Frigidaire GLEQ2152ES Support Question
Frigidaire GLEQ2152ES Support Question
Find answers below for this question about Frigidaire GLEQ2152ES - Electric Dryer.Need a Frigidaire GLEQ2152ES manual? We have 4 online manuals for this item!
Question posted by robertbrianperkins on November 16th, 2011
What The Hell???
Why can't I find a diagram so I can replace the dryer belt myself?!?!?
Tried so many sites and CAN NOT find an answer
Current Answers
Answer #1: Posted by techie12330 on November 16th, 2011 6:18 PM
techie12330
Member since:
November 8th, 2011 Points: 286,200
Member since:
November 8th, 2011 Points: 286,200
Try youtube how to videos:
Related Frigidaire GLEQ2152ES Manual Pages
Use and Care Manual - Page 2
...you don't follow instructions. WHAT TO DO IF YOU SMELL GAS:
• Do not try to prevent property damage, personal injury or loss of all occupants. • Immediately call...be performed by inappropriate waste handling of electrical and electronic equipment. By ensuring this Use & Care Guide and the Operating Instructions included with your dryer. Your dryer may not be caused by a ...
Use and Care Manual - Page 3
...dryer.
Cartons covered with these warnings could result in your dryer has a drying rack, always replace the lint screen when finished using this way ONLY
Important Safety Instructions Con't
Avoid fire hazard or electrical... Guide are not meant to fabrics can become airtight chambers. • Keep laundry products out of lint build-up in these warnings could result in this way...
Use and Care Manual - Page 4
..., read and follow fabric care labels and laundry product labels. Important Safety Instructions Con't
Prevent Injury • To prevent shock hazard and assure stability during operation, the dryer must be installed and electrically grounded by an authorized servicer unless specifically recommended in this dryer.
1. Wait until the dryer has stopped completely before operating this Owner...
Use and Care Manual - Page 5
... inefficient drying and possible fire hazard. 5 Dry thoroughly and replace. Care and Cleaning
Clean lint screen after every load. Do not tumble other items when using dryer-added fabric softener sheets. Hazardous fumes or electrical shock could result in warm, soapy water. The dryer must be dried on changing the door. Do not operate...
Use and Care Manual - Page 6
... with diluted chlorine bleach [1/2 cup (120 ml) in washer or dryer to
electricity.
• Or, add a fabric softener sheet and
reduce static electricity.
• Lint screen not clean
tumble without heat.
• ... Lint is attached to reduce abrasion.
Care and Cleaning con't
Do not store or place laundry products on top of lint and scum, and fabric damage. Outside
• Clean the ...
Use and Care Manual - Page 7
... from pockets before starting each cycle. POSSIBLE CAUSE
Electrical power cord is not securely plugged in wall outlet. Reset circuit breaker or replace fuse.
Replace fuse. Make sure all lint has been removed from drum and restart dryer. Items left in the dryer circuit.
OCCURRENCE
Dryer does not start. Dryer does not have not been followed. See...
Technical Data Sheet - Page 1
... become corrupted. Position cycle selector to NORMAL, temperature selector to NO terminal on gas models, replace electronic control. If problem persists, replace electronic control. Remove wires from dryer. Remove wires from control thermistor. If meter reads 240V on electric models and 120V on the relay RL2.
Measure resistance of time. Measure resistance of each...
Technical Data Sheet - Page 2
... lit and "AF" (Air Fluff) is rotated, there should light. 5 O'clock: Drive motor runs; c. Dryer will be used to 12 O'clock position. 2. In controls that do not have a digit display, the dryness ...Press and hold Pause Cancel and START buttons simultaneously for six seconds or disconnect power from dryer. heat source is pressed, all LED'S will make the Damp LED come on the both...
Installation Instructions - Page 2
.... maximum time delay fuse or circuit breaker. The dryer is in the installed position. do not use with a 120 volt 3-wire power cord.
See ELECTRICAL CONNECTIONS for Installation: 1.
Flat or straight blade screwdriver... SMELL GAS · Do not try to be located so the power supply cord is accessible when the dryer is equipped with clothes dryers. POWER SUPPLY CORD KIT -
PRE...
Installation Instructions - Page 3
...18 inches (45.7 cm) above the floor. Use an approved vent hood to exhaust the dryer. Set the dryer timer and temperature to do so can result in death, explosion, fire or burns. If the...flow.
Do not screen the exhaust ends of plastic duct or metal foil duct, replace it must be exhausted into the laundry area. Excessive lint can build up of the vent system, nor use plastic flexible ...
Installation Instructions - Page 4
...In an area exposed to be unobstructed when a door is installed. However, on electric dryers, exhausting can be to the right or left side of the cabinet or the bottom... connection to the dryer.
6. EXHAUST DUCT LOCATING DIMENSIONS
SAME AS OTHER SIDE
3 3/4" (9.5 cm)
5 7/8" (15 cm)
13 1/2" (34 cm)
4 3/8" (11 cm) 3 3/4" (9.5 cm()9.5 cm)
GAS SUPPLY REQUIREMENTS
Replace copper connecting pipe ...
Installation Instructions - Page 5
... models - 0 inches (0 cm) for proper operation in a recess or closet installation.
0" (0 cm)
0" (0 cm)
1" (2.54 cm)
0" (0 cm)
60 sq. inches (387.1 sq.
cm)
60 sq.
This dryer MUST be exhausted outdoors.
5. MINIMUM INSTALLATION CLEARANCES -
Installation Instructions - Page 6
... (70.49cm) 28.5 to clear door handle (72.39cm)
2.375" (6.03cm)
(34.29cm) 13.5" To rear & base exhausts
27.0"
(68.58cm)
Stacked Dryer Installation Dimensions
(68.58cm) 27.0"
Electrical supply on rear of unit
28.25" to front of cabinet(71.76cm)
28.75" to clear knobs (73.03cm) 29.5" to clear...
Installation Instructions - Page 7
...the exhaust system MUST terminate outside the enclosure with American National Standard for Mobile Homes. Return the dryer to scratch the paint.
2.
"Solid door " Reversal Instructions:
1. Hold the door firmly before... using metal ducting that secure the door hinges to the floor. FOAM SHIPPING PAD
The dryer is accomplished by transferring hinges to be 4 inches (10.16 cm) in the open ...
Installation Instructions - Page 8
...
You may need a plastic knife to help remove the plugs. Window Door Reversal Instructions
1. Open the dryer door. Remove the four hinge hole plugs from the left side of the door opening . NOTE: You ...may need a plastic knife to help remove the plugs. Be careful to the dryer front panel. Remove the four screws that secure the door hinges to avoid scratching the paint.
2....
Installation Instructions - Page 9
... strain relief must be run with this dryer.
ELECTRICAL INSTALLATION
ELECTRIC Dryer
The following are specific requirements for the proper power cord to be purchased. If in this dryer utilizes and can be pulled out of the dryer and can melt, creating electrical shock and/or fire hazard. For a permanently connected dryer: 1. Refer to withstand the amounts of...
Installation Instructions - Page 10
... WIRE
RED
BLACK TIGHTEN
NUT
WHITE
TO THESE THREADS
NUT
STRAIN RELIEF MOUNTING BRACKET
STRAIN RELIEF MOUNTING B R A C K E T POWER CORD
POWER CORD
ELECTRICAL CONNECTIONS FOR 4-WIRE SYSTEM
ELECTRIC Dryer
ELECTRICAL CONNECTIONS FOR 3-WIRE SYSTEM
ELECTRIC Dryer
1.
power cord, NEMA 10-30 type SRDT, through the strain relief.
5. Attach the green power cord ground wire to the back...
Installation Instructions - Page 11
...: A wiring diagram is off . Label all four legs.
3. Verify proper operation after the dryer is resistant to the corrosive action of the legs until the dryer is necessary for...breaker/fuse box.
5. The dryer MUST be applied when installing, operating and maintaining any appliance.
If this dryer are needed for future reference. REPLACEMENT PARTS
If replacements parts are not meant to be...
Operating Instructions - Page 1
..., press OPTIONS until the desired selection is made up of just a few items. It provides approximately 20 minutes of load, weight and fabric type.
The dryer senses the moisture level of ventillation system, electrical voltage or gas pressure can also affect drying time.
It explains these operating steps in place.
3.
See the...
Operating Instructions - Page 2
... adjustments will automatically be displayed for any Auto Dry cycle will not light. See the "Dryer Settings Chart" for most loads. Medium heat is recommended for more details. Low heat is...recommended for wrinkle free, permanent press and lightweight fabrics. Dryer Features
Control To avoid having someone accidentally start or stop the dryer, press OPTIONS and SELECT at the end of the...
Similar Questions
Electric Dryer Conversion To Gas?
Can my dryer be converted to gas ?
Can my dryer be converted to gas ?
(Posted by Anonymous-155161 8 years ago)
Give Me A Diagran Of Where Is The Fuse Locatedin A Frigidaire Electric Dryer
(Posted by 101robi 9 years ago)
How To Replace Belt For Gleq2152es0 Frigidaire Electric Dryer
(Posted by HBChodian 10 years ago)
Frigidaire Electric Dryer Fer641fs. No Heat. Timer Not Advancing.
My electric dryer has no heat and the timer is not advancing like it suppose to. It just keeps spinn...
My electric dryer has no heat and the timer is not advancing like it suppose to. It just keeps spinn...
(Posted by mouatech 10 years ago)
Frigidaire Gleq2152es Electric Dryer Runs A While, Heats On Then Stops After 10m
(Posted by thespen691 13 years ago)