Frigidaire FFLG4033QT Support Question
Frigidaire FFLG4033QT Support Question
Find answers below for this question about Frigidaire FFLG4033QT.Need a Frigidaire FFLG4033QT manual? We have 2 online manuals for this item!
Question posted by darrylshaw67 on February 21st, 2017
Syphon Break Kit Manufacturer Dose Not Carry Where Do You Get The Right One
I called manufacturer and they don't carry washer syphon break kit where do I get the correct one to fit the FFLE4033QT?
Current Answers
Answer #1: Posted by Odin on February 21st, 2017 7:34 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,630
Member since:
April 10th, 2010 Points: 41,236,630
Try an online parts source like http://www.ereplacementparts.com/ or https://www.partstore.com/. Or consider the other suggestions at https://www.helpowl.com/q/Weider/PlatinumXp800/Other/replacement-parts-foe-weider-xp-800/1022670.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Frigidaire FFLG4033QT Manual Pages
Use and Care Guide - Page 1
All about the
Use & Care
of your Laundry Center
TABLE OF CONTENTS
Important Safety Instructions 2-5 Washer Operating Instructions 6-12 Dryer Operating Instructions 13-16 Care and Cleaning 17-18 Avoid Service 19-20
Warranty 21 Notes 22 Français 23 Español 45
www.frigidaire.com USA 1-800-944-9044
www.frigidaire.ca Canada 1-800-265-8352
A02591501A (1408)
Use and Care Guide - Page 3
...
DANGER indicates an imminently hazardous situation which , if not avoided, could result in this laundry center.
IMPORTANT SAFETY INSTRUCTIONS
WARNING
Please read all instructions before using this Use & Care ...may not have every feature included.
Record and retain these instructions for your laundry center are not meant to cover every possible condition and situation that follow ...
Use and Care Guide - Page 4
...WARNING -
If the hot water system has not been used near the washer. An excessive amount of this laundry center, comply with the basic warnings listed below. ter. Children might ... the washer is unpacked. Regularly inspect the outdoor exhaust opening and in the laundry cen- The dryer must be installed on electric dryers (not provided with unit except those manufactured for sale...
Use and Care Guide - Page 6
... and/or damage to prevent oversudsing. The amount required depends on the detergent label:
• Follow detergent manufacturer's directions. Load small items first.
Add powdered bleach to the empty tub.
6 Add laundry load to washer.
• Add items one at , laid-out fashion.
• For best washing performance, dry load level should...
Use and Care Guide - Page 16
...are slightly
damp to avoid overdrying. • Check that lint filter is clean and in washer or dryer
to reduce static electricity. • Remove items when they are dry, remove the rack... let items hang over the sides or through the grids. PROBLEM Greasy, oily stains
Lint
Pilling (Fibers break off, ball up and cling to complete drying. • Block knits into the dryer drum. PREVENTIVE...
Use and Care Guide - Page 19
...When in place, the duct must have it corrected by a qualified electrician. Residue ...calling for service, review this laundry center. It may produce a thumping sound.
Dryer does not start . POSSIBLE CAUSE
SOLUTION
Foreign objects such as coins or safety pins may be in the dryer circuit. Belt buckles and metal fasteners are 2 house fuses in drum or pump. Washer is open . Call...
Use and Care Guide - Page 21
... WARRANTY OR ANY IMPLIED WARRANTY. YOU MAY ALSO HAVE OTHER RIGHTS THAT VARY FROM STATE TO STATE. IF YOU NEED SERVICE
...or workmanship, or for service calls to floors, cabinets, walls, etc. 13. Service calls to correct the installation of your best ... BASED ON IMPLIED WARRANTIES, INCLUDING WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO ONE YEAR OR...
Installation Guide - Page 2
...dryer in accordance with washer purchase. Place all occupants.
• Immediately call the fire...• Install the appliance according to the manufacturer's instructions and local codes.
• The... Destroy the carton and plastic bags after the laundry center is not recommended for natural
gas or ...work • 3-wire or 4-wire 240 volt cord kit
(electric dryer) • 4 in Canada, CAN...
Installation Guide - Page 3
...Foam shipping support (underneath appliance) removed and stored
Leveling Laundry Center is level, side-to-side and frontto-back ... Use only new hoses and verify rubber sealing washers are labeled with all screws tight on terminal block &#... connections sealed with approved sealer and wrench tight Conversion kit for LP system Gas supply turned on ...
Installation Guide - Page 4
....
GROUNDING CONNECTION - NOTE
Laundry centers manufactured for sale in Canada.
NEMA 10-30R or NEMA 14-30R receptacle to neutral unless it was manufactured for sale in the installed... 4-wire cord connection instructions see ELECTRICAL CONNECTIONS FOR A 3-WIRE SYSTEM.
4-WIRE POWER SUPPLY CORD KIT (not supplied)
4-wire receptacle (NEMA type 14-30R)
The dryer MUST employ a 4-conductor ...
Installation Guide - Page 6
Correct Incorrect
6 For drain systems in operation. These conditions will obstruct clothes dryer air&#... minute.
2 A standpipe diameter of any other obstruction.
Also, ensure the present duct is in the floor, install a syphon break kit available from an authorized parts distributor. Exhaust system requirements
Use only 4 inch (102 mm) diameter rigid or flexible metal duct...
Installation Guide - Page 8
... direction
The laundry center may be exhausted four (4) ways with rear flush installation:
CORRECT
INCORRECT
In installations where the exhaust system is not described in the charts, the following method must be used .
• Venting vertically through a roof may expose the exhaust system to the side or down and 1 elbow right)
To...
Installation Guide - Page 9
.... INSTALLATION REQUIREMENTS
Manufactured or mobile home installation
1 Installation MUST conform to current Manufactured Home Construction &...other fuel burning appliance shall be installed in this laundry center to the floor with no obstructions.... install your dryer in diameter with approved Mobile Home Installation Kit P/N 137067200. Openings are required to be located 3 inches...
Installation Guide - Page 13
... form a standpipe to an upright position and remove the tape holding the lid shut. With help from a second person, carefully tip the laundry center slightly to the right side of the washer, remove the wire shipping clip securing the drain hose.
6. CAUTION
EXCESSIVE WEIGHT HAZARD To avoid back or other tub contents.
2.
DO...
Installation Guide - Page 14
...
4 Check for gas leaks with an open flame. WARNING
EXPLOSION HAZARD NEVER test for gas system leaks with an approved manual shutoff valve.
conversion kit must be installed by brushing on the back of the dryer. IMPORTANT
DO NOT connect the dryer to the gas shutoff valve.
14 INSTALLATION INSTRUCTIONS...
Installation Guide - Page 15
...the dryer. 3 Install a UL-approved strain relief according to the
power cord/strain relief manufacturer's instructions in the power cord entry hole below the access panel. IMPORTANT
If moving dryer ...SHOCK HAZARD Do not make a sharp bend or crimp wiring/conductor at connections.
7 Follow manufacturer's guidelines for firmly securing the strain relief and power cord.
8 Reinstall the terminal ...
Installation Guide - Page 16
...block.
6 Attach the ground (GREEN) power cord wire to the power cord/strain relief manufacturer's instructions in the power cord entry hole below the access panel. WARNING
ELECTRICAL SHOCK HAZARD ...Do not make a sharp bend or crimp wiring/conductor at connections.
9 Follow manufacturer's guidelines for 4-wire system
BLACK or RED power wire
Neutral terminal
WHITE neutral wire
BLACK...
Installation Guide - Page 17
... pliers. Do not bend, kink or pinch water inlet hoses.
4 Turn on the washer. RUBBER WASHERS MUST BE PRESENT
USE ONLY NEW HOSES
NOTE
Hoses are not included with pliers. See "Accessories" section for various inlet hose kits to fit your laundry center
Excessive noise and vibration can be prevented by properly leveling the...
Installation Guide - Page 18
... to seal all other joints.
3 Reinstall the dryer front access panel. 4 Carefully slide the laundry center to the outside exhaust system. Recheck for level and rock corners for stability.
INSTALLATION INSTRUCTIONS
...screws (items A, to the right) securing the dryer front access panel to the exhaust vent system. Use of a 4" (10.2 cm) clamp (item B, to the right) is recommended to connect ...
Installation Guide - Page 20
...kit prior to explore hose kit options that will meet your laundry center. INLET HOSE KITS Please call 866-233-8353 (in dryer/washer feet adjustment. CAUTION
Failure to use of your laundry...installation needs.
MOBILE HOME INSTALLATION KIT P/N 137067200
Installation in a mobile home requires the use accessories manufactured by (or approved by) the manufacturer could result in personal injury...
Similar Questions
Leaking From Bottom Rightside
leaking FFTW1001PW toploader wash cant afford repair man how or where do i open from front or back
leaking FFTW1001PW toploader wash cant afford repair man how or where do i open from front or back
(Posted by quiggme 1 year ago)
Bearings And Seal Kit
looking for a washer tube bearings and seal kit for model fffw5000qw.
looking for a washer tube bearings and seal kit for model fffw5000qw.
(Posted by latchford86jl 3 years ago)
Syphon Break Kit
I need a syphon break kit for my fridgidaire ffle4033qt laundry center
I need a syphon break kit for my fridgidaire ffle4033qt laundry center
(Posted by darrylshaw67 7 years ago)
Washer Frigidaire Fex831fs Wont Work On Spin Cycle
(Posted by Lashbhogi 10 years ago)
Need Kit That Stabilizes Tub
need to purchase kit that stabilizes tub during moving
need to purchase kit that stabilizes tub during moving
(Posted by caryklausner 11 years ago)