GE GFC720F Support Question
GE GFC720F Support Question
Find answers below for this question about GE GFC720F - 3/4 HP Continuous Feed Disposer.Need a GE GFC720F manual? We have 1 online manual for this item!
Question posted by freddymantis on November 18th, 2011
Shock Protection
Is the GE disposal unit double insulated? Is it UL listed?
Current Answers
Related GE GFC720F Manual Pages
Use and Care Manual - Page 1
... 2
Installation Instructions
Attaching the Discharge Elbow 6 Components and Installation of Sink Flange 5 Connecting Disposer to Sink Flange 7 Dimensions/Typical Installations 8 Dishwasher Connection 6
Operating Instructions
Batch Feed Models 9 Care and Maintenance 10 Continuous Feed Models 9
Troubleshooting Tips
Before You Call for Service . . . . . .11
Consumer Support
Warranty 12...
Use and Care Manual - Page 2
... the continuous feed
model connects to whether the appliance is controlled by a waste disposer, do not put fingers or hands into an appropriate outlet that may be expelled by the wall switch, while the
other hot liquids.
c) Glass, china or plastic. g) Whole corn husks. INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK OR INJURY...
Use and Care Manual - Page 3
...Disposer (end bell)
B. B. Ribbed Side
NOTE: When viewing face of electric shock. Connect bare ground wire. If plastic pipe is used.
GE...disposer does not come equipped with grounding pin at top, the larger left blade is properly grounded. The batch-feed or "TC" model connects to the hot side, while the continuous feed...BX cable: 1. Use only UL approved ground clamp. A.
NOTE:...
Use and Care Manual - Page 4
...heavily coated with hardened
grease and accumulations, rout out with the Consumer.
• Note to disposer. 2.
WHAT YOU WILL NEED
• Phillips and flat blade screwdrivers
• Channel lock ...'s putty (for future reference. • Skill level - Installation Instructions
Disposer
If you have questions, call 800.GE.CARES (800.432.2737) or Visit our Website at: GEAppliances.com
...
Use and Care Manual - Page 5
... stainless steel sinks.
Do not press too hard. Unscrew the support ring from the disposer by the factory. E. If no leaks.
At
Hand-tighten sink flange
this point ...Groove Hopper
Dishwasher Discharge Inlet
Elbow Gasket
Disposer
End Bell (Electrical Connections)
Elbow Flange
Rating Label in This Area
*Not used with batch feed model
Screws
Discharge Elbow
INSTALLATION OF SINK ...
Use and Care Manual - Page 6
... Rubber Adapter
3 ATTACHING THE DISCHARGE ELBOW
CONNECT DISCHARGE ELBOW
Connect the discharge elbow to the disposer.* Make sure all plumbing connections are connecting to grind, over the course of a flexible ...drain pipe. If the hose size is different, you will not damage the disposer in any way, but may
take some time to a dishwasher, complete the following step.
This...
Use and Care Manual - Page 7
...Hopper Projection
3 LOCK MOUNT RING
Turn the mount ring slowly to the right so that the disposer is hard to the hopper projection. Locking Detail
Hopper Projection in "Supported" Position
Discharge Elbow... Ring
4 CHECK FOR LEAKS
Check the unit for leaks.
2 LINE UP WITH OUTLET PIPE
Turn the mount ring and the disposer until it locks up the disposer under the sink flange. Turn the mount...
Use and Care Manual - Page 8
....
DOUBLE BOWL END OUTLET**
*Approx.
8
NOTE: It is essential for the proper operation of the disposer that.../2"
GFC720 Model Series
8 1/2"
93/8"
165/8"
5 9/16"
4 1/2" 11/2"
GFB760 Model Series Batch Feed Operation
8 1/2"
7 1/4"
161/16"
5 9/16"
4 1/2" 11/2"
GFC1020 Model Series
SOME TYPICAL ... listed above, to avoid standing water in disposer motor housing.
**Flexible drain pipe ...
Use and Care Manual - Page 9
... down the drain.
When the medium-sized slot in food waste. Continuous Feed Models
A. C. To speed up food waste disposal, cut or break up with other trash. This assures that the disposer slows down to shut the disposer off , let the water and the disposer run for 25 seconds after shredding stops. Lift the stopper to...
Use and Care Manual - Page 10
...pulling it is equipped with a little household scouring powder will also work.
10
The disposer is ruggedly built to give you may want to leave the stopper in the drain ...guard for the Batch Feed model, is properly seated. B. Care and maintenance.
C. I If an odor develops, run orange or lemon rinds through the disposer. DO NOT ATTEMPT TO LUBRICATE YOUR DISPOSER.
You may prefer...
Use and Care Manual - Page 11
...unit may not need to the disposer. If no foreign object is present, there may be internal problems.
Remove Splash Guard
Turntable
Disposer...other than those during grinding of elbow flange screws.
*Batch Feed does not include splash guard.
11 Push the button in ...Dislodge the object by :
1. This feature protects your house wiring and your disposer. Check the electrical power switch, fuse box ...
Use and Care Manual - Page 12
... limited warranty period, you will be responsible for service. During this one year or the shortest period allowed by a GE Authorized Servicer is located in materials or workmanship relating to the replacement disposer. I Replacement of house fuses or resetting of the original purchase date is a defect in an area where service by...
Similar Questions
Ge Gfc325f Disposal
My disposal was jammed, I unjammed it using a butter knife around the edges to remove the broken gla...
My disposal was jammed, I unjammed it using a butter knife around the edges to remove the broken gla...
(Posted by lemleyr70 5 years ago)
Disposal Makes Hum Noise
Hello. My GE GFC325 garbage disposal is making a humming sound when I turn the disposal on. How do I...
Hello. My GE GFC325 garbage disposal is making a humming sound when I turn the disposal on. How do I...
(Posted by lizzybizzy50 7 years ago)
Reset Botton On G E Gfc720f Garbage Disposal
(Posted by Anonymous-60916 12 years ago)
