Electrolux EIGD55HIW Support Question
Electrolux EIGD55HIW Support Question
Find answers below for this question about Electrolux EIGD55HIW - 27" Gas Dryer.Need a Electrolux EIGD55HIW manual? We have 6 online manuals for this item!
Question posted by gjarecki on November 22nd, 2010
Dryer Will Not Start
Unit is brand new, out of the box today first load of wash is in dryer, Door closed, power on , Disply lights up. When start button is pressed, the dryer powers off
Current Answers
Related Electrolux EIGD55HIW Manual Pages
Complete Owner's Guide (English) - Page 2
...choosing Electrolux, the new premium brand in home appliances. and Canada: 1-877-4ELECTROLUX (1-877-435-3287) For online support and product information visit http://www.electroluxappliances.com
Table of contents
Finding information 2 SAFETY 3-5 Features 6 Operating Instructions 7-18 • Getting Started 7 • Normal Operating Sounds 7 • Operating Your Dryer 8-9 • Cycle...
Complete Owner's Guide (English) - Page 3
...Care Guide, Installation Instructions and on electric dryers (not provided with unit except those manufactured for sale in this warning...death. Save these instructions for future reference.
240 v Electric Dryer
120 v Gas Dryer
10-30R 3-wire
(fused 30 amp)
14-30R 4-wire
.... Power cord with a WARNING or CAUTION based on the risk type as described below:
This symbol alerts you to light any...
Complete Owner's Guide (English) - Page 4
...dryer door to prevent accidental entrapment.
• Failure to comply with gasoline, cleaning solvents, kerosene, waxes, etc. To prevent personal injury, observe all appliances.
• Destroy the carton, plastic bag and other packing materials after each load... could result in the dryer. Do not stack or place laundry or throw rugs against the front or back of the dryer.
• Do not...
Complete Owner's Guide (English) - Page 5
... is moved to a new location, have it will be exposed to INSTALLATION INSTRUCTIONS for the installer's reference. PREVENT INJURY AND DAMAGE TO THE DRYER
• All repairs and servicing must be removed. The third grounding prong must replace the thermal limiter switch after correcting the fault.
• Failure to a gas pipe. Never ground...
Complete Owner's Guide (English) - Page 7
...system. This is supported by electric solenoids. Load the dryer. (See page 9.)
3.
Getting Started
Operating Instructions 7
To operate your new dryer:
A. Select the desired cycle. (See page...closes to control the gas flow. Check and clean the lint screen. (See page 9.)
2. This noise is normal and will only occur when the gas is operating, there may be sounds generated as the dryer...
Complete Owner's Guide (English) - Page 9
... Time Dry cycles will sound at the end of the cycle to remind you to remove lint from the filter.
Close the door and press start to factory settings, press the temperature and dryness buttons at the same time and hold for the cycle selected. A signal will be indicated for 5 seconds.
5. The estimated drying time for...
Complete Owner's Guide (English) - Page 10
The indicator for each load.
With Auto Dry cycles, the load will be dried at the back of the dryer drum sense the moisture level of selecting the correct ...return it has begun, press the cancel button before selecting a new cycle. Room temperature and humidity, type of load and fabric type. Drying time varies depending on items to the cycle desired. If the load is too small or ...
Complete Owner's Guide (English) - Page 15
... you to remove those items, close the door and press the start again. The wrinkle release option can remove the load.
To add options, press the corresponding options buttons to increase the amount of the cycle.
NOTE
To change the options once the cycle has begun, press the pause button, make the new selections and press start button to any Auto Dry cycle...
Complete Owner's Guide (English) - Page 17
... selected. REVERSIBLE DOOR
Your dryer is displayed during the cycle.
Press tabs down the metal support on top of the rack, leaving space between cycles, press and hold the control lock button for items containing plastic, foam rubber, rubber-like materials, feathers or down. moisture sensing bars Closing the door turns off if the door is opened to...
Complete Owner's Guide (English) - Page 18
...for electric dryers. 18 Operating Instructions
Dryer Settings Chart
These Temperature, Dryness levels and Options are available with the following cycles:
bulky/ heavy mixed towels normal casual fast delicate touch time
bedding duty
load
dry
up...61692;
* Factory presets Available selections **Estimated cycle duration is based on gas models.
Complete Owner's Guide (English) - Page 19
...
• Before moving the dryer, place a strip of the door opening. WARNING
FIRE HAZARD
A clothes dryer produces combustible lint. IMPORTANT
Clean lint screen after every load.
Rinse several times with clear... and those listed below.
• Before cleaning the dryer interior, unplug the electrical power cord to the floor. The dryer must be connected to persons or property, comply with...
Complete Owner's Guide (English) - Page 21
...dryer is on a 240 volt circuit.
To return to the factory default settings, press and hold the temperature and dryness buttons...or circuit breaker tripped.
OCCURRENCE
Dryer does not start. POSSIBLE CAUSE
SOLUTION
Electrical power cord is empty or there ...Dryer does not have no more than drying on a separate circuit.
Dryer has been programmed to support the burner flame (gas...
Installation Instructions (All Languages) - Page 3
... and save this guide ‰ Test hinge and latch for function
Electrical Power
‰ House power turned on ‰ Dryer plugged in
Final Checks
‰ Installation Instructions and Use and Care Guide read thoroughly
‰ Door latches and drum tumbles when cycle starts
‰ Registration card sent in
Pre-installation requirements
Tools and materials needed...
Installation Instructions (All Languages) - Page 5
...dryer stops, the dampers automatically close to prevent drafts and the entrance of 12 inches (30.5 cm) clearance between the vent hood and the ground or any pressure testing of the gas... to collapse, be 1/2 inch (1.27 cm) pipe.
3. Installation Requirements 5
Gas supply requirements
WARNING
EXPLOSION HAZARD
Uncoated copper tubing will obstruct clothes dryer airflow and increase the ...
Installation Instructions (All Languages) - Page 6
...dryer. The dryer... ft. (30.48m)
2
105 ft. (32.00m)
90 ft. (27.43m)
3
95 ft. (28.96m)
80 ft. (24.38m)
...well as increasing drying times.
If the dryer is not exhausted outdoors, some fi... metal foil tape. The dryer must be connected to come...turn 90° dryer vent elbow directly ... the surrounding area. Dryer vent elbows are available...clothes dryer must be exhausted outdoors.
...
Installation Instructions (All Languages) - Page 7
...When installing a gas dryer into a mobile home, a provision must be used , the more the dryer is unacceptable. Connect an inclined or digital manometer between the dryer and the point ...dryer is less than 1.0 inch of water column. Refer to down ) and start the dryer.
3. Installation Requirements 7
Exhaust system requirements, continued
WARNING
EXPLOSION HAZARD
Do not install the dryer ...
Installation Instructions (All Languages) - Page 9
... . (2 cm) to installation depth. Installation Requirements 9
Installed dryer dimensions
50.6" (128.5cm)* to clear open door
31.50" (80cm)* to front of closed door
27.00" (68.5cm)
38.00" (96.5cm)
53.00" (134.5cm)
freestand dryer on floor
floor line
gas supply pipe on rear of gas unit
1.4" (3.5cm)
dryer mounted on optional pedestal
16.25" (41.5cm...
Installation Instructions (All Languages) - Page 14
... rear of Dryer
All connections must be equipped with a manometer.
conversion kit must be in the gas supply line to allow gas to move through the pipe. Use a 1/2 inch to 3/8 inch (1.27 cm to 0.96 cm) reducer for gas to flow through the gas line. Manual Shutoff Flare Valve Union
GAS FLOW
Flare Union
Closed Nipple
Open...
Installation Instructions (All Languages) - Page 18
... Cycle. Empty dryer's drum and close door.
13 4
2. If it prompts an action such as boxes, clothing, etc.) obstructs the flow of cycle completion. At cycle completion, the LCD user interface may display INSTAL PASS!, meaning your dryer in the dryer the first time: wake up from lower right position (1), press the start button. NOTE
On gas dryers, before...
Product Specifications Sheet (English) - Page 1
....)
140 Lbs.
*Side-by-Side units in one load with LCD Display
Yes
Gentle Tumble™ Dry System
Yes
Luxury-Quiet™ Sound System
Yes
Luxury-Design® Lighting
Yes
Luxury-Dry™ System
Yes
Touch-2-Open™/ (Close) Door
Yes
Exact Dry™ Moisture Sensor
Yes
Stainless Steel Dryer Drum
Yes
Tumble Speed (RPM)
50...
Similar Questions
How Do I Get The 'key Stuck' Button To Stop. I Get This On A Number Of Differen
The "key stuck" warning is popping up with 3 different cycle options. how do you get this to stop?
The "key stuck" warning is popping up with 3 different cycle options. how do you get this to stop?
(Posted by barclayn6 2 years ago)
Electrolux Dryer Ewed65hss
my dryer with model number EWED65HSS is throwing a E64 code. What does it mean, can I fix it myself ...
my dryer with model number EWED65HSS is throwing a E64 code. What does it mean, can I fix it myself ...
(Posted by Cindymailers 6 years ago)
Dryer Pausing For No Apparent Reason A Few Seconds After Starting Cycle...
would a defective moisture sensor be causing our electrolux dryer to pause a few seconds into a new ...
would a defective moisture sensor be causing our electrolux dryer to pause a few seconds into a new ...
(Posted by plantz 7 years ago)
Can You Covert From Gas
I was not aware that my sister gave me a gas dryer and my apartment does not have hook-ups. I need t...
I was not aware that my sister gave me a gas dryer and my apartment does not have hook-ups. I need t...
(Posted by teraettinger6 8 years ago)
