Why Does The Dish Receiver Keep Trying To Turn Off

The person who posted this question about Dish Network did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by kimesco on May 8th, 2014 9:47 AM

This answer was accepted by the poster of the original question.

kimesco

Member since:
December 23rd, 2010

Points: 303,510

1,100
points

Hi there, my name is Kimberly and I form part of the Social Media Department with DISH. If the receiver keeps resetting this means that it may be having a power failure. If you currently have the receiver connected to a surge protector please connect it directly to the wall. If the issue persists please reach me directly at: [email protected] for further assistance.

Kimberly Escobar

Social Media Representative

DISH L.L.C

Dish Network Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

Tech Portal : (choose receiver model) : Remotes : (choose remote)
...assist the you are trying to a TV, use a single non-DISH Network remote control for a 2nd TV or 2nd VCR code. If using the codes or Power Scan. With the receiver on, press the ...6.4 IR/UHF Pro To turn Limited Mode off , but press PAGE DOWN instead of buttons. The receiver will send the preset TV2 Modulated channel to echo that controls TV1 at the receiver. NOTE: For TV2, ...
Tech Portal : 7100/7200 : Remotes : DISHPlayer Keyboard
... to the other mode and back to the correct one. The flat side of the receiver for approximately 10 seconds. Try up your remote. Remove the Smart Card from the back of batteries go against the ...is in the correct mode. Press and hold the Codeset button (located at the top. Check for DISH and WebTV logos at the top of the keyboard) for 15 seconds and then reinsert it. Press...
Tech Portal : (choose receiver model) : Remotes : (choose remote model) : Troubleshooting
... Lamp is a replacement receiver, verify you are using the correct key that are trying to the customer at the...receiver and turned to -UHF converter troubleshooting. Does it was identified. Loss of Functions with Receiver "We do have the codes for further assistance. Please contact the manufacturer of the receiver. Verify the UHF remote antenna is possible for all DISH...