Wire Replacement

• Unplug the iron and wait for it to cool down completely before proceeding.
• Locate the screws that secure the iron's casing. These screws are usually found underneath the iron, so turn it over and look for them.
• Use a screwdriver to remove the screws and take off the casing. Be careful not to damage any wires or parts inside the iron.
• Locate the power cord and disconnect it from the iron's internal components. This can usually be done by pulling the cord out of the connector.
• Take note of how the cord is threaded through the iron's body. This will be important when installing the new cord.
• Purchase a replacement power cord that is compatible with your Hamilton Beach steam iron model 14506.
• Thread the new power cord through the iron's body following the same path as the old cord.
• Reconnect the new cord to the iron's internal components.
• Replace the casing and secure it with the screws you removed earlier.
• Test the iron to make sure it is working properly before use.

Locate the screws that hold the appliance's casing in place. Depending on the specific model, these screws may be located on the back or bottom of the appliance. Use a screwdriver to remove the screws.

https://youtu.be/di89jxQlCLY

1. Unplug the iron from the electrical outlet and let it cool down completely.
2. Remove any water from the iron's water tank to avoid spillage.
3. Locate the screws on the bottom of the iron and use a screwdriver to remove them.
4. Carefully separate the bottom plate from the iron and set it aside.
5. Locate the power cord inside the iron and trace it to the point where it connects to the iron's internal wiring. It should be attached with a pair of wire nuts.
6. Use a pair of pliers to twist the wire nuts counterclockwise to loosen them, and then remove the nuts to detach the old power cord.
7. Take the new power cord and strip about 1/2 inch of insulation from the ends of its wires.
8. Twist the bare ends of the new power cord wires together with the wires inside the iron, and then screw on new wire nuts clockwise to secure the connection.
9. Carefully reassemble the iron's bottom plate and screw it back into place.
10. Test the iron to make sure it's working properly and that the new power cord is securely attached.

If you're not comfortable working with electrical wiring or if you're unsure about any of these steps, it's best to seek the assistance of a professional technician or repair service.