (2.41 mm) diameter original equipment manufacturer replacement line. The use this unit. Clean after handling. See the Cleaning and Storage instructions. ...
CS 202 Operator's Manual - Page 3

... after adjusting the D-handle. Place the fuel container spout into the hole underneath the cutting head shield (Fig. 2). While firmly holding the upper shaft housing, pull the attachment straight out of ignition for the D-handle to move the D-handle to the instructions on the 2-cycle oil bottle. Primary Hole Upper Shaft...
CS 202 Operator's Manual - Page 4

...the choke lever to Position 2 (Fig. 8) and continue the warm-up for ALL further steps. 7. Pull the starter rope with a controlled and Grip steady motion 3 to 5 times to start , begin the...bottom of the emission control devices and system may stall the engine. NOTE: Maintenance, replacement, or repair of the inner reel. FREQUENCY Every 10 hours Every 25 hours MAINTENANCE ...
CS 202 Operator's Manual - Page 5

... of the cutting head THE CUTTING LINE ADVANCES UNCONTROLLABLY There is cracked, fouled or dirty, replace it from the cylinder. MAINTENANCE ADJUSTING THE IDLE SPEED NOTE: Careless adjustments can damage plastic...lever to Position 3, squeeze the throttle control and pull the starter rope Drain the fuel tank and add fresh, properly mixed fuel Replace the spark plug THE ENGINE WILL NOT IDLE The ...

Similar Questions

Replace Pull Cord
how do I replace starter pull cor
(Posted by rpstrong1984 5 years ago)
Trimmer Is Getting Fuel In And Spark. But Sounds Really Rough Trying To Start. W
trimmer pulls good but sounds rough. Getting fuel from the plunger and spark. Still won't start. Die...
(Posted by Quadchamp94 6 years ago)
Shaft On Cs202 Trimmer Gets Hot
the end of shaft gets hot melted the string spool.
(Posted by alshark 9 years ago)
Adding New String To Cub Cadet Cs202
How do you put new string into Cub Cadet CS202
(Posted by bchums 10 years ago)
Ask a New Question
Use the box below to post a new question about this Cub Cadet product .
Points & Prizes
  • You can earn points for nearly everything you do on HelpOwl.com
  • You can trade in those points for gift cards at leading retailers such as Amazon.com and Walmart
  • It's that simple!
See How it Works
Create a Free Account

Cub Cadet Manuals

Find free Cub Cadet CS 202 manuals and user guides available at ManualOwl.com. Try out our unique manual viewer allowing you to interact with manuals from directly within your browser!

Cub Cadet Reviews

View thousands of Cub Cadet user reviews and customer ratings available at ReviewOwl.com.

Contact Information

Complete Cub Cadet customer service contact information including steps to reach representatives, hours of operation, customer support links and more from ContactHelp.com.

Scoreboard Ratings

See detailed Cub Cadet customer service rankings, employee comments and much more from our sister site.

Cub Cadet Recalls

Find comprehensive Cub Cadet recall information updated hourly on RecallOwl.com.