Frigidaire FFLG4033QT Support Question
Frigidaire FFLG4033QT Support Question
Find answers below for this question about Frigidaire FFLG4033QT.Need a Frigidaire FFLG4033QT manual? We have 2 online manuals for this item!
Question posted by genosola on June 18th, 2017
Washer Will Not Cycle
washer will not cycle if I turn the dial at any position and push the start it beeps but no clicks or anything I changed the lid latch switch thinking that could be the issue but it was not the problem I tried doing a master reset or go through the diagnostic process but it would not respond.. any ideas of what this could be or which board could be the issue thank you for your time
Current Answers
Related Frigidaire FFLG4033QT Manual Pages
Use and Care Guide - Page 1
All about the
Use & Care
of your Laundry Center
TABLE OF CONTENTS
Important Safety Instructions 2-5 Washer Operating Instructions 6-12 Dryer Operating Instructions 13-16 Care and Cleaning 17-18 Avoid Service 19-20
Warranty 21 Notes 22 Français 23 Español 45
www.frigidaire.com USA 1-800-944-9044
www.frigidaire.ca Canada 1-800-265-8352
A02591501A (1408)
Use and Care Guide - Page 4
...ficient drying and possible fire.
Some rubber materials, when heated, can become airtight chambers. • Keep laundry products out of fire, electrical shock, or injury to persons when using the washer, turn on or near children. Regularly inspect the outdoor exhaust opening and remove any time.
• Do not use...
Use and Care Guide - Page 5
... removed.
The washer motor will be plugged into the laundry center while parts are packed in below freezing temperatures.
• Do not install on the laundry center. Included in the cycle selector knob to a gas pipe. If the laundry center is moved to a new location, have it becomes overheated.
• A thermal limiter switch automatically turns off at...
Use and Care Guide - Page 6
...tears to prevent further damage during washing.
• Turn knit items inside out to prevent pilling. •...powdered bleach to the empty tub.
6 Add laundry load to washer.
• Add items one at , laid-...the lid:
• Refer to balance the load.
6 Do not overload the washer.
...be washed together.
• Sort items by recommended cycle and water temperature.
• Separate white, light...
Use and Care Guide - Page 7
... fill above . You
may have to perform a drain cycle to remove water left in unwarranted repair costs.
9 Start the washer.
• Close the washer lid.
Do not force open .
• Push in automatic dryer, line dry, or dry flat the cycle end after the cycle has ended. WASHER OPERATING INSTRUCTIONS
Washing Procedures, continued
7 If desired, add liquid...
Use and Care Guide - Page 8
... for a normal wash cycle. To change the cycle after the soak phase. Make the new selection and push in or turn the cycle selector knob to start the new cycle. Hot water is recommended to fabric care label for heavily soiled, durable garments - delicates Use this cycle for use of detergent recommended for reference only. NOTE
Washers connected to be...
Use and Care Guide - Page 9
... range of the cycle use with cold tap supply to achieve cold.
For best results
Follow the fabric care label instructions on items to be sure the fabric softener switch is selected. cool... hot Use this setting for dispenser cleaning procedures. WASHER OPERATING INSTRUCTIONS
Washing Cycle Settings
Wash Water Temperature
Turn the temp knob until the desired wash water temperature is...
Use and Care Guide - Page 12
... directly on collars and cuffs.
• Turn items inside out to reduce abrasion.
• Increase water temperature using casual cycle.
• Increase detergent. • Add...broken threads. • Overloading the washer. • Degradation of lint and scum, and fabric damage. WASHER OPERATING INSTRUCTIONS
Common Washing Problems
Many washing problems involve poor soil and stain removal, ...
Use and Care Guide - Page 14
...this cycle to be dried at the selected temperature to continue the cycle and the cycle may differ.
To change the cycle ...push in either direction to dry everyday fabrics including cottons, linens and sheets.
heavy duty Select this cycle to the cycle desired. Drying Cycle Selection
Turn the cycle selector in or turn the cycle selector knob to start the new cycle. Auto Dry cycles...
Use and Care Guide - Page 16
...Turn items inside out to reduce
abrasion.
• Follow fabric care label directions. • If shrinking is not in dryer after
cycle...;lter is clean and in washer or dryer
to be tumble ... the drying rack.
4. Common Drying Problems
Many drying problems involve poor cleaning results, poor soil ...Place fabric softener sheet on top of
load before starting the dryer.
• Do not overload dryer...
Use and Care Guide - Page 17
...Safety Instructions and those listed below.
• Before cleaning the laundry center interior, unplug the electrical power cord to future loads. ...hear a slight click.
17 NOTE
Fabric softener may develop in items left in the washer. • Dry the washer top, the area...washer as soon as the cycle
ends. Dry the filter thoroughly and replace. An excessive amount of lint around the lid...
Use and Care Guide - Page 18
Start the cycle
and let the washer drain for cold weather storage and care.
18 Rinse several times ...of cardboard or thin fiberboard under the front leveling legs to prevent damage to the washer:
1 Turn off tub interior and close the lid. 7 Store laundry center in an upright position. 8 To remove antifreeze from hoses. 3 Plug electrical cord into a properly grounded
electrical ...
Use and Care Guide - Page 19
... problem is open.
The washer will not operate when the lid ...starting each cycle. Call authorized service person for details. Check to support the burner flame (gas models).
See INSTALLATION INSTRUCTIONS.
Use a dehumidifier near the dryer.
19 Thumping sound. Vibrating noise. Belt buckles and metal fasteners are not turned on water supply faucets. Washer lid...
Use and Care Guide - Page 20
.... The drain and spin cycles Lid lock malfunction.
The washer will not operate when the lid is kinked or clogged.
...as belt buckles, zippers Turn items inside of balance. Drying temperature too high.
Washer is kinked.
Drain hose... wrinkling. If problem persists, your hot water system may not be unable to cold water faucet. wash cycle is being used...
Installation Guide - Page 2
...after the laundry center is not recommended for future reference. WHAT TO DO IF YOU SMELL GAS: • Do not try to fi..., etc.
• Do not install a clothes dryer with washer purchase.
Good safe practice and caution MUST be easily crushed and...be applied when installing, operating and maintaining any electrical switch; See "Accessories" section for play. Cartons covered with...
Installation Guide - Page 3
...61472;House power turned on Laundry Center plugged in
Final Checks Installation Instructions and Use and Care Guide read thoroughly Water enters drum when cycle starts with lid lowered.
Recognize... on all corners
Water Supply Use only new hoses and verify rubber sealing washers are labeled with all screws tight on the risk type as described below:
Defi...
Installation Guide - Page 5
.... Your water department can advise you of your washer's water inlet. INSTALLATION REQUIREMENTS
Electrical requirements for Laundry Center with the National Fuel Gas Code, ANSI Z223....1 (latest edition).
2 The gas supply line should be 1/2 inch (1.27 cm) pipe.
3 If codes allow, flexible metal tubing may not complete cycles...
Installation Guide - Page 10
...slope of combustion and ventilation air. 3 On carpet. Failure to dripping water or outside weather conditions. Laundry Center Dimensions
47.5" (120.5 cm)
gas supply pipe on rear of gas unit
17.6" (45 ... of unit
55.75" (141.5 cm)
45" (114 cm)
water supply connection on rear of washer
drain hose retention clamp on gas unit approximately 60 inches (152.5 cm). 2Loose drain hose length beyond ...
Installation Guide - Page 13
...laundry center is to be transported at a later date, the tub blocking pad, foam base and tub support should be completed.
1. It helps form a standpipe to an upright position and remove the tape holding the lid... RIGHT side
ONLY!
2
7. Save these items for the start of the remaining cardboard. UNPACKING LAUNDRY CENTER
Unpacking Instructions
IMPORTANT
To prevent vibration, possible machine damage...
Installation Guide - Page 19
... of the drain hose with 3-prong grounded plug
3 Turn on the end of the water. There must be ... hose in the standpipe. IMPORTANT
Check to the standpipe, inlet hose, laundry tub, etc. A snug hose fit can cause a siphoning action... operation. 6 If you time and money. 5 Run the washer through a complete cycle, checking for service. 7 Place these instructions in the enclosure package...
Similar Questions
Syphon Break Kit Manufacturer Dose Not Carry Where Do You Get The Right One
I called manufacturer and they don't carry washer syphon break kit where do I get the correct one to...
I called manufacturer and they don't carry washer syphon break kit where do I get the correct one to...
(Posted by darrylshaw67 7 years ago)
My Washer Shuts O Off Wen I Push Start
(Posted by tcrocker117 9 years ago)
Washer Fills With Water And Timer Starts But Nothing Else Happens
(Posted by Lptaa5 10 years ago)
My Washer And Dryer Stackable , Washer Quit Turning
MY WASHER LOCK UP WHILE IT WAS RUNNING, BELTS SMELL LIKE THEY WERE BURNING UP . MODEL NO. GLET1031CS...
MY WASHER LOCK UP WHILE IT WAS RUNNING, BELTS SMELL LIKE THEY WERE BURNING UP . MODEL NO. GLET1031CS...
(Posted by Tips 11 years ago)
Using New Washer For First Time.model # Atf8000fe1
Set the required settings and pushed START. There is a flashing "Pause" that continues to flash and ...
Set the required settings and pushed START. There is a flashing "Pause" that continues to flash and ...
(Posted by jbishoph 12 years ago)