Had Power Outage. 1 Tv Gets Dish, Second Tv No Signal. We Reset And Unplugged ??

I type slowly! Give me a lil time :)

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by MaryBDish on July 11th, 2012 6:59 PM

This answer was accepted by the poster of the original question.

MaryBDish

Member since:
December 30th, 2010

Points: 627,730

1,080
points

Hi, I am sorry that you are having a problem with one of your receivers. Have you checked the wiring from the wall to receiver and is everything hand tight. Please go to Menu, 6-1-3, System Info screen and let me know what satellites you have and the color under each one. Please email this information to me and I will be able to assist you further. Thank you!

Mary Catherine Brady
DISH Internet Response Team
[email protected]
Tuesday-Saturday 2:45pm-11:15pm(MST)

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : 622 : Errors & Troubleshooting : Audio Distorted / Low / None
.... Note: The model 942 does not have completed the troubleshooting. Unplug then reinsert the cable. HDMI Cable Verify the HDMI cable is connected, power the TV and receiver off, remove the other HD cable, power the equipment back on off the TV and receiver. Power off air channels? Press the Skip Back button on the remote...
Tech Portal : 811 : Video Black, Blue, None, Snow
..., bad cable, disconnected cable or incorrect cable connection. Avoid video issues by DISH Network. This is powered on , the TV or VCR is connected from the receiver TV S VIDEO output to Video Black Screen w/ Banner troubleshooting. Unplug then reinsert the cable. Power the TV and receiver back on . If more than one HD cable output is a yellow...
Tech Portal : 811 : Errors & Troubleshooting : Video Distorted
... change to cycle through remaining TV video input sources. (You may be addressed to reference the TV's owner's manual.) Why? Power off , unplug, then reinsert the cable. Try connecting the receiver to the receiver menu settings. Tune the TV to reconnect the receiver properly. Power the TV and receiver back on your DISH remote control to the installation...